What is the car s chassis What is the impact of a car chassis leakage

If the piston is installed with anti-8, the ring will be broken, first check the K bar [ring open A port o on the opposite side of the exhaust 7 port F], not l over your problem may be the intake 1 cut x seal, or the oil seal leaks 0 ub

1. Air filter.

2. an engine.

3. Engine radiators, electronic fans, and air conditioning condensers are all here.

4. Wiper motor.

5. Brake booster and brake pump.

6. Antifreeze compensation water tank.

When there is a lack of antifreeze in the engine radiator, it can be replenished in time. It is generally not recommended to add water (with a thin pipe connected to the water tank), as the water is easy to rust and scale to block the waterway. In winter, the ice also froze, and the tank and engine burst.

Unless the antifreeze leaks during the drive, add water for emergency, and it is best to add antifreeze for troubleshooting. Don't mix them either.

<> couldn't find a clearer picture. I'll draw a few circles and tell you about it. 1. Air filter.

2. Engine (there are many things on it, the picture is too small to draw). 3. Engine radiators, electronic fans, and air conditioning condensers are all here. 4. Wiper motor.

5. Brake booster and brake pump. 6. Antifreeze compensation water tank. 7. Fuse box in the engine compartment.

8. a battery. 9. a glass water tank. There are many other things, so I won't draw them.

The impact is very intuitive, it costs oil, and there are safety hazards.

There are usually several reasons for oil leaks:

1. Valve oil leakage, valve oil leakage is generally because the valve is blocked or damaged, and the solution is to replace the valve.

2. The joint is loose, and the solution is to tighten the joint or replace the joint.

3. That is, you have problems with the pump and hydraulic oil pipe.

Are you so dead? If there is less, it can be repaired by sheet metal, and it has no effect, and if there is more repair, it will not be repaired well.

The baler, also known as the strapping machine, taping machine or strapping machine, uses strapping to bundle products or packs, and then tightens and combines the two ends by hot melt bonding with a hot hot iron. The function of the baler is to strengthen the packaging items, so that the items will not be scattered due to poor bundling during handling and storage, and they should also be bundled neatly and beautifully.

The water tank is a small expansion tank, the pipe heat dissipation, the oil tank is naturally filled with oil, and the last is the oil pan is the oil tank is the oil tank, which is the industry term.

The water tank is filled with water, the fuel tank is filled with gasoline, and the chassis is filled with engine oil.

Yes, 12V voltage is about 5-10A.

You can only spray paint or touch up the paint, and if you don't touch the primer, you can also throw a light!