My computer takes a long time to add personal settings after it boots up, what s going on?

Updated on number 2024-04-20
18 answers
  1. Anonymous users2024-02-08

    There's too much to start. It's good to optimize it, or turn off some startup items that don't work.

    There are too many things to start randomly, so it is recommended to install Yahoo Assistant and use the optimized acceleration function inside.

    Yahoo Assistant - Optimization Acceleration - Computer Startup Acceleration.

    Remove all the ticks and restart the computer.

  2. Anonymous users2024-02-07

    There are too many programs to start, enter the msconfig command in the start and run, run, and then check the items you don't want to start in the startup bar to solve the problem.

  3. Anonymous users2024-02-06

    1. Type msconfig in the start and run, and turn off some useless startup items.

    2. It may be related to the installed anti-virus software. It is recommended to optimize it with Super Bunny.

  4. Anonymous users2024-02-05

    You have too many things installed, or they are all installed in the C disk, and the virtual memory is not enough, so you uninstall it and install it in another disk.

  5. Anonymous users2024-02-04

    There are too many programs to start, enter msconfig in the start and run fields

  6. Anonymous users2024-02-03

    Fake dead, reinstall the system. or use a restore, but it may not be successful.

  7. Anonymous users2024-02-02

    There are too many things, it's too messy, it's better to tidy up, or simply reinstall the computer system.

  8. Anonymous users2024-02-01

    Delete the things that are not much used, or are rarely used

  9. Anonymous users2024-01-31

    Cause: The motherboard coin cell battery is dead.

    Solution: 1. Disassemble the side panel of the chassis and find the motherboard button battery.

    2. Replace the battery.

    3. Enter the BIOS to reset the time, etc.

    A: When the computer has just started up, the screen as shown in Figure 1 below appears.

    B: Press the Delete (or DEL) key and don't let go until you enter the BIOS (Basic Input and Output System) settings.

    C: In the main menu, use the arrow keys to select the Standard CMOS Features item and press Enter, which will enter the Standard CMOS Features item submenu.

    D: Press F10 to save and exit after setting the time.

  10. Anonymous users2024-01-30

    1. Computer poisoning, virus tampering system time.

    2. The time setting is incorrect - for example, the time zone is set incorrectly, but you have turned on the time synchronization with the Internet, so every time you change it, turn on the computer again, and the time will be automatically synchronized, resulting in the wrong time every time you turn on the computer.

  11. Anonymous users2024-01-29

    The battery power on the motherboard is indeed limited, so there are often problems with the time of the computer, as well as problems with the BIOS settings.

    Generally, the BOIS battery is dead, and the BIOS battery has to be replaced.

  12. Anonymous users2024-01-28

    No, it's the battery on the motherboard that is dead, just change the battery and set it up for a while.

  13. Anonymous users2024-01-27

    This is caused by the motherboard battery is dead! There is a button-like battery on the computer motherboard, and the clock is powered by this battery, just replace one; For example, if you set the password of the motherboard and then forget it, you can buckle the battery and put it back after about 10 seconds, so that the settings will be restored to the default settings of the factory.

  14. Anonymous users2024-01-26

    Every time the computer starts, you need to set the time, indicating that the motherboard BIOS is dead, that is, the motherboard battery is dead.

    Take out the old battery of the motherboard and replace it with a new one, **Approximately 3-10 It is round.

    The function of the BIOS battery in the computer is to provide the role of recording BIOS information after the computer is shut down, if it is out of power, it will cause some basic information of the computer to not be saved, and more importantly, 2 points 1 boot needs to press F12 The time of the computer will change to the date of appearance of the motherboard, if the battery of the computer is dead, it needs to be replaced.

  15. Anonymous users2024-01-25

    How did you come to be Level 4? Old Peng! I wondered to death.

  16. Anonymous users2024-01-24

    The electronics of the computer motherboard are out of power, or broken, just replace it with a new one!

    There is a thing on the computer motherboard with a diameter of about 2 cm similar to a button battery, you unplug the power supply every time even after half a year in the boot time is right, this clock is powered by this battery, and the relevant settings of the motherboard are saved by a battery, for example, you set the password of the motherboard and then forget, you can buckle the battery, and then put it back after about 10 seconds, so that the settings are restored to the default settings of the factory.

  17. Anonymous users2024-01-23

    1. The motherboard button battery is out of power and needs to be stopped and replaced.

    2. Enter the BIOS to set the time after replacing or set the time after booting into Windows, and the date of the abbreviated traces.

    3. If there is a problem with the crystal oscillator or chip capacitor of the motherboard, it needs to be repaired.

  18. Anonymous users2024-01-22

    If every time is the point of starting,Close the computer shutdown of the Kai state bucket,It is recommended to enter the system**hdtune,Check the health of the hard disk,Under normal circumstances,If chkdisk is checked no problem,The next boot will not automatically run staring grinding。

Related questions
7 answers2024-04-20

If your system partition is FAT32 and username.

There are no kanji in it. >>>More

16 answers2024-04-20

None of what you said is correct, follow my method, click on the Internet neighbor on the desktop, select right-click properties, and find the local connection. Select the right-click attribute, pull down, select Internet Protocol, double-click, select Use the following IP address, and fill in the subnet mask in the IP address to use the default. >>>More

13 answers2024-04-20

You can select "Start Running" and enter "at 22:00 shutdown -s", so that at 22 o'clock, the computer will appear in the "System Shutdown" dialog box, which will have a 30-second countdown by default and prompt you to save your work. If you want to shut down in a countdown mode, you can enter "-s -t 3600", here it means it will automatically shut down after 60 minutes, and "3600" means 60 minutes.

5 answers2024-04-20

Start-Run ·shutdown -i Show GUI interface Must be the first -l Log out "Cannot be used with option -m" -s Shut down the computer in 30 seconds -r Shut down and restart this computer -a Discard system shutdown -m computername Remote computer shutdown Reboot Discard -t xx Set shutdown delay xx seconds -c (comment) Comment (maximum 127 characters) -f Force running application to close without warning -d [u][p] :xx:yy close original u is the user p is a scheduled close x is a major original (a positive integer less than 256) y is a minor original (a positive integer less than 65536) For example: >>>More

7 answers2024-04-20

Timed shutdown 3000

The most professional timer shutdown software, a good helper for parents, to meet all kinds of users who have needs for timer shutdown. Powerful and easy to use, it has functions such as shutting down the computer at a scheduled time, scheduling tasks, disabling online chat and browsing, prohibiting running your set software (such as games), prohibiting the Internet and using the computer during a specified period of time, and hiding the disk lock. >>>More