How to install a hard disk Lenovo notebook, how to install a Lenovo computer mechanical hard disk

Please unplug the battery on the laptop before preparing to disassemble and install the hard disk, so as to avoid booting the computer due to hitting the power key or the internal vibration of the computer when disassembling or installing the hard disk.

Then remove all the screws on the back cover, at this time it is best to check whether the screws have been removed, if there is one that has not been removed, it cannot be opened. Then where the back cover is opened, there is a notch that can be opened by breaking it up, and it may be difficult to open it when you open it for the first time.

When you open it, you see that the black and boxy thing is the hard drive. Take a certain screwdriver and open it a little, and lift the hard drive directly up to take it out.

Note: This is determined according to the structure of the motherboard, most of the motherboard can be pulled out by connecting left and right. After opening the back cover, you must pay attention to the observation and do not blindly use brute force to disassemble the hard disk on the notebook.

Note: Connectors like this can be connected to SSDs, and HDDs. What kind of installation do you install.

Remove the screws from the hard drive assembly and install a new hard drive.

After the laptop fixed case is installed, install the connector again. Then put this set from top to bottom at the interface of the laptop motherboard.

When installing the cover, it should be noted that one side of the general cover will be installed on the laptop first, and then it can be closed. This method is relatively simple, as long as you see the protruding place on the lid, not the side that was installed first. This completes the installation of the laptop hard drive.

The interface of this laptop to the laptop motherboard is a little different, this one has an additional adapter connector. Most laptops are adapters and are soldered to the laptop.

There is a cover in the back of the hard drive where it is removed.

The specific steps are as follows:

1. Remove the battery, remove the back cover, and the mechanical hard disk will be fixed.

Unscrew the screws and push down to remove the hard disk.

2. Remove the four screws on the hard drive rack and place the SSD.

Replace it with. <>

3. Cover the back cover and install the battery to grind the envy.

Create a recovery medium (USB stick or CD-ROM) and install it on an SSD. There are relevant prompts in the one-click recovery assistant, just follow the operation.

You can't install it like this. Ghost is highly discouraged.

After installing the SSD first, open Achi in the BIOS (this may be the original option), and change the first boot item to the SSD in the BIOS. Then install the clean version of the system (installed version) on the SSD partition, just like you would normally install the system. In this way, the SSD after installation is directly 4K aligned.

If the mechanical grid is not qualified, it will not affect (if you want to use the original system in the future, you can also change the mechanical hard disk for the first start).

Dear Lenovo users, hello!

You can find the information you need at the link below.

windows7

windows

If your problem is not solved, you can complain, put forward your valuable opinions, and then transfer to manual service.