After formatting, you can t enter the system, and the black screen always shows Invalid system disk

Updated on number 2024-05-16
8 answers
  1. Anonymous users2024-02-10

    I definitely can't get in, hehe, how can I get in without a guide area.

    Reinstall the system.,If you can't set the CMOS, q me:79534950

  2. Anonymous users2024-02-09

    This means that the system has not been found.

  3. Anonymous users2024-02-08

    To be more detailed, how to format a C drive? dos?

    If you format the hard drive, it will not affect the boot of the CMOS.

  4. Anonymous users2024-02-07

    invalid system diskļ¼Œreplace the disk and then press any key

    If the system disk is invalid, replace the disk and press the All keys.

    How did you format a C drive?

    In disc format, right?

    Since the prompt is an invalid system disk, this is because you have already started the system on the disc, but your disc has already been taken out. Your C drive is up again. I can't find the system disk.

    You can find a system disk to reinstall it.

    When you turn on your computer, you can see several prompt keys below, what key to press to enter CMOS, what key to press to start items, and so on. You can set it up in those places.

  5. Anonymous users2024-02-06

    It is estimated that important files have been deleted, so that the system has been damaged, and the system needs to be reinstalled. Enter the CMOS and press the hotkey, usually the DEL key, check which key is used to enter the CMOS on that machine. Is the keyboard responding?

    The error message is to the effect that the system disk is invalid, replace it and press any key to continue. This phenomenon may occur due to the system boot file (missing or corrupted, booting with a floppy disk, executing sys a:

    C: Command to pass the system boot file to drive C for troubleshooting.

    Invalid system disk --- replace the disk and then press any key -- Please replace this disk, please press any key.

  6. Anonymous users2024-02-05

    The partition where the system is located cannot be found. The simple point is that the system collapses! Let's install the system.

  7. Anonymous users2024-02-04

    It means that the system disk is invalid, and the only way to reinstall the system is to reinstall it.

  8. Anonymous users2024-02-03

    If the system disk cannot be found, try to rebuild the MBR partition.

Related questions
7 answers2024-05-16

This is caused by improper operation of the USB flash drive, the original file system is corrupted, manifested as unable to open (a few can be opened, can see the files inside, but will show write protection, can not be operated), can not be formatted, as far as I know, can only be re-produced through mass production tools. It is recommended that you first use the software chipgenius to test what type of chip your USB flash drive is, and then go to the Internet** a corresponding mass production tool to reshape or low the level of mass production to achieve the factory setting, this will be more troublesome, but no way, I hope you can succeed! >>>More

4 answers2024-05-16

Formatting, simply put, is to divide a blank disk into small areas and number them for storage on the computer, right-click on the disk Format (a)... >>>More

13 answers2024-05-16

invalid system disk inserted into the system disk.

replace the disk,and then press any key. >>>More

4 answers2024-05-16

How to recover computer hard drive that is formatted.

5 answers2024-05-16

If you delete the original partition and repartition it, and then just format the disk and reinstall the system, the data in the partitions after the C drive still has a greater hope of recovery (the C drive is very difficult, because it has been overwritten by the new data - reinstall the system). >>>More