How to catch the sidespin ball, how to catch the sidespin ball

If it's a sidespin, you just push hard, and take the opportunity to push the serve's corner to catch him off guard! If the location is good, even a drawboard will do!

If it is a side downspin, it is not advisable to push, and a chipping ball must be used. Generally, you can't take the lead Supplement: You can use methods such as steady rubbing, short swinging, splitting long, picking, and pulling for beginners For beginners, the most basic way to catch the downspin ball is to rub steadily, and it is required to rub steadily, low, and not down.

For table tennis players with a certain level, when receiving the spin ball, they must be proactive and increase the difficulty and quality of the return. If the opponent's serve spin is very strong, it is necessary to use the pendulum short and split length method to receive, and increase the difficulty of the rotation and landing point of the recall. Because the downspin ball is not too fast and the spin changes greatly, the preparation time for receiving the serve is sufficient, and it is more difficult to control the hand to judge the spin strength and return the ball.

Strong downspin balls are generally matched with non-** balls with similar techniques. This requires the receiver to judge accurately, and dare to start after seeing the spin strength and landing point of the incoming ball. If you don't have the guts, seek to catch steadily, or even support the ball, most of them will be attacked by the opponent.

Rubbing the ball without turning the ball will not make the ball produce a large spin change, and it is easy to be attacked by the opponent, resulting in passivity or loss of points. When using the backhand pull technique to catch the backhand downspin long ball, it should be noted: if the opponent's serve speed is not too fast, the angle is not large, and the rotation is average, it is relatively easy to return.

However, if the opponent's serve is of high quality, it is required that the ball should be pulled or rushed on both sides with a strong feel, and the opponent's rotation should be restrained by friction and rotation. Give way to the two corners of the opponent fully. If you can accurately judge the incoming ball, it is also effective to use the method of squeezing to catch back.

If the opponent's serve is a sharp downspin, it is easy to get a high ball with the normal way of rubbing the ball, and it is easy to get off the net with the method of pushing and dialing. At this time, you can use rubbing and squeezing back, which can also make the return ball produce a certain sharp downspin, but you should pay attention to mastering the hitting time, racket shape and force method.

There are many types of table tennis rotation, and the commonly used rotations are: topspin, downspin, left spin, right spin, left topspin, left downspin, right topspin, right downspin, right downspin.

In order to catch the spinning ball, you must first understand the manufacturing methods of various spins:

Upspin: Lean forward, touch the middle and upper part of the ball, and rub forward and upward. Such as attacking the ball, pulling the arc ball.

Downspin: Tilt the paddle face backwards, touch the middle and lower part of the ball, and rub it forward and downward. Such as chipping and rubbing.

Left spin: The paddle surface is vertical, the middle of the ball is on the right side, and the force is forward while rubbing from right to left. Such as serving and rubbing.

Right spin: The paddle surface is vertical, touch the middle of the ball to the left, and rub from left to right while pressing forward.

Left topspin: The paddle surface is vertical, touch the lower right side of the ball, and rub it against the upper left while pressing forward.

Left downspin: The paddle face is slightly tilted back, touching the right side of the ball to the upper part, and rubbing to the lower left.

Right topspin: The paddle surface is vertical, touch the left side of the ball and rub it towards the upper right.

Right downspin: The paddle is slightly tilted back, touching the left side of the ball to the upper part of the ball, and rubbing to the lower right.

Once you know how to create a spin, you can determine the direction of rotation based on the direction of your opponent's swing.

Here's how to deal with the various spins:

Upspin: The paddle is slightly forward, and the stronger the topspin, the worse the forward leaning. Pay attention to the magnitude and direction of force.

Downspin ball: The paddle face is tilted back and turned into an upspin ball with attack and pull.

Your opponent has a left-hand spin and your paddle is biased to the left (straight).

Your opponent has a right-hand spin and you have a right-hand shot (straight shot), a backhand for a horizontal shot or a forehand for the sideways.

Left topspin, downspin, right topspin, downspin, use your paddle to face the opponent's paddle face when the ball is touched. The above is just a suggestion for beginners who are learning to spin the ball.

Table tennis teaching: I often encounter sidespin balls in the game, how should I catch them? Table tennis teaching: I often encounter sidespin balls in the game, how should I catch them? Table tennis teaching: I often encounter sidespin balls in the game, how should I catch them?

1. Pick up the left upspin (down) ball. The left-sided topspin ball is a spinning ball that combines left-hand spin and topspin, and it is appropriate to use push, attack and return to this kind of ball. When retracting, the angle of the paddle face should be slightly forward, and the direction of the paddle face should be deflected to the left to counteract the left spin of the incoming ball; Push forward and downward to prevent the ball from reaching the upper right of you**.

2. The left downspin ball is a spinning ball that combines the left spin and the downspin, and it is advisable to rub and cut back to catch this kind of ball. When retracting, the angle of the paddle face should be tilted back and the direction of the paddle face should be deflected to the left to counteract the left spin of the incoming ball; Use a slight upward force to prevent the ball from touching the racket to the lower left**. If you use push and attack to catch back, in addition to paying attention to the angle of the racket surface and the direction it is facing, you should also increase the force of rubbing the ball upward.

