Subject 3 Exam Skills Subject 3 Exam Skills

As long as you usually train seriously, just open it according to your usual training, and open it for a minute during the exam.

All subjects three simulate the use of night lights in the exam, one, pay attention to the close of the window during the exam, there is a car passing by next to the hearing is not clear, hit the wrong light directly hang the subject.

Subject 3 test is a road driving test, to participate in the subject 3 test, first try to go to the test site for practice, familiar with the test site and the location of the broadcast point; When taking the test, be sure to keep a good distance between the cars to give yourself plenty of time to react.

Before taking the subject 3 test, it is best to go to the test venue with the instructor of the driving school to practice more and simulate the test environment, after all, no matter what the test is, practice always makes perfect.

After practicing diligently, you need to calm down during the exam and ensure that you perform normally.

During the test, the most important thing is to keep a distance from the car in front, because the test is basically a computer-based test, so we must make sure that there are fewer vehicles around, so that we can safely perform various operations and pass the subject 3 test.

Finally, the exam should be taken as early as possible, as the darker the day, the greater the impact on novices.

1. Pay attention to the process when getting on the bus to prepare, first report to the examiner, and then request a round-the-car inspection.

2. When starting, follow the order of the light gear brake.

3. Pay attention to control the direction when driving in a straight line. When crossing crosswalks, bus stops, or school areas, be careful to slow down and downshift in advance.

4. Pay attention to finding a good point when pulling over, and would rather lose 10 points than deduct 100 points.

5. Pay attention to slow down in advance when meeting the car.

6. When overtaking, pay attention to the situation in advance and observe the situation in front and behind.

Subject 3 Exam Notes

1. Listen to instructions for the exam.

The subject 3 test has as many as 16 items from the preparation to the end of the test. During the test, you should follow the voice prompts.

Note: The roadside signs are just reminders, and you have to wait for the language to broadcast the action.

2. Relax and look far away, don't be too nervous.

Note: In the straight-line driving test item, due to the fast speed, the direction is easy to deviate, and you must learn to look far ahead, and you must not grasp the steering wheel too hard.

3. Pay attention to road markings and references.

Although the test is conducted on the actual road, there will be corresponding signs in the test area, so you should know the location and the items to be inspected according to the signs. In the area where you pull over, the corresponding dotted line will be drawn on the road surface, and you should operate according to the dotted line, not just by feeling.

4. The gear and speed should match.

In the process of the subject 3 exam, start in 1st gear, but you can't drive at low speed in 1st gear for a long time, you must change the corresponding gear in time and adjust the speed. Remember, accelerate before upshifting and slow down before downshifting.

5. The amplitude of adjusting the steering wheel should be small.

When the speed of the car is high, the steering wheel only needs to be adjusted slightly to change direction. Therefore, it is necessary to grasp the amplitude of the direction of the hit.

6. Pay attention and pay attention to observation.

Subject 3 has high requirements for coordination. During the exam, students must be fully engaged and anticipatory.

Subject 3 exam skills: 1. The speed is slower, and it is no problem to change from 3rd gear to 2nd gear below 25 yards; 2. Slow down early before the traffic light, so as not to turn red before you arrive at the stop line, a little rushed, don't think about rushing over, in addition, when the traffic light flashes, be sure to stop; 3. In case the ignition goes out halfway, you must remember to hang the neutral gear and then ignition, note: 10 points will be deducted for turning off the ignition once, and 100 points will be deducted if it appears again; 4. When pulling over, be sure to keep the right turn signal on until the end of the test

One is to hear the voice and pass the exam! One is to fail the exam, and then the deduction items will be reported; 5. The most important thing, people who have not gone to the simulation must not know, after the test is parked, that is, you are sure that your position is parked, you must keep stepping on the foot brake, pull the handbrake up, and then hang the neutral gear, and then release the foot brake after hearing the test, otherwise the system is prone to problems, of course, you have no problems, you are lucky.

1. Go around the car

After hearing the voice of "passing in front of the car and passing behind the car", the trainees observe the surrounding environment of the vehicle and confirm that it is safe before getting on the bus.

2. Get on the bus and prepare

Once in the car, pay attention to whether the doors are completely closed. Then adjust the seats, adjust the rearview mirrors, and pull the seat belts. In this process, the clutch, accelerator, and brake can be sensed by pedaling.

3. Simulate lighting

After getting in the car, check whether the lights are reset, listen carefully to the voice before making an action, do not grab the voice, it is recommended that the voice broadcast ends for 1 second and then react to do the light action. Now that the lighting exam is over, reset all the lights and get ready to get started.

Fourth, get started

More than 80% of the students started to turn off because they were nervous, lifted the clutch too fast, or forgot to let go of the handbrake. Students can use the following mantras to get started, and it is not easy to miss the operation.

