What s going on with the cutter head falling down?

It should be hydraulic fluid.

Without. Go ahead and give it a try. It can be seen from the top of the spindle. There is a small box next to the hydraulics for oil. There is also a possibility that the steam pressure is not enough, or that steam pressure switch is broken. There are only a few possibilities.

It should be that the bottom of his head is not fixed, so it causes him to fall down, in this case, you can fix it next to it.

The reason why the cutter head always falls down.

1. Is the cutter head frame too worn and the gap is too large;

2. The blade is not worn out too much;

3. Is the screw of the inverted blade of the card loose?

What's going on with the cutter head falling down? The question you are asking should be caused by the lack of a good head or poor contact. It's still safe to be safe.

In this case, it should be that the screw of the cutter head is faulty, and in this case, the screw of the cutter head must be changed, so that it can be.

This is because of gravity, gravity causes objects to fall down, and teammates are called gravitational forces.

That's because your screws are slippery and not properly secured.

This is mainly because the combination is not stable enough, and he can add some sealing rings.

What is the cutting machine cutter head down? What's going on? Or maybe the head he designed fell underneath.

It's because it's not tightened, and if it's tightened, it won't fall down.

The cutter head of the cutting machine fell down, maybe you didn't install it right, or it was the reason why the gap was relatively large!

What's going on with the cutter head falling down? Is the screw loose? Or the cutter head is not explained.

It's nothing, you can't fall off if you twist the screw, it must be loose.

What's going on with the sixth-level cutter head falling down, this is not clear, you should go to the place where the cutting machine is sold and ask what's going on?

Falling down like this is most likely due to loose screws, and it is recommended that you ask him to tighten the screws.

What's going on with the cutter head falling down? The screws are not tightened.

What's going on with the cutter head falling down? I think there's something wrong, right? What's with? Check it out, or ask the manufacturer!