Will the saxophone button be disassembled and cleaned by itself, will it affect the pitch

No, you must be careful when washing, don't pull the keys, otherwise it will run out of gas, and it will affect a lot, such as long tones and the like, it is okay to wash gently.

I'm really sorry I've been blowing it for 15 years, and it's best to use the same screwdriver when disassembling it, because the saxophone rose is generally not slippery.

If you're a beginner and you're not sure, don't do it yourself.

Yes, very well, I don't dare to mess with the parts on the pipe for five years, it is recommended to find a professional repairer.

If the leather pad is wet after blowing, please use absorbent paper to clip the water between the leather pad and the sound hole to absorb the water, and pay attention to the fact that the leather pad does not retain water to avoid shortening the service life due to hardening.

When removing the water in the pipe, the through bar of the SAX through the bell is inserted into and then out of the neck pipe joint, and repeated several times.

After playing, the reed is removed and a strip cloth is used to remove water from the inside of the mouthpiece and neck tube.

To remove the dirt on the surface, you can use a cleaning cloth to remove fingerprints and dust on the surface of the pipe body.

The sound hole of the harmonic key is small and easy to block, so it should be cleaned frequently with a sound hole cleaning stick.

Clean the subtle parts once a week: remove the dirt around the key linkage; Make the gauze into a band and gently clean it between the connecting rods; Use the soundhole cleaning stick to gently clean back and forth between the keys, taking care not to injure the leather pad.

When using key lubricants, apply a small amount of key lubricant to the chain screws (do not loosen the screws). Be careful not to drip too much, and wipe it clean if it sticks to the tube.

Clean the neck canal about once a month: pour the detergent solution into about 30 to 40 warm water (the appropriate ratio is detergent: water = l:

15)；Remove the leather cushion connecting rod from the neck tube and wrap the cork with tape so that it will not get the solution; Clean the inside of the tube with a brush dipped in detergent from the SAX cleaning group, and rinse with clean water after the dirt is removed; Use a strip cloth to penetrate the pipe to absorb the water; Attach the leather cushion linkage and you're done.

Provide some basic, though it should be fine to disassemble on your own, but be careful.

Summary. Hello, the saxophone bass 6 key cover is not tight probably because of 1whether the leather cushion of the corresponding lid is loose or falling off (the sound hole cover is not tight); 2.

whether the screws of the corresponding key are loose (not in place); 3.whether the corresponding pin spring falls off (the key loses power); 4.whether the relevant small mat has fallen off (the position of the lid has changed); 5.

Whether the lid in relation to this sound opens and closes properlyaIf it can't be opened normally due to saliva adhesion, you can just pull it away with your hand, and you can also clean the leather pad with water or alcohol; b.Due to the deformation of the linkage rod, the corresponding cover is not tight;

Hello, the saxophone bass Shihui 6 key cover is not tight probably because of 1whether the leather cushion of the corresponding lid is loose or falling off (the sound hole cover is not tight); 2.whether the screws of the corresponding key are loose (not in place); 3.

whether the corresponding pin spring falls off (the key loses power); 4.whether the relevant small mat has fallen off (the position of the lid has changed from time to time); 5.Whether the lid in relation to this sound opens and closes properlya

If it can't be opened normally due to saliva adhesion, you can just pull it away with your hand, and you can also clean the leather cushion with water or alcohol; b.Due to the deformation of the linkage rod, the corresponding cover is not tight;

Dear, if my answer is helpful to you, please give a thumbs up, your support is also the driving force for my progress. If you feel that my answer is still satisfied, you can click on my avatar to follow me, and you can consult me directly with similar questions in the back car. Finally, I wish you good health and happiness again!

Summary. To reduce the key sounds produced during saxophone recording, you can try the following methods:1

Adjust the position of the recording device: Move the microphone away from the key part of the saxophone and avoid direct contact with the buttons. 2.

Use the right microphone: Choosing a microphone that is suitable for recording the sound of an instrument can reduce the capture of key sounds. 3.

Use a microphone shock mount: A shock mount reduces the likelihood of external vibrations and trigger key sound being transmitted to the microphone. 4.

Reduce the force of the keys: Press the keys as gently as possible to avoid loud noises. 5.

Adjust the recording environment: Try to choose a quiet recording environment, and set appropriate audio gain and noise cancellation parameters to reduce the capture of key sounds. Hopefully, the above methods can help you reduce the key sounds produced when recording the saxophone.

