-
1. How much is the temperature of your water, which is constant between 25-28 degrees.
2. Whether your filtration system has oxygen spray, or whether the water splash filtered by the top can supply enough oxygen!
3. Whether the filtration is open 24 hours a day or more than 12 hours, fish farming can not be heartbroken money, otherwise the gains outweigh the losses.
4. Put enough ceramic rings and the like under the filter cotton to allow nitrifying bacteria to survive.
5. Change one-fifth of the water tank in a week and wash the filter cotton, fish farming is water farming, and you can't be lazy.
6. In order to quickly get the water good to buy nitrifying bacteria and yeast flakes, put them on the filter surface, when the nitrifying bacteria are bought, you must smell whether they are smelly, and if they are not smelly, they are fake, unless you use very expensive dry nitrifying bacteria that do not smell!
7. Don't use water purifiers!
-
The reason is that during the hydrolysis process of water purification agent, physical and chemical processes such as coagulation, adsorption and precipitation occur. Its coagulation effect forms flocs. Fast and large and heavy particles, fast sedimentation.
As your filter pump constantly pulls the floc out of the tank and into the filter tank, where it settles on the filter cotton. As a result, the filter cannot be drained smoothly.
Solution: Clean the flocs on the filter cotton.
According to the above filtration effect of your filtration system, it is recommended to replace the filter pump with a higher power, or clean the filter cotton in time.
-
Nowadays, most of the fish are raised in bare tanks, and the advantage of bare tanks is that they are easy to clean, and dirt is not easy to accumulate at the bottom of the tank. However, due to the lack of nitrifying bacteria in the tank, the self-cleaning ability is limited, if the density of the fish is large and the feeding is too much, and the fish feces cannot be absorbed in time, the water body is easy to be turbid in many cases. Because the BB of the fish cannot be decomposed and transformed by nitrifying bacteria in time, the ammonia nitrogen in the tank exceeds the standard, and the fish is easy to get sick or even die.
The Yongqing filtration system cultivates a large number of nitrifying bacteria in the biochemical mesh plate and bottom sand in the tank to decompose and treat fish feces in time, and generates a directional water flow under the net plate to guide the dirty things to the water inlet to be pumped out and filtered out. So as to keep the water stable and clear, so that the fish are healthy and less sick, and can grow moss and green algae in the fish tank. Yongqing filter to find out.
The system has an automatic cleaning function to clean the bottom of the tank, so that you can enjoy the fun of fish farming with ease.
-
Don't add water purifier to nitrate bacteria. Stabilizers. If you want to clear the water, you can look at my library, which says very clearly, and it is very cost-effective.
-
Your filter should also be washed or replaced.
-
There are two solutions to the problem of circulating pump selection, either to improve the filter box and make the filter box larger, or to change the submersible pump to a smaller flow rate, but the flow rate of the submersible pump must be guaranteed to meet the filtration needs.
The fish tank submersible pump can be used in the case of greater or less than 15% of the normal voltage, if the power cord is damaged, please disconnect the power supply immediately, please clean the rotor and water blades regularly, the user must check whether the rated voltage of the pump is consistent with the actual voltage before use.
When installing or dismantling and cleaning the water pump, you must first unplug the power plug and cut off the power supply to ensure safety.
-
There are two solutions to the problem with your circulating pump selection, either improve your filter box and make it larger, or change to a submersible pump with a lower flow rate. However, the flow rate of the submersible pump must be guaranteed to meet your filtration needs.
-
The filter power is high, and the water flow is too rapid, resulting in the water flow not rushing down and overflowing, in this case, the water flow pipe can be replaced with a thinner one to slow down the flow of water.
-
There are two reasons, one is that the water barrier is too high, and the water is naturally full. The second is that the spacing between the two water baffles is too small.
-
This juicer should.
There is an instruction manual.
You can turn it on.
Let's take a look at the manual.
How to do it can be done.
