How to paste the seams of the solid wood surface so that they do not bulge out

1. The substrate is treated flat. It is important to choose a substrate with a flat surface and no deformation.

2. The hand-pasted veneer should be millimeter, and try not to exceed millimeter.

3. The temperature of the iron should not be too low. Of course, it should not be too high, and the temperature should be suitable.

4. The viscosity of the glue should be appropriate, the solid content should not be too low, it is too thin and sticky, it is easy to blister, the glue should be uniform, and the quality of the glue should be paid attention to.

5. The veneer should be soaked through, and then dried until it is dry and humid and suitable for use. The veneer should not be too wet, which of course requires hands-on experience.

6. The end face or curved surface should be ironed multiple times and pay attention to the interval time.

7. Try not to cut off the end face veneer without a blade, and grind it with a coarse sandcloth pad. There are also more tests, standardized operations, and careful professional operation staff.

The reason for the uneven and excessive gap of the surface layer of the wood board is mainly that when the wood is laid, the moisture content limit is too large, and the reasons for the excessive moisture content of the wood are the following two points:

l) The wood has not been dried or the drying treatment does not meet the requirements.

2) Improper storage of wood or wood products during construction, moisture or rain.

Measures to prevent uneven and excessive width of the gap between the surface layer of the water floor are mainly to measure the moisture content before the wooden floor is laid

1) The moisture content of the surface layer of the wooden board, the skirting board and the seam strip should not be more than 14%.

2) The moisture content of raw (wood) flooring (12cm wide long board) is not more than 18%.

3) The moisture content of the bottom joist is not more than 2o%.

After the wooden floor is laid, the end joints of the wooden boards should be staggered at intervals, and the width of the gaps between the boards should not be greater than 1mm. Hardwood floors, gap width must not be greater than:

Method:1Direct bonding method:

It is to use the floor glue (non-water-soluble, strong aging resistance, and fast curing speed. Note: Dispense without top adhesive) directly to the ground.

This construction method requires that the ground must be particularly dry, flat and clean. Solid wood flooring with a length of less than 300mm and cork flooring are often used.

2.Suspended laying method: first lay a moisture-proof floor mat, and then lay a wooden floor on top. This construction method requires that the ground must be dry and flat. This laying method is currently used more in composite wood flooring.

3.Keel laying method: Wooden keel should use coniferous wood (such as: larch, red and white pine, etc.) or defective flooring materials. That is, the keel is fixed on the ground first, and then the floor is fixed on the keel.

4.Raw floor laying method: that is, the raw floor is fixed directly on the ground, and then the floor is fixed on the raw floor.

This method is generally insufficient in the height reserved on the ground, and can not be used to lay the keel or keel with wool flooring. However, it is reluctant to use the direct bonding method and the suspension laying method.

5.Keel and wool floor laying method: that is, first lay the keel and then lay the wool floor on the top, fix the wool floor with the keel, and then fix the floor on the wool floor.