How to overtake in subject 3, how to overtake, and how to operate overtaking in subject 3

Friends, it is not necessary to have a car in front of you to complete the "overtaking" project in subject 3! When the on-board computer voice report "Please overtake ahead", you first hit the left turn signal, head to the left rearview mirror to observe, if there is no vehicle, 3 seconds before you can change lanes to the left! When you're done changing lanes, turn off your left turn signal!

Then look at the right rearview mirror, hit the right turn signal, and after 3 seconds, there is no oncoming car behind to change to the right lane, and finally turn off the right turn signal to complete the "overtaking" project! Remember to make sure that the safety officer can see that you are clearly looking in the rearview mirror when changing lanes! It takes 3 seconds to move the steering wheel!

There will be no overtaken vehicles ahead!

What about overtaking, there are various operation methods in various places, specifically, it is better to ask the coach how to say, well, like the place around me, only change lanes to the leftmost lane before overtaking, and then when he starts, as long as he adds a little throttle, and then passes directly, because the leftmost lane is already on the overtaking lane, so he does not need to overtake again, change lanes and overtake and then change back, a step is omitted, or it is not easy to make mistakes, so it will be simpler on our side, But I don't know if that's the same in your place. So, you still have to ask the coach or examiner what to say.

When the computer reports the voice of the vehicle in front of you, regardless of whether there is a car in front of you to overtake, the action steps must be correct (for example, you are in the middle lane of the three-lane road) 1: Play the left turn light for more than 3 seconds, observe the left rearview mirror to see the overtaking conditions, change lanes to the left lane to accelerate and overtake 2: Play the right turn light for more than 3 seconds, observe the right rearview mirror to see the overtaking conditions, and change lanes back to the original lane.

Turn signals should be used before overtaking, and the rearview mirror should pay attention to the rear to confirm safety.

Kesan's overtaking operation, it turns out that there are these simple skills!

Pacific Automobile Network] Subject 3 overtaking operation method: 1. When you hear the voice prompt "please overtake", turn on the left turn signal, send out an overtaking signal, signal the overtaken vehicle, observe the rear and left buried traffic conditions through the internal and external rearview mirrors, and overtake after confirming safety. After the vehicle in front gives way, keep a safe distance from the overtaken vehicle and overtake from the left; 2. After the overtaking is completed, turn on the right turn signal, and slowly turn the steering wheel back to the original lane without affecting the normal driving of the overtaken vehicle, and then turn off the turning cavity call signal.

Subject 3: Overtaking operation method: 1. First hit the left turn signal. 2. Honk the horn to prompt the vehicle ahead. 3. Downshift and speed up. 4. Return to the original lane.

1. When the examiner issues an overtaking instruction, the first thing we have to do is to hit the left turn signal in advance, and at the same time observe the rear vehicle through the rearview mirror. When preparing to overtake, use your left turn signal while watching behind you. If the current traffic conditions are not suitable for overtaking, give up overtaking and look for another opportunity.

2. After the time is ripe to signal the vehicle in front, the horn prompts the vehicle in front, and if there is a sign prohibiting honking, it should be changed to alternately change the distance and near lights. If the horn is forbidden on the current road section, the lights should be alternately changed to alert the vehicle in front.

3. Downshift and speed up, pay attention to the rear traffic conditions, confirm the safety of the overtaking line, step on the accelerator pedal deeply after reducing one gear, and overtake the car from the left side of the car in front, and keep a safe distance from the overtaken vehicle when overtaking. After confirming safety, the overtaking time is shortened by downshifting and speeding up.

4. After returning to the original lane and overtaking the vehicle, you should keep the speed and continue to move forward for a while, and observe the rear through the right rearview mirror. After confirming that it is safe, turn right and drive back to the original lane.

Photo by Pacific Automobile Network Q&A).

What are you most worried about in the third year of junior high school? Many students said that they would be nervous if they wanted to overtake, and it was easy to lose points when overtaking. So when I was young, I sorted out some overtaking knowledge, hoping to help the students who are about to participate in the third session.

First of all, overtaking should be downshifted to speed up. It is generally understood that the high gear is faster, so on the way to overtake will move up to first gear. In fact, the forward movement of the vehicle is achieved by the torque exerted by the engine. The high-gear torque is small, the throttle response is sluggish, and the acceleration is quite slow.

