What happens when the air conditioner jumps? As soon as the air conditioner is turned on, the power

1.Check the air conditioner fuse, adjust and repair the fuse in time. 2.

It is recommended that households with air conditioners set up a dedicated power supply to prevent air conditioner tripping. 3.If the local supply voltage is frequently low, a reliable power regulator should be used.

Check your refrigeration system to see if there is a shortage of refrigerant.

I think it's very likely that the power lines in your home are too loaded to support them, which will cause tripping.

There are only three possible reasons for the tripping of household circuit breakers: leakage, overload, and short circuit, and the air conditioning circuit is no exception.

Creepage. The circuit breaker will have a line of small print that reads "Please press before closing" and an arrow next to it pointing to a button

Overload. In order to protect the circuit, the circuit breaker sets a maximum current value – the higher the current, the greater the heat generated. If the heat in the line is too large, the wire will be burned at least and the disaster will be caused at worst. Therefore, it is necessary to use a circuit breaker to limit the current in the line to a certain range.

Short circuit. The possibility of a short circuit in the line is very small, especially during use. Generally, the air conditioner is short-circuited because of the wrong installation - when the air conditioner is installed, the wires are directly connected to the wrong one, and it is possible to short-circuit.

It could be one of the following reasons:

1.Circuit overload: The power required by the air conditioner exceeds the carrying capacity of the circuit, resulting in overload of the circuit and tripping of the power supply.

2.Power supply failure: The power supply itself is faulty and cannot be supplied normally, resulting in the power supply tripping.

3.Internal failure of the air conditioner: There is a fault inside the air conditioner, resulting in excessive current and tripping of the power supply disturbance.

4.Short circuit in the line: The wires of the air conditioner are short-circuited, resulting in excessive current and tripping of the power supply.

It is recommended that you contact a professional maintenance personnel for inspection and repair.

The most likely cause is the phenomenon of the compressor protection device tripping; Too much refrigerant can appropriately reduce the refrigeration dose and increase it; If the heat dissipation is poor, check whether the condenser pipe has dirt and dirt, and clean the condenser; If the pipeline system is blocked, it can be judged and eliminated with reference to the pressure gauge, and then the system can be rearranged; It may be that the evaporator or filter is dusty and fouling, and the evaporator or filter can be cleaned; It is also possible that there is a lack of fluorine, and when the lack of fluorine is lacking, the discharge temperature of the compressor will be overheated, so that the overheating load protection switch will trip, and freon needs to be added.

Supplementary knowledge: the use and maintenance of air conditioners.

1. Choose the operation mode of the air conditioner, such as refrigeration, heating, etc.

2. Set the temperature and adjust the temperature value of the temperature regulator. In general refrigeration operation, the temperature value is set in the range of 24 30. During heating operation, the temperature value is set in the range of 14C 22C.

3. After completing the above operations, turn on the air conditioner, so that the air conditioner can operate normally according to the selected operation mode.

4. After the machine is turned on and running, the cooling capacity and heating capacity of the air conditioner can be adjusted by adjusting the air volume switch as needed.

5. No matter what the reason for the air conditioner to shut down, because the general air conditioner is equipped with a time delay device for shutdown (the delay time is about 3min). At this time, although this type of air conditioner can be turned on immediately after shutdown, it can only be operated after 3 minutes.

1. What happens when the air conditioner trips as soon as it is turned on.

1. It may be caused by the instability of the voltage at home or the short circuit of the line, and the air conditioning compressor cannot start normally.

2. It may also be caused by an abnormality in the leakage protector at home.

3. The four-way valve of the air conditioner has a blow-by, which makes the high and low voltage of the air conditioner have problems, and when the current rises sharply, the air conditioner will trip as soon as it is turned on.

4. It is also possible that too much dust has accumulated on the condenser fins inside the air conditioner, which makes the air conditioner trip due to high heat load.

Second, how to solve the problem of tripping as soon as the air conditioner is turned on.

