What causes water accumulation in the refrigerator crisper compartment?

There is a small hole in the freezer compartment of your refrigerator (near the sink), and you can poke it down with a soft wire about a meter!

Open the back of the refrigerator with a few small screws, you can see the water pipe, the condensate of the water pipe will flow into the water tray above the compressor, and the water will evaporate when the compressor is working hot!

If it freezes, it may be caused by the door seal not being well sealed, you can use a hair dryer to heat the door seal or boil the door seal with boiling water, make it expand, and then press it.

In addition, in the summer, it is necessary to de-ice the freezer frequently!

1.Why is there a lot of water in the fresh-keeping layer?

The working principle of the refrigerator has the problem of cold and heat exchange, in the process of exchange, water will be formed, and more water will be formed in summer, because of the large temperature difference. Whether the gear is adjusted to 1 or 3, the normal refrigerator is also below 8 degrees, which is always lower than the indoor temperature, and water will naturally form.

2.How to fix it.

Start by identifying the cause of the water leak.

There are several possible causes of water leakage as follows:

There is a water outlet hole in the refrigerator, maybe the hole is blocked, the water is not smooth, and the water is left everywhere (most of the landlord's refrigerator is due to this reason), or water accumulates.

If the hole is not blocked, check to see if the tube is blocked, usually behind the refrigerator.

It's not blocked, it's just that there is too much water generated, and it's too late to drain away.

If it's blocked, you can dredge it.

1. Under normal circumstances, the temperature of the refrigerator is set between 0 and 10 degrees, and the food will liquefy into water when it is cold in the sealed box because the food carries a large amount of water vapor and heat (or frequently opens and closes the door).

2. The door seal of the refrigerator is aging, causing the heat from the outside to flow into the refrigerator and turn into water droplets when it is cold. This is an important factor in making the fridge have water droplets. You can use the hot air of the hair dryer to blow on the door seal to soften the door glue and increase the elasticity.

7. If the water does not seep into the sink and accumulates in the refrigerator, it means that the water pipe is blocked, and it can be passed.

3. If the drainage pipe is blocked, the drainage hole of the refrigerator should be dredged with a thin wire.

1.See if the refrigerator door seal is deformed, and if so, replace it.

2.Let's see if it's true"Temperature compensated switch"Put it in the open position, and if it is, close it.

3.See if the drainage hole in the refrigerator is blocked, and if so, you can use a vacuum cleaner to suck it.

There is a drainage hole on the back wall of the refrigerator, and the normally melted water can be discharged, but after a long time, it is blocked by a small amount of debris (slightly), resulting in poor water outlet, and the fresh-keeping layer will accumulate water or freeze. There is a curved pipe under the small hole, which cannot be solved by poking something, you can open the small lid behind the refrigerator, you can see the drain pipe head, and blow hard against the pipe to blow out the debris! Then pour some water from the drain hole in the refrigerator (add a small amount of washing) and rinse it a few times!

Very effective!

There are several ways to solve the problem, please refer to:

1. See if the refrigerator door seal is deformed, and replace it if it is deformed.

2. Put the items in the refrigerator (especially those with more moisture) to wrap them in a fresh-keeping bag.

3. The temperature of the refrigerator should be appropriate, not too low.

4. The drainage hole should be dredged frequently, and it should not be blocked. (If it is blocked, you can use a vacuum cleaner to suck it, and the effect is very good).

5. The refrigerator compartment is a refrigerated item, do not be too close to the back wall (there is a condenser at the back, and the temperature is relatively low).

The air humidity in the refrigerator is too high, the temperature is too low, and the refrigerator drain hole is blocked, resulting in excessive water accumulation.

Exclusion method: The flow of water in the refrigerator indicates that the diversion pipe in the refrigerator is blocked. The diversion pipe is at the bottom of the innermost part of the refrigerator room, and there is a small hole, which is the diversion hole that leads to the outside of the refrigerator. Use a plastic sweater needle (be careful not to use wire) and rinse it with water a few times!

Attention should be paid to the completion of defrosting in the refrigerator room:

1. Check whether there is a gap in the seal of the door, if there is, please repair or replace it. (The way to check is to turn on the flashlight and put it in the refrigerator, close the door, carefully observe whether there is a gap around the refrigerator for light leakage, if there is, you can use a hair dryer to drag it outward, repeat it several times.) Or wash the sealing strip with an aqueous solution of laundry detergent, peel off the sealing strip at the light leakage, paste a piece of sealing tape, put the sealing strip as it is, and then check whether there is still light leakage.

This is done repeatedly until there is no light leakage. ）

2. The gear adjustment of the refrigerator room thermostat is not suitable, and it can be adjusted to 3 gears in summer.

3. Check whether the temperature compensation switch has been turned off.

4. Put things until they have cooled to room temperature, and it is best to use a sealing device to reduce the moisture in the refrigerator and reduce freezing.

Refrigerators are very important in our daily lives. For example, we buy fresh vegetables or fruits, and we can't finish a single meal. At this time, we can keep them fresh in the refrigerator.

So we can eat it fresh the next day, but sometimes there are various problems in the refrigerator, such as water entering the fresh-keeping compartment of the refrigerator. What's going on? Lap grinding.

The first case:

When the ice erector is used for food preservation, if too much food is stored in the refrigerator or the temperature of the stored food is too high, the steam contained in the food during the preservation process will condense on the inner wall of the refrigerator to form condensation.

Solution: You can put the food in the refrigerator to keep it fresh and refrigerated, so that the steam generated by the food will not condense on the inner wall of the refrigerator due to cold.

The second case: When the refrigerator is used in the hot season, if the refrigerator is turned on and off frequently, a large amount of hot air around the refrigerator will enter the refrigerator, and the moisture contained in the hot air will condense into water droplets after it becomes cold.

