What should I pay attention to when using direct drinking water equipment?

The following is an introduction to the precautions for the use of the Fountain of Youth.

1. Raw water: The inlet water source should meet the standards when designing direct drinking water equipment.

2. Power supply: direct drinking water equipment is used in places where the power supply is stable, if the power supply is unstable, it will have a very adverse impact on the system function, and the main board of the system will be burned in serious cases, resulting in the disorder of the working state of the whole system.

3. Installation site: Direct drinking water equipment should be installed in a ventilated and dry area to avoid direct sunlight.

4. Maintenance during use: Consumables should be replaced according to the periodic table provided by the first supplier during the use of the direct drinking water equipment, and pay attention to the system alarm prompt, even if the maintenance and problem are solved.

5. In the process of daily use: should be used continuously as much as possible to avoid frequent start and stop, to maintain the normal power supply and water source, if it has to be stopped for a long time due to special reasons, be sure to refer to the direct drinking water equipment shutdown protection operation method for accurate implementation.

Precautions for direct drinking water equipment:

1. The equipment installation site should be flat, the environment should be clean and tidy, and it should be close to the power supply and water source.

2. Do not go near the fire source and any heating element.

3. The equipment shall not be installed outdoors in the northern region to prevent the equipment from freezing inside and damaging the instrument and filter elements.

4. The installation position of the equipment should be convenient for drainage, so that the drainage pipe of the equipment can be kept smooth.

5. The working pressure of the pump used in the system is ensured, and the working pressure of the pump used in the secondary membrane is ensured. to ensure that the pump works within its rated head.

First, look at the product positioning.

When choosing a manufacturer, it is necessary to look at the best positioning of different manufacturers on water dispenser products. If it is higher than the market positioning or beyond your own purchase budget, then such water dispenser equipment products are generally not recommended to buy. On the contrary, if the positioning is very pertinent under the condition of ensuring quality, such a water dispenser equipment is worth starting.

Second, look at the after-sales service of the product.

When choosing a corporate water dispenser manufacturer, the after-sales service of the product is also very important. If the after-sales service is not very stable, at the time of purchase, the quality problem can not be solved, which will not only increase the purchase budget, but also reduce the cost performance. On the contrary, if the after-sales service is very perfect, you can give priority to such enterprise water dispenser manufacturers.

Third, look at product quality control.

High-quality enterprise water dispenser manufacturers can provide high-quality water dispenser equipment products, and when purchasing, such water dispenser manufacturers and equipment products can be given priority. However, if the quality is unstable, even if the ** positioning is lower, it is not recommended for everyone to buy and use.

1. Improve the taste and improve the quality of drinking water.

The direct drinking water boiler has a purification function, and the purified water removes impurities and peculiar smells, and the water quality is good, and there is a fresh and sweet feeling after drinking. The good taste makes the direct drinking water machine a favorite of many consumers. The direct drinking water boiler has a built-in advanced purified water filter, and the filtered water meets the standard of direct drinking water.

The direct drinking water machine adopts RO reverse osmosis membrane filtration treatment, and the treated purified water is fresher, safer and more hygienic than bottled water, which is also one of the greater benefits of the direct drinking water machine. First of all, the filter element of the direct drinking water machine can not be discharged, and the life is relatively short, of which the life of PP cotton is sold for 3-6 months (according to the local water quality), the life of activated carbon is about half a year, and the life of ultrafiltration is about 1 year; The water output is small, generally only suitable for drinking, and the market ** is not low; At present, most of the direct drinking machines on the market are more beautiful and generous.

Second, reduce the company's costs.

In the past, the general unit or household drinking water was water from the water dispenser, or water boiled by itself. If you boil water by yourself, it will consume electricity or energy, and it will be a lot of money for a long time. The direct drinking water boiler has both heating and refrigeration functions on the ordinary water dispenser and is more powerful than the function, connecting the tap water can produce direct drinking water, drinking how much to produce, its big highlight is that the direct drinking water equipment adopts heat exchange technology, saving more than 80% of electricity compared with the water dispenser, and you can save one, or even a few dollars to buy a machine a year, saving consumers a lot of long-term drinking water investment.

3. Safe and convenient.

The direct drinking water boiler has a strong water supply capacity, and if you want to drink hot boiled water and warm boiled water, as long as the temperature is enough, you can drink it at any time, which is simple and convenient. When the direct drinking water machine encounters dangerous conditions such as electricity leakage, it will automatically cut off the power, making it safer to use.

Direct drinking water boiler brings safe and healthy direct drinking water to people, but now the drinking fountain on the market is still very complicated, many people can not distinguish the difference between direct drinking water boiler and other drinking water devices, I hope that when you buy a water boiler, you can make preparations in advance to prevent buying an unsuitable water dispenser.

First of all, the filter direct drinking water machine can solve the problem of secondary pollution of tap water.

Tap water contains substances that are harmful to the human body, and it is susceptible to secondary pollution, so people generally boil it before drinking, but boiling can only solve the problem of bacteria, but can not solve the problems of sediment, rust, heavy metals, volatile substances and bacterial "corpses" contained in the water, these potential factors will cause serious hidden dangers to health.