To reduce the key sounds produced during saxophone recording, you can try the following methods:1Adjust the position of the recording device:

Move the microphone away from the key part of the saxophone and avoid direct contact with the keys. 2.Use a suitable microphone:

Choosing a microphone that is suitable for recording the sound of an instrument can reduce the capture of key sounds. 3.Use the microphone shock mount:

The shock mount reduces the possibility of external vibrations and triggering key sound transmission to the microphone. 4.Decrease the key force:

Press the keys as gently as possible to avoid loud noises. 5.Adjust the recording environment:

Try to choose a quiet recording environment and set the appropriate audio gain and noise cancellation parameters to reduce the capture of keystrokes. Hopefully, the above methods can help you reduce the key sounds produced when recording the saxophone.

Fellow, I really didn't understand, I can be more specific.

To reduce the key tone in a saxophone recording, there are several ways to do it:1Adjust the recording position:

Place the microphone away from the keys. This reduces the chance of keys going directly into the microphone, which reduces the recording effect of key sounds. 2.

Reduce the force of the keys: Press the keys as gently as possible while playing to avoid overexerting force. Because pressing a key hard will produce a louder keystroke sound, a light press can effectively reduce the key sound.

3.Use cushions and mute devices: Adding soft pads to the keys of the saxophone, or using a special mute device, can effectively eliminate the conduction and resonance of the key sounds.

4.Reasonable selection of recording equipment: the selection of good quality microphones and recording equipment can reduce the recording of noise and noise.

Make sure that the recording device is appropriately sensitive so as not to over-capture the keystrokes. The reason for the key sound is that when the key of the saxophone is pressed, there is contact between the key and the sound hole, and the keystroke sound is generated by the bridge answer. The sound of the dissipation will be clearly audible in the recording.

The above methods can effectively reduce the interference of key sounds. In addition to the above measures, you can also pay attention to your playing technique, avoid frequent key presses, and reduce the appearance of key keys with smoother timbre transitions, which can further improve the quality of your recordings.

Summary. Hello! According to the query the spring becomes loose: it can be reinserted, and crochet springs are often suitable for this.

Hello! According to the inquiry, the spring becomes loose: it can be reinserted, and the crochet spring is often suitable for this.

1. If a key stops suddenly, then detect the corresponding spring, if it is cracked or lost, it can be replaced by a temporary hard rubber tape; Remember to remove the rubber band after playing, as it may damage your covered genus or paint (emergency) in the long run. 2. Loss of low area: The reason is that the hole of your erectomy is not completely closed, and repairing it usually requires careful bending of the mechanism, a task that is best handled by a specialized technician!

3. The spring becomes loose: it can be reinserted, and crochet springs are often suitable for this. 4. Screaming:

Moisten the whistle and change it. 5. Acoustic too: Detect whether the buffer is intact or not, you can choose to drop soluble glue to bond it, other types of glue will harden your sticky, damage your paint or because of its durability resulting in sticky and soft can not be replaced.

6. Leakage: The situation of multiple leaks is gradual, you will press the keys deeply, blow heavier and other situations to adjust them. 1. The main points of the saxophone trembling must be combined with a good basic; 2. If you want to achieve a satisfactory result, the appropriateness and perfection of the Dharma technique are the basic conditions that should be met.

3. The second taste may be disappointing. With the construction of good practice habits, it will gradually get better. 4. Get proper control.

4. After gaining proper control, think about what is needed for music according to the art of matching. 5. In order to learn and research, imitate the best artists (not only saxophonists). 6. Avoid consciously pressing the beat and playing according to the given knowing speed.

7. When the trembling movement is perfect enough, it will be integrated into the sound of the performance, and the music will be rich in laughter, brilliance, and smoothness. 8. In the lyrical phrase, when transitioning from one to the next, do not disturb the flow of the movement. 9. Trembling is an important part of the school, and only through and endured learning can it achieve perfection.

10. Bear in mind the basic definition of trembling:"The amount and the pulsation of various factors at a certain amplitude and rate of pulsation, from making the music sound smooth and soft, full and round. "

Where can it be adjusted and how much.

If you don't replace the parts, it doesn't cost much, and you should be able to get it within 100 yuan. It's hard to say if you need to replace parts.

Generally, where there is a saxophone sale, it can be adjusted.

There is also a musical instrument shop, which is basically fine.

The musical instrument shop has dedicated staff for maintenance and tuning.