5700 memory card problems, 5700 phone memory card problems

This situation indicates that your card is broken. I can't read it with a card reader. If your phone is under warranty, it will fall back to the manufacturer and give you a new card. If not, go buy a new card.

The memory card that comes with the 5700 is very brittle.

First of all, change the phone and try to repair (check the error) and defragment the memory card.

Try it with a USB flash drive or MMC Medic.

If it doesn't work, don't be busy, just change it. My small 7 card also didn't solve this problem for a long time, and I still spent dozens of dollars to buy a new one (Kingston's).

Don't pull out the memory card too often, it's best to use Bluetooth for transmission, or use a data cable. I used to do this often, once also prompted that the memory card was damaged, I wiped the memory card with alcohol, and when the memory card was inserted, I blew in the card slot (blow hard), and it was fine. It is best to check the card on the mobile phone, unplug the SIM card, and enter it in the standby state.

,Enter the secrecy and reboot it.。

If it doesn't work again, let some blood and change the card.

I'm not a master, but also a person who loves to play machines, and often uses very dirty methods to solve problems, I hope your phone will return to normal as soon as possible.

Hehe. I think there is a problem with the mobile phone card reading. Poisoning is impossible. I'd recommend backing it up now. In formatting. Formatting, remember to hard, soft. Thorough!!

Since it was bought in a specialty store, and it was a card problem, you can bring the shopping voucher to the staff there to change it.

The problem is simple: the memory card is in poor contact with the phone!

Words can't solve this kind of problem!

Suggestion: Go to customer service to explain the situation! They'll take care of it for you!

If you don't have a warranty, then Nokia customer service is free! But the premise is: you can't repair it in a small shop outside, once you go to the non-customer service department to repair it, Nokia customer service will refuse the warranty! Including canceling any service in the customer service!

The occurrence of "memory card removal" is estimated to be due to poor contact between the memory card and the machine.

That is, the place where the memory card and the mobile phone are in contact is not good, it is estimated that it is a problem with the card, you can use a friend's card to see if there is such a situation!

Caused by poor contact! Wash your gold finger with alcohol! It's a golden conductive strip!

If it doesn't work, the internal contact is not good, go to the after-sales service to repair it for free!

Hearing you say this, it is most likely caused by poor contact of the memory card contact points.

You take out the memory card first, use an eraser to clean the metal contact part a few times, and then put it in and try it.

Free Warranty This should be a problem with stuck points

100% is a card issue! That's how my machine turned out! Change your card and you'll be fine!

You won't have a problem with a new machine! Isn't your card original?

It is recommended to use someone else's card. If this problem still occurs, it is recommended to go to the after-sales service to re-flash the system.

There are limits to using Bluetooth to transfer things.

The receiving party's mobile phone cannot receive something larger than the phone's own memory.

Because the transferred files are first temporarily saved in the phone's built-in memory.

If the card is broken, whether it is a program or a file, it cannot be read normally. So it should be a system issue. It is highly recommended to back up important data and format the card and phone together.

60 of the systems installed with conflicting files will cause system problems. Said the little problem.

Yours is a miscellaneous card, right? Change one first. The operating system is in the ROM, and the probability of problems is negligible.

It's just that the card is broken. The pronunciation dictionary is universal, and the N95 dictionary N73 can be used as well. It could be a bad area on the card, or a fragment.

You look it up and see if there's any debris. It is still recommended that you change the card, and now the 2G is only a few dozen yuan, Kingston's.

The card that was sent... It's not the best to change the original machine.。。。 I don't have much money, so I'm just slow for you to deposit things in the card, I guess it's a rough card.

The card is not broken, I used to be like this, the file corruption is the problem of that file, either the format is wrong, or there is a program missing in it that can be opened... Sometimes others can use it, but the model is not right and can't be used

Use the computer grid first, then the mobile phone grid. ok

It is possible that the memory card has a password added, try to delete the password

My answer is your machine's question. You have a bezel on the memory card, and when you remove the bezel, the program will shut down (normally) and your machine may be burned or detached because the little switch you have installed inside the bezel burns or falls off. Memory cards rarely burn out.

You'd better try the memory card first. When you're sure your card is okay, there's a good chance you're broken.

You don't need to use the card, this is basically poisoned, your folder is hidden by a virus, and the poison or tool is killed on the computer.

Folder Options - View.

Display all files and folders, and you can see the hidden files.

Wipe the contact port of the memory card with a flannel cloth first, and then try it with a card reader, if it is not a bad contact, it should be formatted.

Hehe. I think there is a problem with the mobile phone card reading. Poisoning is impossible. I'd recommend backing it up now. In formatting. Formatting, remember to hard, soft. Thorough!!

There is no way, you can try to rub the metal connector with a rubber rubber, the joint is dirty, or something will block it. If it still doesn't work, format it.

It can only be that the memory card is corrupted.

It has nothing to do with **. Since the computer doesn't recognize it, it's already a problem.

Previously Cali stuff couldn't be saved.

You can put it in another phone and try it.

Mine is the same thing.

The 5700 really works.

Mine is right now.

Hehe、If you can't, you can get a card.。

Save the information in your card, format the card, and it's out!

If it is still dead, put the mobile phone on the grid, save the data first, and when the method is standby, enter *, and then enter the password 12345,

I formatted the memory card, but then everything was gone.

If there is no backup 5700 original factory backup, the intelligence is downloaded from the Internet, and then to the stored value card.

The memory card is burned, let's replace it.

This card is equal to half a waste card! Set the password can only be read and written by the machine, other mobile phones and card readers connected to the computer can not read, either find a professional to crack, or spend money to buy a one, I only bought a Kingston 35 yuan 2g last week. Don't just put on a password in the future!

Use unlocking software to solve it, but you may encounter data loss, depending on whether what you have in it is important or not.

Khan, I guess I can only buy a new one, but fortunately, the memory card is not expensive now.

1You can see the text message when you install the PC suite, the general text message content is in the memory of the mobile phone, and the file is encrypted and cannot be found. 2** in vedio**In images

**In music3. The grid machine should back up the SMS ** number, delete some unused software in advance or there will be no residue, it is necessary to back up some software, and the things in the grid card will not be missing.

Text messages are generally in the phone.