The power connector of the IDE hard disk is broken by a pin in Rush 30

The broken pin of the power interface can still be used, which means that the broken one has no effect on the hard disk, and the slow should be your psychological effect or other reasons.

Each brand of hard disk has different requirements for this aspect, but they are all roughly the same, this kind of hard injury, it should belong to the paid warranty category, if you do not delay the use of it is recommended not to replace the warranty. The fee should be around 50 or 60 yuan.

This will not give you a warranty for free, and you will have to charge money, generally about 60 yuan. Change.

It's not expensive, in fact, you can handle it yourself, or go to the repair shop and let him weld it for 10 yuan.

But what about yours during the warranty period, take it back and send it for repair, generally, he has to ask you for 100

Covered by the warranty, no money will be charged for any breakdown repairs unless vandalized.

If it is an improper method of unplugging and unplugging the power supply, it is damaged by human negligence, and you may have to charge money.

The charging standard varies from brand to brand, and you can also go to a professional hard drive repair shop.

A needle will be fine.

Do not worry. It will age when it is old.

Mine has broken a few of them.

You don't have to spend money to do unnecessary things.

If it's broken, it's okay if it's the middle two, it's the negative pole, it's connected together on the circuit board, it's okay, just have one,

Don't be afraid, if you go to repair the computer for a small problem, you can get it for dozens of dollars.

The two needles in the middle are connected, it doesn't matter if one is broken, one on both sides is 5v, the red line, the other is 12v, the yellow wire, if it doesn't move long, just find an electric soldering iron and connect the wire.

The pins in the hard disk interface generally have their corresponding functions, and if the pins are broken, there will be various problems.

Generally, in this case, it can only be sent for repair.

Remove the circuit board, remove the remnants of the broken needle, and find a metal rod of similar thickness to thread into it and solder it.

Of course, it has an impact, it will affect the performance and lifespan, take it to the computer city to repair it, it is not expensive, it is better not to get it yourself.

Because it is not clear which one is broken, it cannot give you a clear answer, which has a certain impact on the work of the hard disk.

The solution is to plug in the needle yourself, or return to the factory for repair.

Different motherboards have different IDE slot locations.

You said the one farthest away from the power cord, who knows.

The idea of inserting a needle by himself mentioned by the brother above is very good.

You can try it, and if you can't figure it out, find a professional acquaintance.

Don't waste your three rights to the three guarantees.

You can cut that small strip of IDE in a way similar to a flying lead, and then solder it directly to the PCB board of the hard disk.

This trouble.

If you want to take it off completely.

Use the second-level repair artifact - the tin pot.

If not, pray that the needle you broke is GND or undefined.

Don't change boards.

Didn't look for it. You go to the place where the motherboard is repaired and see if you can get it.

If it can be used on the computer, there are 16 pins in the IDE hard disk that are ground wires, and it doesn't matter if there is one less. As long as the data line is constant, it's fine.

It is estimated that some of them will have problems, so let's fix them.

Use welding technology to pull out the broken pin, and then directly connect the corresponding voltage, (the most practical, the simplest).

This kind of you have to see if there are other burns on the hard disk circuit board Like this, it is generally not as simple as just burning the power port.

It is recommended that you go to a specialized data recovery agency.