Subject 3 Exam Process, Subject 3 Exam Steps

The whole process of taking Subject 3

Get on the bus and prepare, start the vehicle, drive in a straight line, add and decrease gears, change lanes, pass through traffic light intersections, make left and right turns, pass through pedestrian crossings, pass school areas, bus stops, meet cars, overtake, make a U-turn, pull over.

Step 1: During the subject 3 test, before getting on the bus, no matter where the candidate is in the vehicle, be sure to walk from the right side of the car around the front of the car to the cab door, first observe whether there is an obstacle on the road in front of the car, and then observe whether there is an oncoming car behind the car, after ensuring safety, open the door and get on the car.

Step 2: After the first step is completed, gently close the car door, hand the pre-prepared ID card to the examiner with both hands, and introduce yourself with a smile. Treat the examiner as kindly as possible.

Step 3: Before the start of the road test, there is another step in the preparation is to adjust the car facilities, as far as possible to quickly adjust the seats, the left and right 3 rear mirrors, fasten the seat belt, observe the instrument, if the instrument is normal, smile and ask the examiner for advice: "Report to the examiner, the instrument is normal, can I start?"

Step 4: After getting the permission of the examiner of subject 3, step on the clutch, hang 1st gear, hit the left turn signal, press the horn, observe the rearview mirror, confirm the safety, release the clutch to semi-linkage, and release the handbrake at the same time with the right hand (which can effectively prevent the uphill start from slipping), and start smoothly.

Step 5: After a smooth start, don't be in a hurry to change lanes to the left immediately, continue to go straight, turn off the left turn signal at the same time, step on the clutch, shift to 2nd gear (you can use 1st gear to climb to the top of the slope and then shift gears when starting on a steep slope), slow down and loosen the clutch, and give a little throttle with your right foot at the same time to prevent rushing or stalling. Refueling keeps 2nd gear forward, observe that the speedometer reaches more than 30 kilometers or the engine speed exceeds 2000, shift to 3rd gear, keep driving at 30 speeds, if the examiner does not ask for acceleration, there is no need to accelerate.

While you're on the road, don't forget to look in the rearview mirror every 10 seconds or so.

Step 6: During the road test, when you hear the command of "pull over", do not panic, the first reaction is to hit the right turn signal, and then make an obvious deflection action to look at the right rearview mirror, if there is no vehicle behind the right, please hit the direction to the right, and at the same time step on the brake, the left foot clutch is also stepped on, with the feeling of parking at a fixed point to make the car 30cm away from the right curb, back to the right direction, park the car on the side of the road.

Step 7: After the vehicle is stopped, pull the handbrake, dial back to neutral, release the clutch brake with both feet, turn off the right turn signal, release the seat belt, face the examiner and say, "Thank you, examiner", then look at the left mirror, confirm that there is no car coming from behind, open the door, and get out of the car.

After getting out of the car, gently close the door with both hands and say "thank you, examiner" again.

The whole process of the subject 3 exam, the students in the subject 3 exam room click to see if it will be helpful for your subject 3 exam.

Subject 3: The first item is lighting, and the second item is road driving skills.

Subject 3 Exam Process Official Version.

The whole process of taking Subject 3

Get on the bus and prepare, the vehicle starts, drives in a straight line, adds and lowers gears, changes lanes, searches and buries through the red and green Shimin light intersection, makes left and right turns, passes through pedestrian crossings, passes through school areas, bus stops, picks up potatoes, overtakes, U-turns, and pulls over.

1. When taking the driver's license, the second subject is the most rare that is, the third subject, before getting on the car, you must walk around the test car, mainly to observe whether there are obstacles on the road in front of the car, whether the door and trunk are closed;

2. After the inspection, get on the bus and close the door, and hand the documents prepared in advance to the examiner;

3. Adjust the car facilities, including the seats, the left and right 3 rearview mirrors, fasten the seat belt, observe the instrument, and conduct the lighting test after checking that there is no problem;

4. During the test light, the examiner will also score according to your operations, and then notify you to start. Step on the fire, hang 1st gear, hit the left turn signal, observe the rearview mirror, confirm the safety, let go of the handbrake, release the clutch to semi-linkage, and start steadily.

