-
Anonymous users2024-02-111. The damming you are talking about is called muffled.
Muffled sound is a very muffled sound, a kind of electric guitar effect, which is very common in rhythmic electric guitars, and you just have to play it with the edge of your right palm lightly pressed on it, don't get too far from the bridge, and then you turn on the effects and the speakers will produce this muffled effect.
2. C5 D5 requires the tip of the index finger to touch the six strings to silence (also called sound control), as for the index fingertips to silence the 12 strings, this is not much particular In short, as long as you open the speaker to play, as long as there is no noise, this is right.
High Position C5: Well, yes, you can also use the palm of your right hand to caress to silence the sound, and both hands can do it as long as there is a murmur elsewhere.
3. Last question: You said that some tutorials play strong chords, some play three, and some play two.
It's actually all the same The basic composition of the strong chord is the root note + the upper fifth, which is to play two strings.
Root note + upper fifth tone + upper octave, this is to play the three strings (the third string is one more root octave than the second string, which is the meaning of 1 5 + treble 1, so that you can listen to it for yourself, its advantage is that the sound is strengthened by more root notes, and the image is fuller and thicker, warmer.
There is no such thing as playing four powerful chords at the end.
-
Anonymous users2024-02-10There are left-handed and right-handed sounds.
Based on the description of your problem, my understanding is that you have a problem with the damping when you play the rhythm, and if you are playing the downward pluck, you only need to pluck the two strings, and you can use the edge of the palm of your right hand to dampen the sound.
Hope it helps.
-
Anonymous users2024-02-09Make a sound with the outside of the palm of your right hand.
-
Anonymous users2024-02-08The sounding technique is divided into left and right hands: left-handed sounding is mainly used to close the chord, and the hand holding the string (mainly the fingers that are pressed horizontally) is relaxed to make it float lightly on the string to achieve the effect of damping;
The right-hand sound is divided into palm sound control and plucking sound control (skipping tone), and the palm finger sound is pressed on the string with the palm belly (thenar) to make the string stop vibrating; Pulling sound refers to pressing the plucking piece on the string immediately after playing a note, which can make a "click" sound. In solo, damping can be done with the left and right hands, with the left hand for the treble strings and the right hand for the bass strings.
-
Anonymous users2024-02-07Damping is also called silence. It is to touch the strings lightly with your fingers so that the strings stop vibrating, so that the sound of the strings will stop abruptly. You can either silence the left hand or the right hand, depending on the need to play. The left hand is silenced with fingers, and the right hand is generally silenced by the palm of the hand.
-
Anonymous users2024-02-06It is to let him stop and continue to pronounce the sound, and divide the left-hand and right-handed sounds, and the left and right tones are mainly released immediately after playing, so as to achieve the purpose of sounding (mainly used more when strumming the strings).
The principle of right-hand damping is that the right hand touches the part of the bridge and the bottom of the palm touches the strings (after plucking) to achieve the purpose of damping.
-
Anonymous users2024-02-05The tuning of an electric guitar is to ensure that the pitch of the individual strings matches the required standard pitch. Here's an easy way to tune an electric guitar:
1.Use a tuner: Purchase an electronic tuner, which can be a standalone device or a mobile app. Connect the tuner to the electric guitar and adjust the pitch of each string one by one according to the instructions on the tuner.
Keep the tuner in a silent environment and make sure it can hear the tone you play clearly.
Pluck the string and the tuner will show the pitch of that string.
2.Adjust the pitch of the strings:
If the tuner shows a low pitch, use the tuning keys to adjust the tension of the strings upwards until the correct pitch is reached.
If the tuner shows a pitch deviation, use the tuning key to adjust the tension of the strings down until the correct pitch is reached.
3.Double-check: After adjusting the pitch of each string, you can play the open string multiple times or use a chord to make sure the pitch of the individual strings matches and remains stable.
Keep in mind that tuning depends on personal preference and needs. The standard guitar tuning is EADGBE (from bass strings to treble strings), but there are other non-standard tunings.