If you're not buying an old one, that's easy.
-
Well, it's not good to filter cotton, change to a filter cotton with better water permeability, first lay a layer of ceramic ring and put filter cotton on the bottom, and don't put filter cotton at the water outlet.
-
The water permeability of the filter cotton is too poor, so make a filter cotton with gauze yourself.
-
I've been bothered by this question for a long time! Recently, I found out what's going on, there is a net in the filter box, if the net is close to the box, and then put the filter cotton on it, it will not be breathable, you just turn the net over or break it into an arch and then put the filter cotton on it, I hope it can help you.
-
The reason why the upper filter fish tank tank is full is mainly that the filter cotton is not cleaned frequently, resulting in poor permeability, and the water pumped into the tank can not flow out in time, the second is because the power of the pump is relatively large, and the outlet of the sink is relatively small, so that the pump and the sink do not match, resulting in the water can not be discharged in time, resulting in the speed of the tank being full, so the filter cotton of the sink should be cleaned frequently to avoid the phenomenon of silting.
-
A filter can be added to filter the water from the fish tank in large quantities and repeatedly in a short period of time. Insist on changing the water every day, do not have to change it all, use a device or a rubber pipe to replace a part, and use clean water that has been cooled for more than 12 hours to replenish, which is to be done every day, and can be changed more or less according to the water quality.
There is a special water filter for fish farming in the market, which is evenly sprinkled into the tank according to the proportion of the fish tank, and the filter is used to filter out impurities. It is necessary to wipe the inner wall of the fish tank with a cotton cloth regularly, and use algaecide, the effect is ordinary, and the advantage is that it is effective for any algae, and it can effectively remove the algae attached to aquatic weeds, sunken trees and other places that are not easy to remove.
-
1. If the light is too strong, the green algae in the water will continue to grow, so the water will turn green. Now the only way to do this is to change the water to shade the fish tank, which cannot be placed by the window and let the sun shine directly.
2. The fish tank is not large, there are too many fish or the power of the filter is small, and the dirt cannot be completely filtered, and the green algae will grow very quickly.
3. Feeding too much, the fish can't finish the feed, the feed rots in the water, the water quality is over-trophied, so that the water accumulates ammonia and other substances faster, and after nitrifying bacteria, it will be converted into nitrate, nitrate is an important fertilizer for aquatic weeds and algae, and if the water contains a lot of nitrate, the algae will also grow wildly.
4. The nitrification system declines, if the nitrification system operates normally, the algae will not grow like this, only when the nitrification is not working, it will be like this. This means that if one species is strong, the other will be weak.
It is recommended that you change the water again, maintain the water, and establish a nitrification system.
If there is green algae on the wall of the fish tank, you can raise a scavenger or two to eat the green algae. Algae shrimp, black-shelled shrimp or apple snails (Fushou snails) are also available.
1. The fish tank is very large, but the power of the filter is not, or the fish tank is small, and the density of fish farming is too large, which will make the water muddy quickly.
Solution: 1. Keep the fish tank away from sunlight and use a fish lamp instead.
2. Change the water once in the morning and evening, and the pumping water each time is one-fifth of the whole.
3. Add a filter to the fish tank.
4. There is a special water filter for fish farming in the market, how to use it: according to the proportion of your fish tank, the body will be evenly sprinkled into the tank, and the filter will be used to filter out impurities.
5. Wipe the inner wall of the fish tank with a cotton cloth regularly.
Chemical removal method: the use of algaecides, the effect is ordinary, the advantage is that it is effective for any algae, and can effectively remove algae attached to aquatic weeds, sunken trees and other places that are not easy to remove. The disadvantage is that depending on the quality, there is a certain degree of impact on the fish and ecological balance.
-
Fish tank water turbidity causes and solutions.
-
There may be the following reasons: 1. The impact of the overflow of the sewer, you can put a piece of biochemical cotton at the impact to make the water "soft landing".
