Cats are bright. However, the computer cannot connect to the Internet

That's the problem with your long network cable!

It may be that the location of the network cable port is wrong, or it may be that the network cable is disconnected You take it to a nearby computer repair shop to test it, if it is a port location is wrong, let the maintenance point readjust the port and then change the crystal head, no 5 yuan

It doesn't matter if it's orange, blue, green, brown, or brown, as long as you make sure that the other end is also in this order!

But if the network cable is broken, then the cable is basically scrapped, then you have to buy a new one

First of all, make sure that there is no arrears, and then if the third light is on when connected, it is a password error, if it is not lit, it is a line problem, and the line problem is divided into the line between the operator to the cat and the cat to the computer, and you will find the problem if you check it carefully, be patient.

The modena is bright and represents photoelectric transmission. There are three lights on, power supply, WLAN external network, and LAN internal network. The first two lights were on, but in the end they didn't turn on.

It's all on, and the last step is to dial! When the dialing is successful, it's OK. Did you forget to dial the number?

The network cable did something wrong.,It's all I can say.。。。

Orange, orange, white, blue, blue, white, green, green, white, brown, brownish. Isn't that so? Dude: That's what you do with network cables??

The international standards are: orange-white, orange-green-white, blue-blue, blue-white, green-brown-white, brown-white.

But I don't deny that as long as the two ends are in the same line order, they can be connected.

Try restarting the cat multiple times.

Summary. Hello dear, happy to serve you! The network cat signal light is not lit, the mobile phone can be used on the computer, if not, you need to reinstall the network card driver, open the computer manager, and select driver detection.

Hello dear, I am glad to serve you without judgment! The network cat signal light is not lit, the mobile phone can be used on the computer, and if you are sleepy, you need to re-install the network card driver, open the computer manager, and select the driver detection.

He doesn't show the network.

This has been successfully connected, dear.

1. The first light of the cat is the power supply light, the second is broadband, if it has been flashing, there is no network, and the third is the indicator light when the cat is connected to the computer. The last one doesn't make much sense. According to you, your cat should be broken.

Under normal circumstances, the cat has 3 lights that are always on, and if 2 lights are on, it should be that the adsl lights are not on.

2. It may be a problem with moden, not Huawei's cat will not have a problem, you can ask the Netcom company to change the moden for you first, and the general Netcom company can solve this kind of requirement.

3. There may be a problem with the quality of your line, this brother, the ** line is not continuous, you can ask the Netcom company to check the line for you, because the Netcom computer room can test the attenuation of the line, I used to be in the Netcom when the attenuation of the line is more than 50 can not be installed.

Cats generally have four lights, normal times, power, adsl, lan, these three lights are always on, if there is one that flashes often is abnormal, the data light will flash after normal surfing.

If these lights are normal and can't get on the network, it is a problem with the computer, if the router is not installed, you can find the cause of the fault through the error ** obtained by broadband dialing, such as error 693, that is, the wrong username and password, etc.

If your computer is surfing the Internet through a router, you must first bypass the router and use the above method to judge. If the dial-up is normal and the router is not surfing the Internet normally, you need to carefully set the router parameters according to the router's manual.

If you can't even dial up, then you need to check whether the computer has any viruses and whether the network card driver is installed correctly.

1.First of all, it is very likely to carefully review the settings;

2.Then find out that the router of the surrounding users can be used normally, if not, of course, the network provider has taken restrictive measures, and can only find them to solve;

3.If someone else's can take your router and cat to replace someone else's one by one, it may be that one of the devices is broken, or there is a conflict between the two.

4.Finally, if one of your computers has some special virus, it can also cause everyone to be paralyzed. Therefore, it is advisable to kill at the end.

I'm sure you'll figure it out!

Please check the following points first.

1. Whether the network cable is plugged into the main port.

Second, whether the Internet access and password have been set on the route.

3. Is there a problem with the network cable?

Fourth, whether the wireless switch of the computer is turned on in the case of wireless routing.

Then the three computers go online together, if they can receive wireless signals, one can be used as a wireless transmitter, and the other two can be receiving. Thank you.

Cats have 2 lights that are always on.。

WAN or Ethernet is always flashing. Basically, flash several times a second.

If so, it's a routing setup issue.

Sit back and see if that's the case.

The router is not set up.

The cat connects to the WAN port of the wireless router, configures pop dialing in the wireless router, fills in its own password, and the LAN port is connected to its own computer to access the Internet.

Different cats have different functions of lifting and dismantling, and generally come to say that the Internet light is a cat with the function of answering the road segment will light up after successfully dialing up the Internet by its own. That light of yours doesn't come on to see what the error is.