When overtaking, the car should slow down one gear and then overtake at full speed on the throttle. Although the engine speed is a little higher and the noise is a little louder, the distance to overtake is shorter, and the time required to overtake is also shorter. In the case of an automatic transmission, at this point, simply press the throttle to the end, and the transmission will slow down one gear, providing enough torque to downshift.

Secondly, many novices only observe the situation of the vehicle in front of them when overtaking. When they see that there is no overtaking trend ahead, they immediately change lanes to overtake, regardless of the condition of the vehicles behind them. In fact, this practice is very dangerous.

Overtaking cars can easily get rear-ended collisions with themselves. When overtaking, the driver should not only confirm that the front can overtake, but also confirm whether the car behind is overtaking, and turn on the turn signal in advance. When overtaking and merging, he should pay attention to driving the necessary safety distance before returning to the lane to prevent the overtaking vehicle from being scratched.

Finally, when overtaking, it is important to grasp the timing of overtaking and make accurate judgments, especially on some narrow two-way roads. If you are likely to encounter oncoming traffic during overtaking, do not overtake. Driving on undulating roads and mountain roads, where there is a slope top, due to the obstruction of the slope top, we cannot see if there is an oncoming car on the opposite side, becoming a blind spot.

At this time, we should not overtake to avoid colliding with oncoming cars.

Millions of car purchase subsidies.

The correct way to overtake in subject 3 is to confirm whether there are overtaking conditions after hearing the voice prompt "Please complete the overtaking action"; When overtaking, you should first turn on the left turn signal (more than 3 seconds), approach the left side of the front car, and honk the horn to notify the car in front, confirm the safety and the car in front of you to overtake, accelerate and keep a certain lateral distance with the overtaken vehicle, and overtake from the left side; After overtaking the vehicle in front, do not turn the steering wheel sharply to the right, and maintain the speed when overtaking; When you exceed the overtaken vehicle by 20 meters, turn on the right turn signal (more than 3 seconds) and drive back to the original lane. Subject 3 Precautions for overtaking: When overtaking, slow down and honk (in areas where honking is not prohibited), pay attention, stay vigilant, and keep a large lateral distance.

Be prepared to brake urgently at any time to prevent the vehicle from suddenly starting into the lane and causing a collision, or the driver suddenly opening the door and getting out of the car. Especially when overtaking a bus that stops at a station, you should pay more attention to the sudden appearance of pedestrians crossing the road. If you find that there is an obstacle on the left side of the road or the lateral distance is too small and there is a possibility of squeezing, try not to use emergency braking to prevent a sideslip collision due to the arching of the road.

You should stabilize the steering wheel and not turn it from side to side. In the shortest possible time, keep a proper distance between the vehicles, and then wait for the opportunity to overtake. Never risk forcibly overtaking.

The correct way to overtake is as follows:

1. First hit the ruler Minbu left turn signal.

When the examiner takes the trillion to give the overtaking instruction, the first thing we have to do is to turn the left turn light in advance, and at the same time observe the rear vehicle through the rearview mirror, at this time, we should pay attention not to leave the driving direction for too long, and should pay attention to the changes in the traffic situation ahead at any time.

When preparing to overtake, use your left turn signal while watching behind you. If the current traffic conditions are not suitable for overtaking, give up overtaking and look for another opportunity.

2. Honk the horn to prompt the vehicle ahead.

When the time is ripe, the horn should be honked to indicate the car in front, and if there is a sign prohibiting honking, the way should be changed to alternately change the distance and near lights.

If the current road section prohibits honking, it should be changed to Lingsui to alternately change the distance and near lights to remind the car in front.

3. Downshift and speed up.

Pay attention to the traffic conditions behind to confirm the safety of the overtaking line, step on the accelerator pedal deeply after reducing one gear, and overtake from the left side of the car in front of you, and keep a safe distance from the overtaken vehicle when overtaking.

After confirming safety, the overtaking time is shortened by downshifting and speeding up.

4. Return to the original lane.

After overtaking the vehicle, keep the speed and continue to move forward for a while, looking behind you through the right rearview mirror. After confirming that it is safe, turn right and drive back to the original lane.