What should I do if Tuyue burns engine oil very badly?

Reasons for burning engine oil: long-term unclean oil circuit, untimely replacement of antifreeze, and too long oil service cycle.

The harm of burning engine oil: it will continue to generate greater carbon deposits, which will seriously pull the cylinder. The three-way catalytic converter is completely damaged in the poor combustion exhaust gas,,, and the continuous life-sustaining oil will eventually cause the engine to burst the cylinder.

The three points of the car that burn the engine oil will inevitably occupy one point, and the most important point is the high temperature caused by the oil circuit not being effectively cleaned.

Causes of piston ring seizure.

The oil used for the stuck piston ring will be caused by the oil scraping not clean and remaining on the cylinder wall, causing the oil to participate in combustion and burn the oil. Among them, the cylinder wall will be seriously worn due to the delay in processing, and the engine will have to be disassembled.

In fact, the treatment principle of piston ring stagnation should start from the oil circuit, the reason for the stagnation is the beginning of the oil circuit, the oil bearing temperature is 110 degrees, and the high temperature caused by the long-term unclean oil circuit makes the oil at a temperature of 120 degrees or higher for a long time, so that the oil will be exhausted in advance, the small hole of the oil ring is very small, and the oil inside will be dried and scabbed for a long time, and a cylinder stuck is 5000 kilometers of a liter of oil, at this time, the working conditions of other cylinders will also begin to be bad, and soon the 4 cylinders will be stuck. It becomes a liter of engine oil for 1000 kilometers or even hundreds of kilometers. Therefore, in order to solve the problem, we must start from the root oil circuit, which is the way to remove the root.

This kind of car burning engine oil is very easy to do, first check the exhaust valve to see if there is a problem, and then see if the cylinder wall wear is serious, there is no problem, it must be caused by the piston ring stagnation, because there is no cylinder wall wear is not required to overhaul.

The problem of burning engine oil caused by piston ring stagnation is a phenomenon that occurs in most oil-burning vehicles. Now the no-dismantling technology has been very mature and gradually accepted by the majority of car owners. In particular, PNF non-destructive repair technology has completely gotten rid of the technical shackles of the operation of the auto repair shop, without removing a screw, the owner can operate it himself, and the piston ring is repaired and released during driving, and the effect is remarkable.

When the cylinder barrel of the engine is worn too much, when the engine is running normally, the oil brought up by the piston ring will enter the combustion chamber and participate in the combustion of fuel, when the piston in the engine is worn too much and the piston ring loses its elasticity, there will be a situation where the seal is not tight, and the same will bring the oil into the combustion chamber, and the other is the valve guide of the engine is eccentric wear and the valve oil seal is agingThere is a gap, causing the oil to enter the combustion chamber for combustion, what is the specific reason? Or drive to the 4S shop or auto repair shop to check

If it's too powerful, you can only go to the repair shop to check, some are caused by the exhaust valve, or the check valve, if these two problems are eliminated, you can only overhaul the engine.

Go to a professional repair shop for a check-up and get the right medicine.

Summary. Models produced after 19 years must use 0W-20 oil for China 6b emissions, which is due to the more precise machining method of the engine and the means adopted to meet the exhaust emission standards. The use of other viscosities can cause abnormal wear and exhaust emissions due to poor lubrication of the engine, as well as high fuel consumption and increased engine noise.

The particle trap of riding is easy to block, usually try to avoid low-speed driving or idling in place for a long time, usually drive a little more violently, step on the accelerator larger, so that the engine and exhaust system heat up quickly, in order to avoid the three-way catalytic blockage, resulting in increased fuel consumption and exhaust emission problems.

Models produced after 19 years must use 0W-20 oil for China 6b emissions, which is due to the more precise machining method of the engine and the means adopted to meet the exhaust emission standards. The use of other viscosities can cause abnormal wear and exhaust emissions due to poor lubrication of the engine, as well as high fuel consumption and increased engine noise. The particle trap of riding is easy to block, usually try to avoid low-speed driving or long-term idle work in situ, usually drive a little more violently, step on the accelerator larger, so that the engine and exhaust system air attack system quickly heats up, in order to avoid the three-way catalytic blockage, which leads to an increase in fuel consumption and exhaust emission problems.

And 5w-30's, which one is better?

You can only choose 0w-20 engine oil, 5w-30 is not good, you can only choose this kind of engine oil, you can use the original oil or fuchs blue oil.

Most of the Volkswagen Tukai engine oil is caused by the piston ring being stuck by carbon deposits. Relying on the addition of high-viscosity engine oil to continue life is only an expedient measure to cure the change. When the oil enters the combustion chamber to participate in combustion, more carbon deposits will be formed, which in turn will lead to the aggravation of the burning of engine oil, forming a vicious circle.

In the long run, it will cause cylinder wall strain, or even cylinder burst, and finally the engine can only be disassembled for overhaul.

Four reasons why you burn engine oil.

A ...If you don't clean the oil circuit for a long time or don't do effective oil circuit cleaning, detergents are used at will, and using detergents and effective detergents are two different things;

IIThe antifreeze replacement cycle is too long, or the side congratulations do not replace it at all;

IIIThe oil change interval is too long;

IVLong-term or often short-distance driving.

