A broadband 2 home problem urgent 30

1. If you connect the route, the route is turned on 24 hours a day, and the cat is also turned on 24 hours a day. 2 Affects internet speed. 3 There will be no additional fees, you don't have to ask, they must say no, that's money. My house is a router with three machines. No one asked.

Netcom installation and routing is to do business. Of course, the route has to be open 24 hours a day, and so is the cat. Two uses of 100 are not enough. There will be no additional charge for the annual subscription, as long as you can open an extension.

1. It's no longer 300 hours a monthly!

2. Routing cats can be turned off, if both of you are not on the Internet at the same time.

BPS shouldn't be your internet speed. (It should be 1m, 2m mostly for home broadband) 4, is the Netcom overlord clause. You can sometimes be on two planes, sometimes only one. However, there is now cracked software, which can be installed to access the Internet on multiple machines.

Want me to tell you**. You go down yourself.

The first is the need for AP plus switches, which are the most traditional network structures. The AP and the switch are connected through network cables. As long as the network cable can be extended to the area, the AP can carry out WiFi coverage.

TP-Link has a wide range of panel APs that can be mounted directly on the 86 back box. It provides a wifi signal and also comes with a network cable interface.

The number of interfaces is available and 4 are optional. I bought 2Products with interfaces. Behind it is a standard RJ45 interface.

Powered directly via network cable. Must be used with a switch or router that supports PoE power delivery.

The second is the need to manage LAN bandwidth through the router. If you have router management privileges, using the bandwidth of the router administration area network is the most ideal way to control the speed of your network. Nowadays, many routers have LAN bandwidth management functions, which can be achieved with a home router of about 100 yuan.

Through the bandwidth management function of the router, you can control the bandwidth of any computer in the local area network, and you can set not only the maximum downlink bandwidth, but also the maximum uplink bandwidth. This method is simple to operate, but the effect is obvious.

In addition, if the AP access and rejection thresholds are set reasonably, this system can also provide a good experience. Too much hope is placed on the panel AP. Basically, each panel can only manage one room.

The signal in the bathroom and corridor light area is very weak. It's hard to cover the whole house, let alone roam. If you have high requirements for WiFi, it's best to consider the ceiling AP replacement panel, which is a product designed for large coverage.

However, it is important to note that this is only a cheap plan, but if you want to eliminate the latency caused by roaming, please choose a product that explicitly supports fast roaming, which will cost much more.

It is important to know that the advantages of fiber broadband areHubs, Ethernet switch and other networking equipment have low cost, and users do not need to install ADSL modulator manual crude liquid demodulator, which is the capital of Ethernet and ADSL competition. Fiber broadband users have less investment and low cost. ADSL leverages existing on-premise** networks.

and the computer room of the exchange office, which is inseparable from the fixed office. Limited by the geographical area used, while charging ** fees also increases the cost of the product.

In order to make full use of the two broadbands, it is necessary to distinguish the functions of the two broadband bands, one of which is used to connect the wireless router, and the other broadband is used for the use of desktop computers, network TVs and other fixed facilities, so as to ensure that the network speed is not ready to occupy, and give full play to the advantages of the two broadbands.

These two sets of broadband can be installed upstairs, downstairs, or one in the living room and one in the room.

It is very scattered and multi-type, and the family will use its own mobile phone number to bind the operator's broadband, and the two broadbands can be switched freely to prevent network disconnection, and can be installed in different rooms.