Prepare to start which destroy grip to hang a gear, turn on the left light before the car moves;

Sound the horn and then release the handbrake, and the start must be semi-linked;

The car can be turned to the second gear, and the throttle of the second gear is slightly heavier;

Turn off the lights and turn to third gear, the throttle is heavier in third gear;

Increase the speed of the car to four gears, four or five high-speed shifts quickly;

The clutch of the two feet must be distinct, and the standardized movements must be remembered.

5. Drive in a straight line

The main breakthrough direction deviation problem: Li Qing.

1. Control the speed before driving in a straight line, and the uniform speed is the best;

2. Look at the distance ahead, the farther the line of sight, the less likely it is to deviate, so that the vehicle keeps going straight;

3. Control the steering wheel, adjust it in time, and adjust the action lightly and the amplitude is small.

6. Accelerate downshifting

Section 3 speed gear recommendation: speed 10 30 kilometers per hour, second gear; speed 20 40 km/h, three gears; At a speed of more than 40 kilometers per hour, you can hang fourth gear and fifth gear until the end of the course.

2. Shift the clutch to the end, and the direction does not deviate.

Be careful not to look down at the gear when changing gears, and control the steering wheel with your left hand.

7. Observe and slow down at intersections

1. Observation. The exam requires you to swing your head from side to side, not a mechanical movement, and pay attention to the left and right sides'How the vehicle is driven. This can affect actions such as making a U-turn, entering an intersection, etc.

2. Deceleration. Go straight through the school area, through the bus stop, through the crosswalk, go straight ahead, and then enter the section to control the speed within 30 yards, and in the examination room with a lot of vehicles, you can slow down when you encounter obstacles, let other vehicles go first, or even stop, and then start again.

8. Pull over

1. Turn on the right turn signal after hearing the voice prompt;

2. Decelerate and reduce gears in advance, find the right parking position (no other vehicles obstruct you) and stop to the right;

3. When the right side of the body is less than 30 cm away from the roadside, stop the vehicle after parking and tighten the handbrake in neutral gear, and get out of the car after the engine is completely stopped;

4. When you don't hear the instruction to "pass the exam", don't unbuckle your seat belt and get out of the car.

The techniques for the subject 3 exam are as follows:

1. Keep in mind the steps of the start-up operation.

The start seems simple, but the operation steps are not in place, and the points will be deducted at the lightest, and the course will be failed at the worst. Fasten your seatbelt when you get in the car, and not wearing a seatbelt is a big hanging.

The first step in starting the vehicle is to step on the clutch to the end, then hang a gear, then press the horn, followed by the turn signal, observe the left and right rearview mirrors to confirm safety, and slowly release the clutch to the vehicle when the vehicle shakes violently, release the handbrake and start steadily, the sequence of each step can not be wrong.

2. Shift gears smoothly.

The shift in the third section is a frequent operation, and if the shift is unstable, the vehicle is prone to shake or deviate, which is the hanging point. If you want to shift gears smoothly, one is to switch gears skillfully and quickly, and the other is to hold the steering wheel steadily, and it is recommended to develop the habit of "the left hand is the main, the right hand is supplemented". In addition, you can't look down in the process of switching gears, otherwise you will directly fail the exam.

3. Don't forget the turn signal.

We all know that the turn signal in subject 3 is an important assessment point, in the start, U-turn, turn, lane change, overtaking and other items must be timely hit with the turn signal, and turn on the turn signal to keep more than 3s before the steering operation.

4. Don't be lax when you pull over.

Pulling over is the last step in the subject 3 exam, and many students think that they will win the exam in this step, so they will be careless and fail as a result.

In fact, there are quite a lot of assessment points for pulling over, when you hear the system issuing the instruction to pull over, first turn on the turn signal, step on the brakes to slow down, reduce the speed to within the second gear, find the parking position, slowly cut into the parking space, ensure that the distance between the body and the library line is 30 cm when parking, pull the handbrake after parking, hang back to neutral gear, and turn off the turn signal.

5. Listen to the voice in the lighting test.

Once you get on the bus, always check first and make sure all the lights are off. In the process of the lighting test, listen carefully to the voice broadcast instructions, after the voice broadcast is over, turn on the correct lights as required within 5s, and turn off all lights after the test. Note that in the process of lighting the test, you can't grab the password operation, otherwise the computer will not be able to recognize it, and points will be deducted.

The third item we must attach great importance to, we must usually strengthen training, so that we know in our hearts, and only then can we have self-confidence when taking the exam, and at the same time the thinking must be clear when taking the exam, do not be disturbed by external factors, and operate according to the method taught by the coach.