1. You can use the wiring board to reinstall a socket for the air conditioner first, and then try to start it. If there is still tripping, it means that the air conditioner is faulty. You can also unplug the power plug of the air conditioner first, and then send the gate up, if you can send it up, it means that the air conditioner has a fault, then you need to check in detail whether the air conditioning line has a short circuit, if it can't be sent, it means that the home line is abnormal.

2. If the insulation skin of the air conditioning line is damaged, then the insulation performance of the wire will deteriorate, and when the air conditioner is turned on, there will inevitably be a tripping phenomenon, which is an automatic power-off protection measure automatically initiated by the leakage protector at home in order to protect the electrical appliances, in order to prevent the air conditioner from burning out due to excessive current. At this time, it is necessary to use a multimeter to detect the socket, and if the wire is broken and short-circuited, it is necessary to ask an electrician to help detect and replace it.

3. If the socket of the air conditioner does not have a grounding wire or the wiring position is loose, it will also cause the air conditioner to trip as soon as it is turned on. If there is no abnormality in the socket, you need to check the compressor of the air conditioner in detail to see if there is any poor contact, and if so, you need to ask a professional to help repair it.

The reason for the emergence -

1. This will happen because of the lack of electricity during the peak period of electricity consumption, and the large rate of air conditioning.

2. Because the wire diameter of the power cord is too small, several high-power electrical appliances at the same time will make the power cord unbearable and cause tripping.

3. Because of the thermal protection of the press.

Suggested approach——

1. In the case of the old tripping of the air conditioner, check the cause of the fuse blowing first, and take measures to prevent it from blowing again, and adjust and repair it in time. It is recommended that households with air conditioners should be equipped with power supply, which can basically prevent the air conditioner from tripping.

2. When there is a short circuit when the disturbance air conditioner starts, then it is normal to trip, for example, there is an open circuit somewhere, or the insulating glue of the wire is aging and there is a short circuit in the connection, then it is necessary to measure the location of the short circuit with an instrument, and then solve it to carry it, which is generally recommended to be repaired by professionals.

3. Generally speaking, when there is a problem with the capacitance or circuit of the compressor, there will be leakage, and when the leakage is more serious, it will cause the air conditioner to trip after starting. In this case, it is necessary to inspect the coil of the compressor and see if it has any leakage problems, and then repair the coil.

4. If you can't solve the problem of the old jump of the air conditioner, it is recommended to find a professional to check and repair it.

There are generally two main reasons for the tripping of the air conditioner, one is the thermal protection of the press, and the other is the damage of the temperature resistance of the inner pipe. 1. Cause of failure 1: The fuse in the special circuit of the air conditioner is blown out, or the contact of the power switch is poor, or the power supply is out of phase. At present, many families only use one power supply, which will cause abnormal power supply due to the abnormal operation of other electrical appliances.

2. The power supply used by the air conditioner is too low, when the voltage is less than 10% of the single-phase normal voltage of 220V, that is, 198V or below, the refrigeration compressor in the air conditioner is difficult to start. 3. The knob on the temperature controller is not dialed to the appropriate position, such as dialing to a higher position, when the power supply is connected, the temperature in the air conditioning room has not reached the upper limit of the set temperature, and the compressor can not start running. 4. High-pressure relay action, such as the condensation pressure is too high, so that the high-pressure relay action stops the operation of the compressor.

5. Low-pressure relay action, such as insufficient refrigerant in the refrigeration system, resulting in the compressor suction pressure is too low, so that the low-pressure relay action and stop the operation of the compressor. 6. When the current of the compressor and fan motor is too large, the overload protection relay will act and cut off the power supply. 2. Solution 1: Check the cause of the fuse inside and outside the air conditioner from blowing out, and take measures to prevent it from blowing again, which should be adjusted and repaired in time.

It is recommended that households with air conditioners should set up a special power supply to basically prevent the air conditioner from tripping. 2. If the local power supply voltage is often in a low state, it should be used with reliable power supply regulation, and at the same time, it is recommended that families with more household appliances should use special power supply for power supply. 3. Adjust the knob on the temperature controller to the required position, that is, adjust it according to the temperature required by the air-conditioned room.

