The iPhone5 cable is always broken, what should I do

The frequent failure of the mobile phone charging cable is mainly caused by hardware reasons or improper use.

Failure analysis and treatment].

1. Improper operation.

1. After the charging is over, the charging head and the charging cable are always connected to the power supply, and it is easy to damage the charging head and charging cable if they are powered on for a long time.

2. When unplugging the cable, use too much force, or shake the data cable left and right, which is easy to damage the mobile phone interface or data cable connector.

Don't use too much force when plugging and unplugging, and disconnect from the socket in time after charging.

3. During the charging process, the mobile phone is used with great force, and the data cable is folded, which damages the connection line of the interface at both ends of the data cable. Or when carrying the data cable, the data cable is not organized, resulting in frequent pressure or distortion of the line at the interface connection, resulting in the line disconnection.

2. Failures caused by hardware equipment.

1. The charging head is used for a long time, the quality is not good, or the route is faulty, resulting in unstable voltage and easy damage to the data cable.

2. The charging interface of the mobile phone is damaged, or the circuit is faulty, resulting in easy damage to the line.

In particular, ash and water can easily cause damage to the interface.

3. The quality of the charging head is not good, and the voltage is unstable.

4. The charging cable is of poor quality and has a short service life.

It is recommended to replace the charging head and re-test the charging. In addition, when buying a charging cable, it is best to choose the original one, or the one that is relatively high.

Experience sharing of the use of charging cable].

1. Try not to use a compatible data cable to charge your phone.

2. When buying a data cable, it is best to charge the test, choose a relatively large wire diameter, a relatively high one, and the charging process is not easy to heat.

3. Do not frequently connect the original data cable to a non-Apple mobile phone charging head or a compatible charging head for charging.

Not only may it damage the data cable, but it is also easy to operate the phone's motherboard or other hardware.

It's good to buy an adapter, a lot of them are defective, buy a *** point Xindun or something

Buy another one, it's better not to buy a counterfeit one.

1. In order to prevent the data cable from being pulled and damaged, the wire part and the plug head are subcontracted with tape in advance, which can reduce the possibility of being torn. In addition, the data cable that has been torn apart but can continue to be used can be used with tape wrapped.

2. In the process of plugging and unplugging the data cable, try to avoid pulling the wire part directly, so as to better protect the data cable. The amount of time a product is spent in proportion to the amount of "care" invested.

3. Frequent use is also a reason why Apple data cables are easy to break. Ordinary data cables are cheap, there are no technical barriers, and they can be used with each other, so many people will have multiple data lines, which can be used alternately, and one will be prepared at home and in the company. The frequency of use of each strip is greatly reduced, and the service life is extended.

The fixes are as follows:

1. You can use tweezers or knives and other tools gently, it must be gentle, scrape the fourth gold finger, scrape off the black part, and then you can try to charge it normally.

2. Of course, there are many reasons for the damage of the data cable, if this method does not work, it is likely that the chip inside the data cable is damaged, so you can only buy a new data cable.

3. When using the data cable daily, the sweat and oil stains on our hands and the surrounding dust will stain the surface of the data cable, which will cause the material to age. We can use alcohol-free wipes to wipe and clean the thread body.

4. The metal contacts of the lightning interface can be gently wiped with a clean eraser to clean up the carbon deposits and dirt attached to it.

Notes:

1. It is responsible for current transmission for each charge, and the loss is the largest. You can observe your data cable, and this gold finger on both sides of the front and back is often a little darker than the other seven, so the data cable is not in good contact and cannot be charged.

2. Correct unplugging posture, many friends are used to pulling the cable directly to unplug the data cable, in fact, this is a reason for the damage of the data cable. The correct posture is to pinch the plastic sheath part of the lightning connector with your fingers to plug and unplug the data cable.

Apple's data cable is dedicated to special machines, if it is broken, you may have to buy a new one, this has no maintenance value!

Apple warrants your Apple-branded hardware product for a period of one year from the date of original retail purchase"Warranty Period"There are no defects in materials and workmanship. If any defect occurs during the warranty period, Apple will, to the extent permitted by law, at its option, (1) repair the product free of charge with a new part or a part that is equivalent in performance and reliability to the new part, (2) replace the product with a new product with the same functionality or equivalent in performance and reliability, or (3) refund the original purchase price. This warranty does not cover damages caused by abuse, accidents, alterations, or other non-material and workmanship causes.

So, this is actually the after-sales service that Apple consumers should enjoy, and not only the data cable, but also the headphones or power adapter are also covered by the warranty.

If your iPhone 6 cable is broken and it is still under warranty, go to Apple for a free new one. This is the service we should enjoy.

Yes!