5. After a smooth start, continue to go straight and turn off the left turn signal, shift to 2nd gear, refuel to keep 2nd gear forward, observe the speedometer to reach more than 30 kilometers or the engine speed exceeds 2000, shift to 3rd gear, keep 30 speeds, don't forget to look at the rearview mirror every 10 seconds, when there is a sidewalk zebra crossing, be sure to gently step on the brakes, just have a little sense of pause, don't step to death.

6. When you hear the command of "pull over", hit the right turn signal, and then do an obvious deflection action to look at the right rearview mirror, if there is no vehicle behind the right, drive to the side of the road, slowly step on the fire and brakes, when the car is 30cm away from the right curb, park the car on the side of the road.

7. After the vehicle is stopped, you must pull the handbrake, turn the gear back to neutral, release the clutch brake with both feet, turn off the right turn signal, loosen the seat belt, if you pass the exam, the examiner will give you the results on the spot, say thank you to the examiner when you get the results, and then observe the left mirror, confirm that there is no car coming from the rear, open the door, and get out of the car.

Subject 3 Exam Full Steps:

1. Get on the bus and prepare.

First, go around the car, observe the road conditions behind you and the bottom of the car, and press the sensor buttons on the car in turn. Then open the door, adjust the angle of the seat and rearview mirror first, and fasten the seat belt. Remember to empty the instrument panel, lights, gears, and handbrake before starting the test.

2. Simulation of the light of the night lamp.

Voice commands appear randomly and in no fixed order. The operation must be carried out after the command is started, and all lights must be reset and turned off 5 seconds after the command to turn off the lights.

3. Get started. Press the clutch deeply - hang the first gear - hit the left steering - press the horn (for 3 seconds) - let go of the handbrake, look back and reconfirm and start safely.

4. Drive in a straight line.

When the speed reaches 10-20km h, hang 2nd gear; When it reaches 20-30km h, it hangs 3rd gear, and when it reaches 30-40km h, it hangs 4th gear. Keep your eyes straight ahead, switch gears smoothly, don't look down at gear, and don't shake the body.

5. Change lanes. Before changing lanes, turn back fully to observe the traffic coming from behind, turn on the turn signal first, and then change lanes if you confirm that it will not affect the driving of other vehicles. Remember that you can only cross one lane at a time.

6. Pass through the intersection.

Slow down and downshift within 30 meters of the intersection. Drive the vehicle to the corresponding direction lane. If you encounter a red light, you need to stop within the stop line or keep a safe distance of about one meter from the vehicle in front. Remember to steer when turning, observe the left and right oncoming vehicles, and control the gear in second gear and below.

7. Meet the car. When the road conditions are normal, it is enough to keep a safe distance from the oncoming traffic, and when the road conditions are difficult, you should take the initiative to give way to the side of the road.

8. Overtaking. Remember that overtaking can only be done from the left. Before overtaking, turn back to see if there is an oncoming vehicle behind you, turn on the left turn signal in advance, and honk the horn (at night, you can alternately use high and low beams to indicate the vehicle in front) for 3 seconds.

When overtaking, pay attention to the distance from the overtaken vehicle through the rearview mirror. Wait until you have a safe distance, look back and make sure everything is correct, then drive back to the original lane.

9. Make a U-turn. Remember to turn on the left turn signal before making a U-turn, choose a suitable U-turn location, and then slow down and downshift. If you don't have a chance to make a U-turn, you will need to stop and wait.

As soon as the right time comes, look back and make sure it's safe, and then kill the steering wheel immediately. When the front of the car crosses the lane marking, quickly return to the right steering wheel. Make sure that the left turn signal does not go off (press lightly with your finger) at all times when making a U-turn.

10. Pass sidewalks, bus stops, and schools.

Pay attention to the roadside signage and slow down and downshift within 30 meters of the test area. Observe left and right sufficiently, and stop and give way if necessary. Do not honk your horn when passing through schools and residential areas; The speed of the vehicle passing through the school must not exceed 30 m h.

11. Pull over.

When you hear the command, turn on the right turn signal and press the brake to slow down and downshift. Turn around and check the condition of the car behind you to make sure it's safe. Hit the right direction.

In the process of leaning to the right, when the curb stone coincides with the right side of the front cover of the car 1 3, return to the right direction, and slow down to stop. Pull the handbrake, return to neutral, release the clutch, release the brake, turn off the turn signal, and turn off.