Which interface should the optical drive be connected to?

Built-in optical drives should generally be connected to the IDE interface.

As an important device for disc reading, a computer optical drive is indispensable on every computer. However, many people are confused about how to properly wire optical drives when building a computer or replacing hardware. The following will introduce the wiring method of the computer optical drive.

1. Check the motherboard.

First of all, we need to check the type of interface on the motherboard, because the interface between the optical drive and the motherboard will have different specifications, such as IDE interface and SATA interface. Among them, the IDE interface is abandoned to the new motherboard, and the old IDE motherboard on computers in the 90s should be chosen.

2. Prepare the data cable.

After confirming the type of motherboard interface, we need to prepare a suitable data cable. Most of the time, when you buy an optical drive, you will come with a data cable, and if you don't have it, you need to take it to the store and buy it. If you want to use an ATA drive, you need to use a SATA cable, and if you are an IDE drive, you need to use an IDE cable.

3. Wiring. Now that we have the data cable ready, we can connect the optical drive to the motherboard interface. The wiring steps are as follows:

1.Find the seat of the optical drive on the front of the main chassis, open the optical drive panel, insert the optical drive into the card slot and fix it.

2.Connect the data cable to the motherboard and optical drive. Depending on the type of optical drive interface, select the appropriate data cable (SATA or IDE).

There are two interfaces for the data cable connected to the optical drive, one is connected to the optical drive, and the other is connected to the motherboard; The IDE cable has three ports, the middle one connects to the optical drive, and the two sides connect one to the motherboard and the other to the hard disk (if used at the same time).

4.If the power supply has a SATA head, connect the SATA cable to the optical drive. If the power supply does not have a SATA head, you can use a Molex to SATA cable and connect the optical drive.

5.Install the lid and screws of the computer chassis, and the wiring of the optical drive is completed.

In short, the above are the steps and methods of computer optical drive wiring. When operating, it is important to pay attention to the selection of the correct data cable and interface, and to follow the correct steps to avoid unnecessary problems. If you are still confused, you can always seek help and advice from some experienced people.

The wiring method of the computer optical drive needs to open the host, check whether there is a long strip on the motherboard of the host, with multiple pins on it, and then the optical drive cable needs to be aligned with the corresponding pins before it can be inserted smoothly, so that the optical drive can be started normally and read the disc.

1. The optical drive interface is an excuse for the optical drive and motherboard in the notebook or desktop computer, which can drive the digital process. If we take the official launch of CD DA to the market in 1982 as the benchmark, the development process of the tourism storage industry is not a quick word. CD DA, or Laser Digital Disc, has been around the world since its inception.

2. The hard disk interface is the connection between the hard disk and the host system, and its function is to transfer data between the hard disk cache and the host memory. Different hard disk interfaces determine the connection speed between the hard disk and the computer, and in the whole system, the quality of the hard disk interface directly affects the speed of the program and the performance of the system. From a holistic perspective, there are four types of hard disk interfaces: IDE, SATA, SCSI, and Fibre Channel.

Yes, the IDE era is the same, the power port of the same IDE port, and the SATA era is also the same, but the physical appearance of the optical drive interface of the notebook is different, and it is made into an integrated head, but it still runs the same protocol as the hard disk, and it can be converted to the same interface with a conversion cable.

Share computer maintenance experience, expand chip-level maintenance knowledge, and improve your overall maintenance skills.

Both the optical drive and the hard disk have two interfaces: IDE and SATA.