Solution: Minimize the number of times you open and close the refrigerator door. At the same time, it is necessary to dredge the drainage outlet and leakage of the refrigerator room to ensure smooth drainage, so that the condensate residue in the refrigerator can be buried and discharged from the refrigerator in time.

The third case: we can all see that the refrigerator's crisper compartment has a drainage hole. The function of this drain hole is to drain the condensate generated during the operation of the refrigerator out of the refrigerator.

If the refrigerator is used for a long time, the drainage hole is easily blocked by some debris, which eventually leads to poor drainage of the refrigerator, so there will be water in the fresh-keeping room of the refrigerator.

Solution: Clean up the stagnant water in the fresh-keeping room first, and then dredge the drainage hole in time. The drain pipe of the refrigerator has a certain curvature. You can open the back cover of the refrigerator, find its drain, remove it, clean the drain from the drain, and rinse it with clean water a few times to reinstall it.

1. There is a drainage hole on the back wall of the refrigerator room of our refrigerator, and the water can be discharged from the hole during normal use, but after a long time of use, the drainage hole is blocked by debris, which will create a situation where the drainage is not smooth, so that the fresh-keeping layer will accumulate water.

2. If the drainage speed is found to be poor, check whether the leakage hole is blocked, and the leakage hole should be dredged with a thin iron wire under the key state of the wheel base that cuts off the power supply.

There is a water outlet hole in the refrigerator, which has been blocked by a small amount of debris (slightly) after a long time, resulting in poor water outlet, and water is left everywhere. You can open the lid on the back of the refrigerator and you can see the drain pipe, and blow the pipe to blow out the debris! Then pour some water from the drain hole in the refrigerator (add a small amount of washing) and rinse it a few times!

Very effective!

Water accumulation in the refrigerator is generally caused by improper use.

The main reasons are:

1.When the food is placed in the refrigerator, the temperature is too high, and the overheated food contains water vapor, which turns into water when cooled. When this water cannot be drained completely, stagnant water is formed. For this reason, it can be solved as long as you do not put overheated food in the refrigerator.

2.When the refrigerator door is opened frequently, a large amount of hot air pours into the refrigerator, forming a hot and cold convection. When the refrigerator door is closed, the hot air easily liquefies into water.

This phenomenon is not unfamiliar to everyone, just like in winter, it is easy to have water droplets on the windows of a closed house. We should try to open and close the refrigerator door as much as possible, and shorten the time to open and close the refrigerator door. As long as you pay a little attention in use, it is not difficult to solve this.

3.Drain holes are blocked. The back of the refrigerator is designed with a leak hole, which is to drain the stagnant water in the refrigerator for the brigade shirt.

When you find that there is too much water, you should check whether the drainage hole is clear. If the drain hole is found to be blocked, it should be dredged with a thin wire when the power supply is cut off.

Refrigerator (a refrigeration device that maintains a constant low temperature):

1.Refrigerator is a kind of refrigeration equipment that maintains a constant low temperature, and it is also a kind of civil product that keeps food or other items in a constant low temperature and cold state. Inside the box there is a compressor, a cabinet or box for ice making for icing, and a storage box with a refrigeration unit.

2.The volume of a household refrigerator is usually 20 500 liters. In 1910, the world's first household refrigerator with compression refrigeration came out in the United States.

In the year the Swedish company Lido developed a household absorption refrigerator. In 1927, the General Electric Company of the United States developed a fully enclosed refrigerator. In 1930, air-cooled continuous diffusion absorption refrigerators with different heating methods were dismantled and put into the market.

In 1931, a new type of refrigerant freon was successfully developed, and the production of household thermoelectric refrigerators began in the second half of the decade, and China began to produce refrigerators in the 50s.

There is a lot of water in the refrigerator because the drain pipe is blocked, you can see that there is a small hole in the refrigerator, that is the drainage hole, you can just pass it through. The temperature in the refrigerator is generally not very low, there will not be a lot of ice melted with too much water, and a small amount of water is normal.

It may be that the drain on the back wall of your refrigerator is blocked, just find something to poke it. It's also possible that you have a lot of cold drinks in your fridge, which will also produce a lot of stagnant water.

It's normal to have water.

While your fridge is running.

After refrigeration, a layer should form on the wall.

Frost: After your refrigerator stops, the frost on the wall of your refrigerator will melt away, if you still have water in your refrigerator.

So you look at the middle of the lower half of the back wall.

There's a little hole.

You see, the little hole is not blocked.

If it's blocked. Then find a longer iron bar to penetrate.

It's all right, after you get some water into that little hole, you can see the water, and your refrigerator won't be able to have water in the future.

The methods of treating water accumulation in the refrigerator are: using diligent defrost, adjusting the water receiving funnel, controlling the temperature of refrigeration, not putting hot food in the refrigerator, opening the door and closing the door tightly.

1. Use diligent cream.

When using a refrigerator, it is necessary to defrost frequently, and it is also a measure to save electricity.

2. Adjust the water receiving funnel.

Adjust the water hopper to align it with the position of the water tray.

3. Control the refrigeration temperature.

The temperature in the refrigerator should not be adjusted below 0°C, usually 2-6°C, so as to prevent the water from freezing.

4. Hot food cannot be put in the refrigerator.

Many people are accustomed to putting steaming food in the refrigerator, which is wrong. This is because water vapor from hot food cools down, resulting in water accumulation.

5. Open and close the door.

When using the refrigerator, it is an important job to open and close the door tightly, and the liquid bridge should be careful to prevent it from running cold, and if the sealing strip is damaged, it should be repaired in time.