How do I pitch a small tent? How to pitch a tent How to pitch a tent

Look at the instruction manual. Otherwise, go to the place you bought. Ask him.

Here's how to pitch a tent:

Tool: Tent.

1. Site selection and clean up the camp

To set up a tent, we have to choose a good campsite, the choice of campsite should be determined flexibly according to the terrain, and the season, etc., the camping site should be easy to enter, easy to rest, relatively flat place, but also to choose a place closer to the water source, but not too close, 40 50 meters away from the water source is ideal.

Because it is too close to the water, the river rises at night, there is a danger of being washed away, and there are many mosquitoes, which are easy to bite and hinder sleep, and it is also necessary to avoid lightning strike areas and flash flood areas as much as possible. The ground should be cleaned, there should be no sharp objects, check whether there are ant nests, honeycombs, etc., and stay away from these places.

2. Floor cloth

In order to keep out moisture and protect the tent, it is best to spread 1 layer of waterproof floor cloth on the ground if possible.

3. Shop account

Usually the bottom is a dark cloth surface, and the bottom side down puts the door in the direction you want to enter and exit.

4. Wear a skeleton

Usually the tent will have 2 folding tent poles, take out the folded tent poles, straighten them one by one, and connect them into 2 long tent poles. Put the 2 long tent poles crosswise on the inner tent, and thread them into the inner tent diagonal, the inner tent diagonal has an opening to let the tent pole pass through, and remember to let the tent pole pass through the pull ring directly above the middle.

5. Set up an internal account

Two people stand diagonally, step on the corner of the inner tent while holding up a long skeleton and inserting the latch into the skeleton, and then do the same diagonal again. This step requires a bit of effort, and don't be afraid to break the skeleton.

Basically, the skeleton is very strong, if it is really difficult to hold up, it may be that the skeleton is loose one by one, or the internal organs are entangled in the cloth of the skeleton (as shown in the second picture below). After the completion of the whole spine of the tent shape comes out, and then don't forget to hook the inner tent to the skeleton.

6. Playing external accounts

Lay the outer ledger, hook the four corners to hook the pull ring of the inner tent latch, support the short skeleton on the front and rear doors, and fix the devil's felt with the diagonal long skeleton. Before laying the flysheet, you can open the top windows on both sides of the flybook, and the ventilation effect will be better, but it is not suitable for this when it is windy and rainy.

7. Nail the ground and pull the camp rope

Nail the camp nail to fix the tent. The door is fixed at night so that it will not be blown around by the wind and filial piety, and it is very noisy, the four corners are fixed and the tent will not be blown away when the wind is strong, and the bottom of both sides can be nailed up to separate the inner and outer tents, and the inner and outer tents can be separated to keep the inner tents dry and not wet, and it is very painful to sleep until the tent is wet.

Usually the weather changes big and fast in the camping place, I don't know when it will suddenly be windy and rainy, it is recommended not to be lazy, and all the camp nails must be nailed.

Setting up a tent is an important skill in outdoor activities, and mastering the right way to set it up can ensure the stability and safety of the tent. Here are the basic steps to set up a tent:

1.Preparation: Start by making sure the ground is flat and free of debris. If it's grass or sand, you can lay a floor cloth first to protect the bottom of the tent from wear and tear. At the same time, make sure that the surrounding environment is safe and away from damp, collapsing-prone areas.

2.Open the tent: Take the tent out of the bag, open the four corners of the tent, and pull two of the corners towards the middle so that it forms an "X" shape. This will prevent the tent from being overstretched during the erection process.

3.Install the ground nails and wind ropes: evenly distribute the ground nails along the town around the tent, and determine the length of the ground nails according to the ground conditions.

At the bottom of the tent**, secure the tent with long ground spikes. Then, thread the wind rope through the four corners of the tent to secure it to the ground spikes. Pay attention to keep the tightness of the wind rope moderate, too tight may cause the tent to deform, and too loose may cause the tent to be unstable.

4.Adjust the tent: During the construction process, you need to constantly adjust the shape of the tent to ensure that it is flat and stable. If you find that the tent is tilted or raised, you can adjust the tightness of the wind rope appropriately to bring it to balance.

5.Stow the tent: After the event, the tent needs to be folded.

First, remove the clasp from the wind rope and unfasten the retaining ring on the ground peg. Next, slowly roll the four corners of the tent inward until the tent is fully folded. Finally, place the tent in the bag.

There are a few things to keep in mind when setting up a tent:

Choose the right type of tent according to the weather and environment (such as shade, rain, wind, etc.).

Properly install ground spikes and wind ropes to ensure the stability and safety of the tent.

Pay attention to the ventilation inside the tent and keep the air circulation inside and outside the tent.

Regularly inspect the tent for wear and tear and replace or repair it if necessary.

Here's how to pitch a tent:Tools: Tents and accessories.

1. Open the stored tent.

2. Check whether the accessories are complete.

3. Lay the inner tent on the flat ground.

4. Wear the strut.

5. Thread the pole into the inner tent.

6. Fix each other with the tent.

7. The inner account has been set up.

8. Cover the flysheet and fix it.

Steps to pitch a tent1. Cross the two main support rods of the tent into an "X" shape and pass through the four corner fixing holes of the tent.

2. The four corners of the tent are fixed and supported, and the tent in the middle will also increase the space of the tent with the uplift of the bracket.

3. Fix the tent and support rods, and the tent will be erected and you can move inside.

4. In the field, it is necessary to fix the tent nails to prevent the tent from being blown away by the wind, and it is necessary to use hammers and other tools to nail the tent nails into the soil.

1. First of all, spread out the inner tent flatly, open the tent pole, and place it crosswise.

2. Then thread the two ends of the tent pole into the bottom air hole in turn.

3. Hang the tent hook on the tent pole in turn, and the skeleton is completed.

4. Put the outer account on the inner account, and pay attention to the external account and the inner account door.

5. Finally, fix the self-adhesive strip of the flysheet on the tent pole, fix the four corners with tent nails, and the construction can be completed.