What should I do if my watch falls into the water?

Hello, method 1: If you accidentally get water into the case, you can use a granular substance called silicone to put it into a closed container with the watch that has accumulated water, and after a few hours, take out the watch, and the water will all disappear. This method is simple and economical, and there is no damage to the accuracy and longevity of the watch.

The silica gel that has been absorbed many times can be dried at 120 degrees for several hours, and the water absorption capacity is renewable, and it can be used again and again.

Method 2: If the water ingress is not serious, but there is a layer of fog in the surface glass, then you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the table tightly, and bake it at a distance of 15 cm from a 40-watt light bulb for about 30 minutes to eliminate the moisture. Do not bake the watch mask directly close to the fire, so as not to deform the watch by heating.

You can also put the mask facing inwards and the bottom shell facing outward, and wear it on the wrist backwards, and the moisture can be eliminated after two hours. If the water ingress is severe, it is best to immediately send it to the watch shop to wipe the oil and remove the moisture from the movement to avoid rust on the parts.

Method 3: Put the surface face inward, the bottom shell facing outward, and wear it on the wrist, and the moisture can be eliminated after two hours. If the water ingress is severe, it is best to immediately send it to the watch shop to wipe the oil and remove the moisture from the movement to avoid rust on the parts.

Special attention should be paid to the fact that if the electronic watch is flooded, the electronic should be removed in time. Whether it is a mechanical watch or an electronic watch, if the water ingress is serious, it should be sent for repair in time.

The watch should be fished out immediately after falling into the water, after the water into the watch, if the watch has good waterproof performance, it may only be a small amount of water in the table, after a small amount of water is generally 20-30 minutes later, after a layer of water mist on the surface shell, if this is the case, you continue to take it for a few days and there will be no more, it will naturally evaporate after a few days of water vapor, and it will be dry. (You can also use a lamp to absorb water and wrap it in a flannel, and use a slightly hot air to absorb the water in the table as much as possible.)

If you find that the watch is flooded, you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the watch tightly, put it about 15 cm near a 40-watt light bulb, and bake for about 40 minutes, and the water vapor in the watch can be eliminated. Do not bake the watch directly near the heat, so as not to deform the glass by heating. Because although there is no moisture on the dial, there may still be water in the movement, and the movement will rust and cause damage to the movement after a long time.

After the watch is flooded, it is recommended to find a professional repair outlet as soon as possible for the master to check and deal with it, which can reduce your unnecessary losses.

Take out the battery directly, don't turn it off, it's easy to burn the circuit....Then put it in a ventilated place, preferably with the sun....A day in the sun....Then turn it on and try....If not, go to customer service for repair....

Remove immediately to dry, or blow dry with a hair dryer.