The RTP annealing time of the film is 60 seconds and 20 seconds, and it has been done to the next pr

This time is very short, so you don't need to worry too much, you can make the next process.

If you do the next process, it will have an impact, because there will be a time gap, so there will be an impact.

This is definitely not going to make a difference, and this can be completely reassured.

If you do it for 20 seconds, you will have a certain impact on the next program, of course, it will have a certain impact on the next program, and of course it will have a certain impact!

Generally, it is not a big impact, and then it is a reasonable situation, and the normal situation should not be too big.

This one is influential, and it's best to follow the rules.

Hello, if this time is pushed from 60 seconds to 20 seconds.

Then it will still have a little bit of an impact relatively speaking.

If the time is shortened, I don't think it will have much impact on the next process, otherwise the leader will not decide to reduce the time.

There will be a certain effect, and this stress is not completely eliminated.

The film return time is 60 seconds 20 seconds to do the next step and application, this impact will not be too big, you should have a certain amount, slightly less impact.

Sixty seconds between the help annealing stones and twenty seconds of degeneration have a certain effect.

I can't do it after 60 seconds of annealing time and 20 seconds of relapse, does the next red have an impact? I think it's going to have an impact, a little bit of an impact.

I still have a certain influence, let us know that if there is a problem with this, the impact will be bigger.

Under normal circumstances, it will reduce the service life and actual use effect, and should be replaced.

Yes. The process is not the same.

Product performance has an impact.

Verification is required before processing can continue.

It is recommended that specific problems be analyzed in detail, and engineers should seek truth from facts. I'll ask your colleague what is the reason for writing like this, can you show me the process flow diagram and the production layout.

Generally, this annealing time should be able to achieve the process.

Don't RTP annealing for 60 seconds, retreat for 20 seconds to do the next process, does it matter? There is no impact.

Film RTP, annealing time of 60 seconds, retreat to 20 seconds, all to the next construction period, this is completely unaffected, can be operated in this way, is very good.

We say that the professional operation process has a strict time limit, and it is recommended that you operate according to the specified time, so as to ensure the quality of the product.

Of course, this is expired, of course, it must be done again, and the original polishing needs to be carried out again.