My computer was fine yesterday, but this morning, the mouse doesn t move, and it doesn t work when I

I've had the same problem as you, and I've finally come to a conclusion and found a solution that works.

Hot swap the mouse (except for 98, the mouse will burn out), and then restart, generally one time can be successful, if unsuccessful, shut down and restart again (to use the keyboard control, do not force the hot start).

This is because your mouse compatibility is not good, and it would be good to change to a genuine mouse if it is completely solved. This is the case with many fake mice that are difficult to distinguish from each other.

Unplugging the mouse from the chassis and plugging it back in may be caused by poor contact.

Turn on the computer and press F8 to select the last correct configuration to try.

Is the keyboard good? If it's good, try it by plugging it in.

Either the mouse is in water or broken.

Don't restart, turn off the computer at the boot switch, and then reboot it to try, it should be done, and mine is solved like this.

Categories: Electrobi Brain Network >> Hardware.

Problem description: Play well, suddenly the host rings a few times, and then the mouse doesn't move, the line is not loose at that time, I can't unplug it and plug it in, but after restarting the host, it's okay, what's going on?

Analysis: This is a problem with the driver of the mouse Menghui cavity standard, which may conflict with the system or other hardware, it is recommended to ** a mouse manufacturer's dedicated driver, which may have fewer conflicts.

Plug it back in, then restart the computer and try it, if it doesn't work, change the socket and restart the computer again.

Usually this is either caused by the interface between the mouse and the host, or the driver of the few mice that need to be driven is damaged. The former is more likely.

Generally speaking, the occurrence of a mouse click becoming a double click is mostly caused by a mouse failure, but it may also be due to a mouse click becoming a double click due to an incorrect setting operation. Therefore, it is recommended that you overhaul it before repairing, and try to connect the mouse to other computers, if the problem still exists, then it is basically certain that the mouse is faulty, this type of failure is basically a small fault, and the maintenance is relatively simple, the following shares the author's repair process.

Operate the mouse to do things like determine the cursor position, choose the menu item you want to run from the menu bar, move copied files between directories, and speed up file movement. You can define the mouse buttons, such as selecting objects or discarding, depending on the software you use.

Because the wireless mouse uses a special wireless data information transmission method, this transmission mode is inevitably subject to interference, and we all know that the power cord and data cable will produce interference signals during use, so remember to sort out various power signal lines, or use wires with better shielding performance. Minimize the possibility of interference with the wireless mouse signal transmission.

Now it is equivalent to saying that you can't do anything when you boot up, and you can't move the keyboard and mouse?

You turn on the computer now and see if the keyboard light shows it or not, and if the mouse is on.

If it's a U-port replacement, try it. If it's a circular connector, plug it back in, and by the way, see if the needle is crooked.

When you turn on the computer, see if it is useful to use the keyboard, such as entering the motherboard, entering the safe mode or something, mainly to detect whether the keyboard is damaged.

If the above doesn't respond, buy a U-port keyboard and try it.

It may be that the mouse cable socket is loose, restart the computer after plugging it in.

It is very likely that the contact is poor, the general solution is to unplug it and then connect it, if it still doesn't work, see if the mouse drive is normal.

There is file loss in the system, it is recommended to reinstall the system.