3. Connect the right side of the upspin (down) ball. This type of serve is a combination of right spin and topspin. Pick up the right topspin ball, generally use push, attack is appropriate.

When retracting, the angle of the paddle face should be slightly forward, and the direction of the paddle face should be deflected to the right to counteract the right spin of the incoming ball; Use more force forward and lower to prevent the ball from touching the racket to the upper left**. If you use rubbing and shaving back, in addition to paying attention to the angle of the paddle surface and the direction it is facing, you should also increase the force of downward friction.

4. The right downspin ball is a rotating ball that combines the right spin and the downspin, and it is generally appropriate to rub and cut this kind of ball. When retracting, the angle of the racket face should be slightly tilted back, and the direction of the racket face should be deviated to the right to counteract the right spin of the incoming ball; The upward force should be relatively increased to prevent the ball from touching the racket to the lower left**. If you use push and attack to catch back, in addition to paying attention to the angle of the racket surface and the direction it is facing, you should also increase the force of rubbing the ball upward.

The table tennis downspin ball is received as follows:

First, the downspin short ball does not go out of the judgment table.

If it is judged that the opponent is sending a downspin short ball and does not come out, the method of receiving the ball is different according to the different balls

1. On the backhand, you can swing short to the opponent's forehand triangle, or the middle of the forehand position. You can also split the long and dig the ear to the opponent's forehand at a large angle, and try to add spins to increase the difficulty of the opponent's next board in space. Positive catches can be used to pull the ball with a backhand, and the opponent is generally more passive.

2. In the forehand position, you can split long to the large angle of the opponent's backhand, or swing short to the large angle of the opponent's forehand.

3. In the middle position, the horizontal shot can be twisted up with a backhand in the stage, which is slightly picky. If you find it difficult to pick up and spin down, you can use your forehand to shake the opponent's backhand to achieve the purpose of control.

Second, the introduction and semi-introduction of the downward spin long ball.

If you judge that the opponent is sending a downspin long ball to the table, or a half-shot to take the following methods:

1. The backhand spins the long ball, and the horizontal shot is directly pulled up, and it is better not to pull the ball, but only to rub the ball to control the angle and not be easily attacked by the opponent. If you can't hit horizontally, you can actively grab sideways, and if you hit horizontally, you can pull it up directly.

2. With a large angle of forehand, use a cross step or a big stride in place to pull the arc circle ball to the opponent's forehand at a large angle or the opponent's backhand, and try to increase the speed of the counterattack and cause difficulties to the opponent.

3. Chase the body in the middle, actively fight back with the forehand sideways, and pull the arc ball to the opponent's backhand position for a stable reception, and the opponent should not exert force. You can also return to the opponent's forehand at a large angle, but the angle must be large, otherwise the opponent will definitely fight back on the next board, and the threat of coming back is great.

4. Pay attention to the cooperation of the footsteps in receiving the serve, not standing dead to receive the serve, and moving more feet In order to improve the quality of the return ball, try to use the arc ball to shoot back, and try to increase the rotation of the ball, especially when the arc of the ball is very low, it can ensure the rate of getting on the stage, overcome the downspin ball, and reduce mistakes.

The increase in spin undoubtedly makes the other brother dare not exert his strength easily, which is conducive to the continuous attack of the next board of our serve.

There are three ways to catch the side spin ball, one is to cut the ball in the opposite direction, the second is to bend the ball in the opposite direction, and the third is to pull back.

Interpretive diagrams. Table tennis guess how to cut the ball:

When playing table tennis cutting ball, you need to pay attention to the hitting time, at the high point, or in the early stage of rising, facing the incoming ball, hitting the middle and lower part of the ball, and completing the hitting table tennis cutting ball The technique requires or Li Qiu's wrist, the finger force is extremely high, and it is not easy to practice well, so you must have enough wrist strength.

Table tennis cutting skills:

Fight in the opposite direction of the ball to get the racket in the opposite direction of the ball to spin the ball.

Straight and back: <>

Diagram of a straight shot and a reverse shot.

Sidespin Ball Hitting Action:

The process of spinning the spike early is a "cutting" process, and the racket should be waved against the imaginary clock at 3 o'clock. Before making contact with the ball, the racket should move towards the ball at an angle of about 45 degrees. The swing requires the body to move high, outward and forward, and the elbow forward and up at the same time.

1. Left spin ball: the paddle surface is vertical, touch the middle of the ball to the right, and rub it from right to left while exerting force forward. Such as serving and rubbing.

2. Right spin ball: the racket surface is vertical, touch the middle of the ball to the left, and rub it from left to right while pressing forward.

3. Left topspin ball: The paddle surface is vertical, touch the upper right side of the ball, and rub it to the upper left while pressing forward.

4. Left downspin ball: The paddle surface is slightly tilted back, touch the lower part of the right side of the ball, and rub it to the lower left.

5. Right topspin ball: The paddle surface is vertical, touch the left side of the ball to the upper part, and rub it to the upper right.

6. Right downspin ball: The paddle surface is slightly tilted back, touch the lower left side of the ball, and rub it to the right down.