First of all, we need to understand the construction of iPhone data cables. In order to ensure the safety of the iPhone when charging, Apple added tin foil to the data cable for insulation. In order to increase the service life of the data cable, Apple has added a metal mesh around the wire, in this way, to strengthen the toughness of the data cable.

This outer layer of metal mesh extends all the way to the protective rubber ring of the data cable connector. However, since the four wires are soldered at different locations at the data cable interface, the metal mesh can no longer protect the wires after the wires are separated.

In our daily use, in the process of pulling the data cable, it is usually directly by pulling the wire part, instead of pulling the plug. In the long run, the outer rubber ring of the wire will be stripped away from its place along with the metal mesh, and the metal wire will lose its all-important protection. This, coupled with the fact that some users do not pay attention to bending the data cables, accelerates the rate of internal metal wire loss.

You can go to the place where you sell your mobile phone with the original, don't just be greedy for cheap when you buy this kind of thing, I believe you Apple 5 have bought, and it won't be bad for this little money to buy a ***, it is recommended not to buy it online, the appearance of the Internet is beautiful but the quality is not good. Basically, 60% of you can be satisfied with buying something online is good, or go to the physical store to rest assured, at least if it is broken, you will go directly to the store to find the seller.

This quality is not good. Pay attention to it.

It can only be said that you used it too fiercely!!

It is recommended to use the original one, and try to avoid bending during use.

Don't buy on the line again, you change a hundred to buy the same result, you know!

Apple's data cable is easy to break, and it also depends on the frequency of charging the mobile phone, and the voltage when charging the mobile phone. First of all, we need to understand the internal structure of the iPhone data cable, in order to ensure the safety of the iPhone when charging, Apple added aluminum foil to the data cable for insulation, and at the same time, in order to increase the service life of the data cable, Apple added a metal mesh around the wire, in this way, to strengthen the toughness of the data cable.

First of all, we need to understand the internal structure of the iPhone data cable, in order to ensure the safety of the iPhone when charging, Apple added aluminum foil to the data cable for insulation, and at the same time, in order to increase the service life of the data cable, Apple added a metal mesh around the wire, in this way, to strengthen the toughness of the data cable.

2.Because the international four-color wires need to be welded in different positions of the joints, the two protective cores of metal braided mesh and bulletproof wire that strengthen toughness can only be wrapped in the connection between the wire body and the plug, that is, the rubber ring, which is also the part that causes the data cable to be most easily pulled and torn.

3. The material of the wire core is almost the same as Apple's original, metal woven mesh, bulletproof wire design, and it does have MFI certification chips, and the workmanship does not look bad.

The data cable of the Apple mobile phone is made of degradable materials, and it is normal to change one in two or three years.

If you want to extend the lifespan, try to isolate the data cable from the air, which can be tied with electrical tape.

If you don't use it for a long time, you must prevent moisture and high temperature above 30 degrees, otherwise when you use it again, it is possible that the charging head will fall off by itself.

My data cable is five or six a year, and the data cable is four or five hundred yuan in five years.

Dear, there are many reasons why the iPhone charging cable is always broken, but not most of them are because of the quality of the data cable, the analysis is as follows:

The purchased data cable is a high imitation Apple data cable, does not contain MFI certified data cable, the appearance is no different at first glance, but there is a difference in nature, the non-certified data cable does not contain a certified chip, at this time, the authentication window will pop up when using a non-certified data cable to charge the mobile phone, and the non-certified data cable has no shield on the data transmission, which is one of the main reasons for the short life of the data cable and easy to break.

The second is caused by the user's bad habits, and now Apple's data cable is mostly made of TPE rubber wire, which has the disadvantage of low strength, no tensile resistance, and easy to be damaged. For many users, when using the data cable, they often pull, drag, and pull the mobile phone data cable, which will cause damage to the cable, and finally accelerate the damage of the data cable!

So try to buy genuine ones when you buy them, and be careful when you use them.

Ask the question about the charge always being damaged.

Charging is a leakage phone appearance power.

The head is broken several.

The mobile phone charger itself is designed to be relatively compact, and it is easy to heat up during use, and if the surrounding heat dissipation environment is not good, the heat generated is not easy to dissipate, which can easily lead to damage to the charger.

When charging the mobile phone, the charger that comes with the original factory is not used, or the power output of the charger does not match the original charger, which is one of the reasons why the manual of many mobile phones requires the original charger to be charged.

This is critical.

And if it is not original, it will also damage the mobile phone battery.

Use a charger that does not have 3C certification, or use a low-cost, non-quality copycat charger to charge your phone.

Therefore, try to spend as much money as possible to buy genuine originals, so that the chance of bad is not great, and it is also good for the mobile phone.

Ask a question, okay, thank you.

Be careful when you save it... Don't often pull the wires, the wires inside and the fragile ones.。