How to cross the restrictions of Netcom, and set user access restrictions

Add your IP to free monitoring, or use **.

If this function can't be realized, there is no need to do online behavior management. Create a user, write the username, IP also, and don't write anything else. Create a custom category, write what you need, and look at the question mark in the upper right corner for formatting.

Then build a web browsing policy, select the user who belongs to the new user, **category does not belong to the newly built**, and control the action blocking. Check off the records as well to make it easier to troubleshoot when there is a problem.

Don't think about cracking it, the phone can't get on the network may be because of the network management bar your BYOD is banned, the only way is for you to get the password of the network health device, if you know the management address of the network health You can try a username: ns25000 password: ns25000

This is the default setting of the factory of Wangkang.,The general administrator is too lazy to change it.。。。 Because I'm just doing Netkang, when I go out to distribute equipment, the customer doesn't ask for it, but the password won't move!

DNS tunnels and encrypted tunnels.

Even the "great wall" can be turned, and the net is counted as the green onion!

Remember one sentence: there is no wall in the world that cannot be climbed!

It's very difficult to crack the phone, you can change the IP, iOS and Android.

There's no good way, take a look at the software that was forcibly uninstalled with some of it, and he uninstalled it.

Using Cheetah WiFi and then enabling NAT mode can bypass NetKang's online behavior management restrictions.

NetHealth Internet Behavior Management provides network managers with identity authentication, compliance access, web page filtering, application control, bandwidth management, content auditing, outgoing filtering, behavior analysis and other functions of various Internet access environments, and restricts the access of multiple Internet devices from the hardware port, so it can only use NAT dynamic address translation technology to turn multi-channel network communication into one.

NAT works with the help of NAT, a private (reserved) address"Interior"When the network sends data packets through the router, the private address is converted into a legitimate IP address, and a LAN only needs to use a small number of IP addresses (or even one) to realize the communication needs of all computers in the private address network with the Internet.

The default initial password of the hotspot is admin;

2.Users can set their own WiFi hotspot name and password;

3.To know the password on the wireless hotspot router, you can ask the person who set it up;

After the behavior management device limits the network speed of 100k, it is normal to open web pages very slowly, and this rate is almost equivalent to narrowband, which is the kind of bandwidth that was dialed up with a 56k cat when there was no broadband many years ago. If you want to access the Internet normally, you must enable at least a few megabytes of bandwidth (100K equals megabytes).

Enter the IP address, enter the correct username and administrative password.

The username and password of the Netcom device is decentralized, so you must have the username and password of the setting function.

Are you **? Shanghai?

It's the same as a router, you can log in with an IP address.

The hardware maintenance cost is high, there are many problems, and the monitoring is not perfect, it is best to use software, you can use WinShield intranet management software.

You can call Netcom 400** for consultation.

Create a temporary user group, and make a strategy to block this group, or you can call Wangkang's 400 after-sales service.

Freeze directly or the previous policy.