2. The sewer pipe is altogether, and the spiral silencer can be added to the pipe.
3. The water impact on the water surface of the bottom tank can be extended below the water surface or the filter bag can be installed 4. The water impact on the water surface of the main tank can be extended below the water surface or the sound of the water flow from the rain is generally more in several places: 1. The sound of the water flow in the overflow area 2, and the water impact of the sewer pipe on the water surface of the bottom tank.
3. Sewer pipe resonance sound.
4. The return pipe impacts the water surface of the main tank.
The solutions are as follows: 1. Put a piece of biochemical cotton at the impact point.
2. Extend below the water surface or install filter bags.
3. Install a spiral silencer or a sound-absorbing brush.
4. Extend to below the water surface or install rain to get out of the water.
-
It's normal to have sound at such a high distance! It is recommended that you direct the water to the side of the tank or add a pipe to direct it directly to the surface of the water.
-
Clever solution to the big problem of water sound at the bottom of the filter water outlet on the fish tank: use coarse hole ecological sponge strips (fish stores have bought, like coarse sponge-like things, black ones are cut into long strips, and the length is controlled by themselves) Plug them from the downhole, and the lower end hangs into the water. The effect is super good, and the method is simple.
At night, insert the oxygen inlet pipe head on the pump into the fish tank water. It's all silent, and my wife will never talk about it anymore.
-
Add nitrifying bacteria.
To grow nitrifying bacteria, it is important to have enough filter media. You can add some glass rings and biochemical balls to the filter tank to grow nitrifying bacteria.
Nitrifying bacteria can break down fish feces, which is a false statement. Nitrifying bacteria, as the name suggests, are those that carry out nitrification. The process of nitrification oxidizing ammonia into nitrate in water does not make the water clear, but it can reduce the harmful substances in the water, which is helpful for fish and other bacteria.
Fish tank water purifier is a chemical that is harmful to fish and is not recommended to use. Upstairs it is said that nitrifying bacteria are anaerobic bacteria, which is wrong, nitrifying bacteria are aerobic and anaerobic.
Most of the nitrifying bacteria sold outside have little effect, and it is best to cultivate nitrification by yourself.
Nitrifying bacteria are ubiquitous and do not need to be deliberately added.
You can put a tank of water, filter and add oxygen for 24 hours, the light can be dimmed, and you can put the fish in the tank after about a week, and you can add the fish in a few days.
You have already raised fish, only in the filtration add glass rings, biochemical balls, and wait for the nitrification system to form.
-
Even if you have a filter, you need to change the water in the tank regularly, preferably in a third of the tank, and your filter needs to be cleaned regularly and the filter media should be changed regularly to prevent the growth of bacteria.
-
Not so fast!
It won't be clear until the filter is set up!
Solution: 1. If the water in the fish tank is turbid, you can keep the fish tank away from the sunlight and use a fish lamp to irradiate the fish tank. Removing algae from the tank, controlling the number of fish, and reducing the number of fish appropriately will reduce the source of pollution. >>>More
Actually you are overly luxurious, resulting in muddy waters. A submersible pump can muddy the water in the fish tank, and with the addition of an oxygenation pump, it is no wonder that there is so much gas in the water without turning white. No matter how good the water quality is, it can't withstand such tossing and stirring, not to mention fish feces, filter sponges, etc. can be polluted. >>>More
Water is farmed. Ornamental fish.
If the water is not clean and turbid, it will affect the growth and health of aquarium fish, so it is very important to understand why the water in the fish tank is turbid. leads in life. >>>More
<> Ornamental Fish Turbidity in the water quality of ornamental fish is a common problem, and there are many reasons why the water becomes turbid. Before finding out the cause, you also need to save the turbid water quality, so I have compiled six methods for you to refer to. >>>More
1: The first step is to pour out half of the water in the fish tank, if it is a large fish tank, you can scoop it out with a water spoon, and you can use a water hose to export. >>>More