-
Anonymous users2024-02-04Summary. The electric guitar has been run-in, and the steps for tuning are as follows: 1. Check the equipment of the electric guitar
Inspect the adjusters, strings, bridges, and fretboards of your electric guitar to make sure they are not damaged; 2. Check the sound quality: check the timbre of the electric guitar, the adjustment range of the adjuster, whether there is any abnormal sound, and whether there is resonance; 3. Adjust the strings: first twist the strings to the required tension, and then calibrate the bridge height so that the strings are parallel to the fretboard to achieve the best sound quality; 4. Adjust the pickups:
Adjust the height of the pickups for the best sound quality; 5. Adjust the gain: adjust the gain according to the actual situation to make the volume the best; 6. Adjust the volume and timbre: adjust the timbre of the electric guitar to achieve the best timbre; 7. Calibration regulator:
Adjust the adjuster to achieve the best tuning. With the above steps, the electric guitar is ready to be tuned. When tuning, be careful not to over-adjust to avoid damage to your electric guitar.
The electric guitar has been run-in, and the steps of tuning are as follows: 1. Check the equipment of the electric guitar: check the adjuster, strings, bridges and fretboard of the electric guitar to ensure that they are not damaged in any way; 2. Check the sound quality
Check the tone of the electric guitar, the adjustment range of the adjuster, whether there are any abnormal sounds, and whether there is resonance; 3. Adjust the strings: first twist the strings to the required tension, and then calibrate the bridge height so that the strings are parallel to the fretboard to achieve the best sound quality; 4. Adjust the pickup: adjust the height of the pickup to get the best sound quality; 5. Adjust the gain:
According to the actual situation, adjust the gain to make the volume the best; 6. Adjust the volume and timbre: adjust the timbre of the electric guitar to achieve the best timbre; 7. Calibrate the regulator: adjust the regulator to achieve the best tuning effect.
By pressing the keys above, the electric guitar can be tuned. When tuning, be careful not to over-adjust the electric guitar, so as not to cause damage to the electric guitar.
The electric guitar has been honed by the owner, can it only be broken back by professionals?
Yes. There is no other way.
Re-tune and re-tune.
That's going to be re-run-in, isn't it?
Uh-huh. How long will it take to get it back?
It won't take long. 30 minutes.
Is there a difference between the broken back and the one that has been run-in?
Yes. Will the difference be significant.
Not big.
-
Anonymous users2024-02-03Sound control is when the strings have not yet been recorded, and there is sound control, which is also called silence. It is to touch the strings with your fingers so that the strings stop vibrating, so that the sound will stop. You can either silence the left hand or the right hand, depending on the need to play.
The left hand is silenced with fingers, and the right hand is generally silenced by the palm of the hand.
When it is fully vibrate, it goes to stop the strings, and the sound it produces is a "cut tone" that is not crisp and bright, and it makes a "puff rotten hand" sound. The standard notation for muffled sounds is m.
Press the bottom of the palm of your right hand against the string near the saddle so that the string does not reverberate. The damping has an absolute pitch, and you can't press the strings too far from the saddle or push too hard.
Many people and even guitar teachers will have the idea that when you play, you will play which chords are composed of chords, so that you must not go wrong, and it is the introduction to practicing improvisation! It sounds plausible, and it makes sense in terms of improvisational music theory! But my more than 10 years of teaching experience has taught me that improvisation like this can seriously undermine students' confidence and drive them down! >>>More
The string guard and the silence, the damping and the muffling of the electric guitar are related but there are many differences, the string guard and the silence are two different concepts, the string guard refers to the protection of other unplayed strings before playing, to avoid accidentally touching them and making noise, and the silence refers to the elimination of the afterglow after playing. Of course, both work must be done together during the playing process. >>>More
Everyone is right, first practice the piano Don't be anxious when you encounter a problem, calm down and think about how to solve it. The landlord said that looking at the complex score to listen to it once to find the rhythm, it proves that it is not that you have a sense of rhythm, but that you have not yet understood the time value reflected in the rhythm of the beatmap, in fact, you are not familiar with it, the solution is very simple, when practicing a new tune, don't be in a hurry to get the score to play, that is not efficient, first read the score carefully, find out the difficulties that you think need to be paid attention to, split it according to the bars, and first beat the rhythm by hand, which is very important, Many people are roughly calculated in their hearts, in fact, the effect can not reach the expected goal at all, so when looking at the new score, play the rhythm first, arrange the finger shape in a simple way, and then start practicing, when you encounter a problem, you will pass a small section, don't worry, so that the accumulation of time, you can't improve it, practice makes perfect, come on, the landlord.
Ah, actually.
Both kneading strings can be used, but the effect varies depending on the guitar. >>>More
Electric guitar recording is generally divided into two ways: internal recording and external recording. >>>More