Second, filtered direct drinking water dispensers are the best choice to replace bottled water.

A bucket of bottled water ranges from 8 to 16 yuan, the cost is high, and a considerable proportion of this water is tap water processed by large water dispensers or pure water machines, and there is very little natural mineral water; At the same time, the bottled water has a short shelf life, and it is in an open state after being connected to the water dispenser, which is easy to be polluted by pollutants in the air, so it is not an ideal drinking water solution.

Thirdly, the scumbag filtered direct drinking water machine is not as expensive as bottled water.

Bottled water is listed as daily water by a few wealthy families, but its cost is too high, and its effect may not be as good as that of filtered water dispensers.

Fourth, the filtered direct drinking water machine meets the standard of raw drinking and the cost is low.

The filtered water dispenser can effectively separate and remove all kinds of pollutants, and the water has a good taste, good water quality, can meet the standard of direct drinking, safe and healthy, and is the most ideal drinking water solution.

When using a water dispenser, you should also consider various things, such as drinking water safety. What are the precautions for using water dispensers? PChouse will take you to find out.

1. The water dispenser should be placed 10 cm away from the wall, and the ventilation and heat dissipation can be guaranteed. Avoid direct sunlight and away from heat sources so as not to affect the taste of drinking water.

2. The hot and cold water faucets of the water dispenser should be used alternately to ensure the smooth flow of drinking water and prevent the use of a single faucet, resulting in poor water flow in the machine.

3. Before plugging the bottled water into the water dispenser, the protective film of the outer layer of the bottled water should be torn off to prevent the outer packaging from entering the water dispenser and blocking the pipe, resulting in unsmooth water outflow.

4. Avoid dry boiling of water dispensers. If there is no new bottled water to change, the power should be turned off immediately, the water dispenser is in a dry burning state, and it is easy to catch fire.

5. If there are stains on the surface of the water dispenser, rinse it with a large amount of water, and do not use acidic or alkaline solutions to clean the surface of the water dispenser.

6. Be sure to disconnect the power supply of the water dispenser before going to bed. The whole working process of the water dispenser is a process of heating and cooling and then heating, and the drinking water is repeatedly heated, which is easy to produce carcinogens - nitrite, so the power supply of the water dispenser must be disconnected at night to ensure the health of drinking water.

Yes, the direct drinking water dispenser is to purify the tap water, and the filtered water quality is safe and healthy, and there is no problem with drinking it directly. If there is a problem with the direct drinking water purification system itself or if there is a problem with the water source, the quality of the direct drinking water will be affected.

The vast majority of the water from the direct drinking water machine can not be drunk directly, the reason is that the direct drinking water machine is generally made more exquisite, and it is impossible to place fully functional accessories in such a small space, so the sterilization device is usually not placed in, if you want to drink water healthy and safe, install a small household ultraviolet sterilizer behind the direct drinking water machine, which can solve the problem of drinking water.

The water in the direct drinking water dispenser is filtered through a filter membrane, so it can be drunk directly, and it is also okay to boil.

Yes, it has a filtration function to remove impurities, which is good for the human body.

It's not good, it's still boiling and drinking.

It's more hygienic.

Direct drinking water dispenser is a practical electrical appliance in modern life, which can directly convert tap water into hot or cold water, which is convenient for people to use. The method of using a direct drinking water dispenser is also very simple, and the following is an introduction to the drinking method of a direct drinking water dispenser.

1.Wash buckets and tubing.

Before using the water machine for the first time, clean the bucket and pipes. You can add white vinegar or special cleaning agent to the bucket and mix it with water, stir, and then put the cleaning liquid into the water machine and circulate it for about half an hour, and then drain the cleaning liquid. Repeat this twice until there is no odor.

2.Add water. Pour the water you need to drink into the bucket of the drinking fountain, and in general, you can add water below the highest water mark of the bucket.

When adding water, be careful not to pour boiling water directly, because talking about pure hot water will make the temperature in the water machine too high, which will easily lead to machine failure. In addition, it is best to put ice cubes in the water first when adding water, which can reduce the water temperature to ensure the normal operation of the direct drinking water dispenser.

3.Select the water temperature.

The direct drinking water dispenser can generally adjust the water temperature, which can be adjusted according to your needs. The temperature regulator can adjust the temperature of the outlet, which is usually divided into three levels: room temperature, ice water and hot water. The applicable temperature range of the water machine is generally 5 -45.

4.Wait for the water temperature to reach the required level.

After adjusting the water temperature, you need to wait for a while for the water machine to reach the set temperature. This process usually takes a few minutes, so calculate the time well in advance before drinking.

5.Start using a direct drinking water dispenser.

Once the water machine reaches the desired temperature, it is time to start using it. If you need ice water, you can press the ice water button directly; If you need hot water, you can press the hot water button. If you need room temperature water, you can press the room temperature water button.

In short, it is very convenient to use a direct drinking water machine, and you only need to pay attention to some basic matters of shouting and grinding, which will make the water machine run more smoothly and better bring us high-quality living water.