The above four points of the vehicle that burns engine oil must be occupied by one or all four points.

How the piston rings are stuck.

The principle of piston ring stagnation should start from the oil circuit, the oil temperature is 110 degrees, and the high temperature caused by the long-term unclean oil circuit makes the oil at a temperature of 120 degrees or higher for a long time, so that the oil will be exhausted in advance, the small hole of the oil ring is very small, and the oil inside will be dried and scabbed for a long time. It becomes a liter of engine oil for 1000 kilometers or even hundreds of kilometers. Therefore, in order to solve the problem, we must start from the root cause of the oil road, which is the way to get to the root.

The solution to burning the oil.

In the habitual thinking of car enthusiasts, they always think that burning engine oil should be overhauled, so that they not only have to bear high maintenance costs, but also bear the unpredictable risks and depreciation losses brought about by the overhaul. Destroy the airtightness and precision of the engine. And it is possible to burn the engine oil again after tens of thousands of kilometers, so overhauling the engine is unsustainable.

Now the no-dismantling technology has been very mature and gradually accepted by the majority of car owners. In particular, the non-destructive repair products containing PNF patented technology have completely gotten rid of the technical shackles of the operation of the auto repair shop, and the owner can operate it himself without removing a screw, and the piston ring is repaired and released during driving, and the effect is remarkable.

Pacific Automobile Network] Tuyue engine will have some burn oil, but this is for the old model, **Tuyue is relatively rare, unless the vehicle has a fault reason. The engine oil itself has a certain consumption of douyin, and excessive consumption is the problem of burning engine oil. There are many factors that affect the burning of engine oil, such as:

Fuel quality, driving conditions, driving habits, maintenance habits, etc., the above reasons will aggravate the oil consumption of Tuyue and lead to oil burning.

There are generally two types of real "engine oil":

Cool car burning oil: every morning when the car is on for the first time, the rear exhaust pipe will have a relatively thick blue smoke discharge, and the blue smoke will disappear after a while;

Burn oil when accelerating: When the vehicle is driving and slamming on the accelerator or when the vehicle is on the spot, a large amount of blue smoke is emitted from the exhaust pipe.

The phenomenon of aggravating engine oil consumption and causing Tuyue to burn engine oil is as follows:

1. Carbon deposition occurs in the combustion chamber, which makes the gas ring of the piston ring stuck, and the sealing is poor.

2. Oil sludge is generated in the lubrication system, and the oil sludge blocks the oil return hole of the oil ring and weakens the oil scraping performance.

3. Wear occurs between the piston and the cylinder wall.

4. The valve seal is corroded and aging, and the sealing performance fails.

In addition, there are crankcase ventilation systems (exhaust valves) in cars today, which can also increase the consumption of oil. With the development of science and technology, the problem of burning and infiltrating oil can also be solved by not dismantling and repairing.

Photo by Li Caiying of Pacific Automobile Network).

The Tuyue engine will burn some oil, but this is for the old models, and there are fewer new models, unless there is a problem with the vehicle. The oil itself has a certain amount of consumption, and excessive consumption is the problem of burning oil. There are many factors that affect fuel combustion, such as:

Fuel quality, road conditions, driving habits, maintenance habits, etc. The above reasons will aggravate the fuel consumption of the earth moon and lead to oil burning.

There are two kinds of real "fuel":

Car cooling and burning oil: When you get in the car for the first time every morning, a thick blue smoke will come out of the rear exhaust pipe, which will disappear after a while;

When accelerating, burn the local oil: when the vehicle slams on the accelerator or stops in place while driving, a large amount of blue smoke is emitted from the exhaust pipe.

The increase in fuel consumption leads to the phenomenon of burning oil in the earth moon;

1.Carbon deposits occur in the combustion chamber, causing the air ring of the piston ring to jam, resulting in poor sealing.

2.The lubrication system generates sludge, which clogs the oil return hole of the oil ring and weakens the oil scraping performance.

3.Wear occurs between the piston and the cylinder wall.

4.Corrosion and aging of valve seals and failure of seal performance excitation.

In addition, there are now crankcase ventilation systems (exhaust valves) in automobiles. If something goes wrong, it can also exacerbate fuel consumption. With the development of science and technology, it is possible to solve the problem of burning engine oil without dismantling and repairing.

Millions of subsidies for the purchase of Mingla front cars.

1. It will cause the oxygen sensor of the vehicle to be damaged too quickly.

2. It will lead to an increase in automobile fuel consumption, excessive exhaust emissions, unstable idling, self-improvement of automobile hidden dangers, and an increase in economic burden.

3. The adverse consequences such as increased carbon deposition in the combustion chamber of the engine, weak acceleration, slow speed, and insufficient power will be pointed out.

The impact is as follows: Absolutely

If the engine appears and takes the code to burn the oil, it is not fully burned. The fuel consumption of the engine will increase, and the fuel consumption will increase due to poor combustion of the engine for a long time, the three-way catalytic converter may be blocked or damaged, and the emission of the engine is not up to standard, and the annual inspection of the vehicle cannot be passed.