How to prepare the water for blowing bubbles, how to prepare for blowing bubble water

Enthusiastic Friends 2009-03-14

Bubble Blowing Solution Recipe Large Collection Optimal Formula for Blowing Bubble Solution: 2 parts detergent, 6 parts water and 1 part glycerol 4 parts glycerin. Reasons for Bubble Colorful:

Light is refracted at both the top and bottom of the film as it passes through the film of the soap bubble, which can contain up to about 150 different layers. The messy color combinations we see are caused by unbalanced layers of film. The last film layer reflects red light, the thinnest reflects violet light, and the center reflects colorful light.

Causes of bubble formation: Bubbles are formed due to the surface tension of water. This tension is the mutual traction force that exists inside the object and is perpendicular to the contact surface of two adjacent parts when it is subjected to a tensile force.

The mutual attraction between water molecules on the surface of the water is stronger than the attraction between water molecules and air. These water molecules are like being glued to a beggar. However, if the water molecules are overly bonded to each other, bubbles will not be easy to form.

The soap "breaks" the surface tension of the water, reducing it to only 1 3 under normal conditions, which is the optimal tension required to blow bubbles. The method of slowing down the disappearance of bubbles: the evaporation of water is very fast, when the water evaporates, the surface of the bubbles is broken, and the bubbles disappear, therefore, some substances must be added to the bubble solution to prevent the evaporation of water, and this kind of substance with water-collecting properties is called hygroscopic.

Glycerin is a hygroscopic liquid that forms a weak chemical bond with water, which slows down the evaporation of water. The use of soapy water will affect the effect of blowing bubbles. Generally, soapy water made with 2 parts of dishwashing concentrate and 6 parts of water can be used.

To make the bubbles last, change the recipe to 2 parts dishwashing detergent plus 6 parts water and 1 to 4 parts glycerin. I first poured a little glycerin into the water, then poured some laundry detergent, stirred quickly, detergent (laundry detergent) added water and put in a little salt, or glycerin, it became bubble water Foam bath gel + water + honey You can try it Method 1: glue + wash + water, the ratio is 1:

2:3 Method 2: Soap, hot water, colored ink (to add color) Mix one part liquid soap, 1 part glycerin, and 6 parts water together to make your own bubble water In daily life, there are many materials that can be made into water for blowing bubbles, such as:

Chop the soap and dissolve it in water, or you can add water with dishwashing detergent or shampoo. Experiments have proved that adding three solutions of soapy water, dishwashing detergent and shampoo with a relatively high concentration can make the bubbles blown out more durable and not easy to break. Another way is to:

Add a small spoon of granulated sugar or a little tea leaves to the soapy water and leave it in a dark place overnight, and you will find that the bubbles blown by this soapy water are not only bright in color, but also less likely to burst.

water, dish soap, or soapy water.

The simple recipe for children's blowing bubble water is as follows:Prepare materials: toothpaste, water, detergent.

The first step is to pour the prepared water into the glassware, as shown in the figure below

Step 2: Then pour some toothpaste into the poured water, as shown in the picture below

Step 3: Pour in a little more detergent, as shown in the picture below

The fourth step and the final stirring can be completed, as shown in the following figure:

1. The first step is to make tea. Pour the tea leaves into a cup, brew the tea with hot water, cover and steep for a while. The tea leaves are then strained out, leaving only the tea.

2. In the second step, the soaking water is mixed with the tomato. Place dish soap and a teaspoon of sugar in a container and stir well. Then pour in the prepared tea water. The ratio of dish soap to tea is one to three.

3. The third step, cooling. Shake the bubble water well and wait for the water to cool.

4. The fourth step is bottling. Put the prepared sparkling water into the prepared small bottle.

5. After filling the bottle, you can take the bubble blowing tool and go outdoors to blow bubbles.

Cut the soap into thin slices and put it in a cup, melt the soap flakes with hot water, then add a small amount of granulated sugar and a bag of tea to the cup, cover the lid and leave it overnight. Add 1-2 tablespoons of sugar to an empty cup, pour in an appropriate amount of detergent and tea, and stir with chopsticks. Place dish soap, shampoo or hand sanitizer, water, glue as per 2:

The ratio of 2:4:1 can be adjusted.

Add one-third of dish soap and half a tablespoon of sugar to a glass of water and stir. <

1. Cut the soap into thin slices and put it in a cup, melt the fertilizer soap flakes with hot water, then add a small amount of sugar and a bag of tea to the cup, cover the lid and leave it overnight.

2. Add 1-2 tablespoons of sugar to an empty cup, pour in an appropriate amount of detergent and tea, and stir it with chopsticks.

3. Mix dish soap, shampoo or hand sanitizer, water and glue according to the ratio of 2:2:4:1.

4. Add one-third of dish soap and half a spoon of sugar to a glass of water and stir.

Recipe for bubble water.

One: Ingredients: 2 cups, 1 bag of tea, sugar, boiling water, detergent Method:

1. Take a cup and pour boiling water into it, put it in a tea bag 2. Add 1-2 tablespoons of sugar to an empty cup, pour in some detergent, pour in tea, and stir it with chopsticks.

2: 1. Cut the soap into small slices and put them in a cup, and rinse into the hot water to dissolve the soap flakes. 2. Add an appropriate amount of granulated sugar and a bag of tea to the cup, cover the lid and leave it overnight.

Three: Stir 1 cup of water, 1 3 cups of dish soap, and half a spoon of sugar. This is a proven formula. Unlike the bubble water sold outside, it has a pungent smell and is safe.

Four: Add a little vinegar with dish soap, as long as the concentration of dish soap is enough, the effect is also good.

Five: Use black tea water with fragrant soap and a little sugar, soak it for one night, and the bubbles blown out of this water are big and not easy to break.

Six: Glue: Water:

Dish soap: hand sanitizer (or shampoo) = 1:4:

2:2, the effect is very good, you can also add sugar, increase the effect with blue ink, according to this recipe is easy to succeed, if you use pearlescent hand sanitizer or shampoo bubble color is better, if you add a little sugar and vinegar, the bubble is not easy to break.