4. Check the cause of the high condensation pressure and eliminate it to restore the condensation pressure to normal pressure. 5. Check the cause of insufficient refrigerant in the refrigeration system, and eliminate it to restore the suction pressure to normal pressure. 6. Check the cause of overload of compressor motor and fan motor, and rule it out.

In the case of heat production, the heat pump-assisted electric air conditioner uses both electric heating and heat pump-assisted heating. The heating efficiency is high, and the power consumption is between the heat pump type and the electric heating type. The disadvantage of heat pump hot and cold air conditioner is that the machine failure caused by the failure of the four-way solenoid directional valve used is that the four-way electromagnetic directional valve of famous brand products has good working reliability.

The above are all the fault causes and solutions for the air conditioner to trip when it is powered on.

Tripping is a self-protection mechanism for household appliances, and always tripping means that your air conditioner is out of order. The reasons why the air conditioner trips as soon as it is turned on are as follows: there is a short circuit inside the air conditioner, and the electric switch jumps quickly after it is turned on to play a protective role.

The current of the air conditioner is greater than the rated current of the electric switch, so after turning on the air conditioner, the electric switch quickly trips and plays a protective role. When the switch fails, and the rated current of the switch is not reached, the switch will skip and leak. Workaround:

Replace the power switch. If it still trips, it is an air conditioner failure. You need to contact the after-sales service of the air conditioner for repair.

No matter what electrical appliances are, if there is a trip, there are many reasons, but look at your trip caused by leakage, find a multimeter to measure the resistance to the ground should be greater than 0 5m ohms, if a few thousand ohms below to see if there is water in that place, measure whether the shell of the outer machine is charged, the insulation is not good or the cable has a touch of the casing, and the door-to-door fee for repairing the air conditioner is also 50. Let's find someone to repair it as soon as possible. Poor contact.

Some air conditioners are installed on the wall, while others are pressed on the ground, and if the air conditioner is installed on the wall, it will require a long wire. At this time, if the length of the wire is not enough, it will affect the fit between the plug and the socket. If the plug and socket are not together, the air conditioner will always trip.

If it is an air conditioner placed on the ground, pay attention to whether there are children at home, if the child accidentally kicks the air conditioner wire while walking or running. At this time, the air conditioner will also trip suddenly, which will also affect the safety of the child. Could the main cause be a problem with the current?

There may be a leakage behind the air conditioner. Or the current passing through the air conditioner is greater than the air conditioner itself. So when the air conditioner can't withstand the current.

The air conditioner is more likely to trip. What happens when the air conditioner trips? How can I prevent my air conditioner from tripping all the time?

The amount of current should be ensured for drainage. Also pay attention to the plug and socket, be sure to connect together.

The old trip of the air conditioner can be caused by the following reasons:

1.Circuit overload: If the circuit where the air conditioner is located is overloaded, it may cause the tripper to trip old times. This may be because other electrical devices are also connected to the same circuit, resulting in the total load exceeding the carrying capacity of the circuit.

2.Circuit short-circuit: A circuit short-circuit is when there is direct contact between two wires in a circuit, resulting in excessive current, and the tripper will automatically disconnect the circuit. This can be caused by aging, damaged, or improperly installed wires.

3.Tripper aging: Trippers will also age with the growth of time of use, resulting in a decrease in their sensitivity and easy to trip by mistake.

4.Air conditioner failure: If there is a fault in the air conditioner itself, such as damage to the motor or circuit board failure, it may also cause the tripper to trip.

Workaround:1Check the circuit load, and if the load is too large, consider increasing the circuit capacity or reducing the use of other electrical equipment.

2.Check the circuit line, if you find that the wire is aging, damaged or improperly installed, you need to replace or repair it in time.

3.Replace the tripper, if the tripper is aging and causes the mobile game to trip by mistake, you need to replace it with a new tripper.

4.Check that the air conditioner itself is otherwise stupid and there is a fault, and if there is a fault, it needs to be repaired or replaced in time.