-
Anonymous users2024-02-11The Honda Mirage 150 run-in period is over after about 1000 kilometers.
A few points to pay attention to during the motorcycle run-in period:
1) After each driving, it must be used for cloth wiping, and it is clear that if it rains, it should be cleaned of rainwater in time to prevent rust.
2) Check whether the electrolyte of the battery meets the standard (10 mm to 15 mm higher than the plate), and when it is not enough, distilled water can be used to replenish it.
3) Always check whether the tire pressure is normal, and pump in time when the air pressure is too low, otherwise it will increase unnecessary fuel consumption and wear on the tire.
4) Regularly inspect the front and rear axle nuts, rear shock absorbers, and license plate screws; Whether the nut is tightened or a series of key parts of the fastener.
5) After each trip, check whether the rear chain is normal and must be adjusted when it is too loose.
6) Lubricate the front and rear brakes, rocker arms, clutch grips, directional knob bearings, etc. regularly. (7) Check whether the horn, light switch and light bulb are normal before each trip.
8) Replenish fuel and replace the specified number of lubricating oil in a timely manner, and the replacement time shall be in accordance with the instructions for the run-in period of the newly purchased motorcycle.
The factors that affect the service life of motorcycles, in addition to the quality of the product, are also related to the method of use: first, the quality of the run-in, and secondly, the daily use and maintenance. Although the run-in period of the new car is short, and the run-in mileage accounts for a small proportion of the whole service life of the car, the quality of the run-in has a crucial impact on the future service life.
During the run-in period, measures such as limiting speed, reducing load and strengthening maintenance can reduce the amount of wear and tear of parts and prolong the service life of the motorcycle. During the run-in period of the new car, in addition to driving in strict accordance with the requirements in the instruction manual, it should also be "one sufficient, one strict, three control, three services".
"One full" is to fully warm up. After fully warming up the engine, start again, first drive 1 2 kilometers in low gear, and then switch to high gear. "One strict" is a strict oil blending method.
The proportion of two-stroke mixed lubricated motorcycle fuel is very important, and the fuel should be mixed evenly in a special container according to the requirements of different oil blending ratios in different periods, and the mixed fuel should be filtered.
The "three controls" are: 1 Control the speed. Running-in is carried out in strict accordance with the different speeds specified in the instruction manual.
2 Control overload. During the run-in period, the maximum load capacity of the control car is less than 1 2 of the load, and the flat road surface is selected. 3 Control time.
Avoid running the engine for too long. Stop for a break every 15 minutes over 500 km and every 30 minutes for 500 1500 km.
"Three diligence" is: 1. Frequent cleaning. Always keep your vehicle clean and tidy.
2. Check frequently. Check whether the lubrication part is fully lubricated, and check whether the engine, gearbox and brake device are overheated. 3 Change the oil frequently.
Change the lubricating oil frequently, so that the metal chips generated during the running-in process can be taken away in time.
-
Anonymous users2024-02-101000 km is over, within 1000 km the speed should not exceed 6000 and it will be fine.
-
Anonymous users2024-02-09u āb 咯郄tisd z 酡o b 咯郄j
The speed of each gear can be controlled at about 8000 rpm 2x, the acceleration should not be too strong, and it is best to run in with light load.
-
Anonymous users2024-02-08Hello, it is a pleasure to serve you and give you the following answer: The reasons why the Honda 150 Phantom has not been upgraded may be: 1
Insufficient memory space: The memory space of the Honda 150 Phantom may no longer be enough for new features and software, so it can't be upgraded. Workaround:
1.Use a cleanup tool: You can use a cleanup tool to clean up unnecessary files in your system files and free up memory space to accommodate new features and software. 2.
Replace memory: If memory space is still insufficient, consider replacing it with a larger capacity to accommodate new features and software; 3.Using External Storage:
If you're still running out of memory space, consider using external storage to store some files and software that you don't use frequently in an external storage device to free up more memory space. Personal Tips:1
Regular cleaning: Unnecessary files in the system should be cleaned up regularly to free up memory space, so as not to affect the normal operation of the system. 2.Install the software properly:
When installing new software, you should take into account the size of the memory space to avoid system crashes; 3.Regular backup: Important files should be backed up regularly to avoid data loss due to system failure.
Walk for an hour or two a day, control the throttle below 2500 rpm, turn the steering wheel and don't hit the end, it's almost good, my 3000 one. >>>More
It's not normal, right?,At least I still think there's something wrong with your relationship.,It shouldn't be like this.,It feels like she doesn't care about you very much.,It doesn't seem to be a little too financially managed.,Don't pay attention to it.,In fact, boys don't need too much in love.,It's just some care for girls and the like.,But I don't think these can be reflected from what you said.,Maybe there's just that you don't remember.,Because people sometimes treat things bad.,Especially if someone else is bad.,Special.""Actually, think about it, she won't love you, or rather. I don't love you so much, or rather, that's not love, in fact, sometimes this doesn't happen if you love someone, so you should reflect on whether this love is still necessary. >>>More
1: Do not let the engine speed be too high.
The run-in period is the process of engine grinding and grinding, too high speed will damage the surface of the uneven axle, so we should pay more attention to the engine speed, no matter how many gears, the speed should not exceed 3000 rpm, such as automatic transmission should not exceed 3500 rpm. >>>More
For the car run-in period, it generally refers to the car from the time the store is proposed. After the new car leaves the factory, the parts work is not smooth enough, and if it does not go through a period of running-in, the wear and tear of the car will be intensified.
Usually 3000 kilometers for the first insurance, after the first insurance every 5000 kilometers to change the oil. The problem of quality during the run-in period is straightforward. However, during the run-in period, the speed should not be higher than 80km h, and it is best not to accelerate sharply, and it is best not to brake suddenly.