Pay attention to those during the break in period of automatic transmission cars

How does a new car run in? Hello, let me ask you this question: 1. The run-in period is generally divided into three stages, the first stage is generally considered to be 0-1000 kilometers, that is, this stage should keep the speed can not be too high, generally not more than 80 yards is appropriate, the speed can be initially run-in in this period, basically 0-4000 rpm should be properly run-in, and the throttle should not be too heavy.

2, the second stage of 1000-3000 kilometers, this period, the speed can still not exceed 80 yards, the speed continues to run-in, the throttle can be appropriately added some kilometers - 5000 kilometers, during this period can be the first insurance, the first insurance after the high-speed, that is, between 80-120 or 130 yards, each speed of the car can be used at a constant speed for more than ten minutes, at this time the throttle can be used as much as possible, there is no clear requirement for the speed, personal recommendations do not exceed 4500 revolutions. 4. The time of the first insurance can be carried out within 5000 kilometers after 3000 kilometers. 5. Pull the high-speed, 1 time 2 times is enough, there is no need to go to Dora, I personally recommend to do the first insurance, and then pull the high-speed, of course, there are also 4S recommendations to pull the high-speed first, and then do the first insurance, in fact, they are all the same.

If my answer is helpful to you, please set it to.

Do not exceed 1,0-1000km for 60km hours. 1000-3000km do not exceed 80km hour. 3000-5000km should not exceed 100km hour.

It is best not to carry other passengers within the kilometer, and try to carry as few passengers as possible within 5000 kilometers after 1000. 3.Generally, the 4S shop will change the new car for free at about 1500 kilometers (depending on the manufacturer, the number of kilometers is slightly different), and the engine oil is once, don't miss it.

4.When starting the car, pay attention to slow acceleration, do not accelerate sharply, and do not have operations that overload the engine such as trailers. 5.

Pay attention to the reduction of fuel, lubricating oil, coolant and other fluids at any time, leakage and other problems, and deal with them in time. 6.If it is a cold area, try to avoid low temperature and cold start.

7.After the period, it is also necessary to change the three worries regularly, and the common practice is to change the oil for 5,000 kilometers. 8.

If you find that there are problems such as rudder, deflection tire, sieve rudder, etc., immediately do four-wheel alignment and tire dynamic balancing. 9.Now that fuel is skyrocketing, it is recommended to maintain an economic speed of 80 km/h on a regular basis to make the most cost-effective.

And be sure to fill the fuel according to the label required by the manufacturer.

In the run-in period of the new car, the engine speed can not be too high, the speed of 60-90 kilometers per hour is ideal, there should be a process of heating the car when cold starting, and then drive on the road after the water temperature changes, do not rush to refuel, brake sharply, try to maintain a constant speed, the maximum speed of the vehicle should not exceed 100 kilometers per hour, but also do not drive at low speed for a long time, do not overload people! Satisfied.

1. Start warming up:

Start-up warm-up actually gives the engine enough time to lubricate, especially for owners who buy turbochargers, and warming up during the break-in period is not negligible. The recommended warm-up time for turbocharged models is at least one minute.

2.Smooth start:

Start the engine smoothly. If the vehicle starts fast or brakes suddenly, it is easy to cause abnormal wear and tear of the relevant parts of the vehicle, which is not conducive to the normal running-in of the vehicle. In the later stage, it may increase the maintenance cost of the owner, and the start is stable and the acceleration is slow, which can make the engine have a better adaptation process.

3.The speed of the starting machine should not be too high:

During the break-in period, the speed of the new car should be properly controlled. If the engine speed is higher, the load intensity of the engine will be greater, and the damage to the engine will be greater. Generally, when the first 500 kilometers of a new car, it should not exceed 80 kilometers and hours, and avoid high-speed driving.

4.Don't keep a piece of gear for a long time:

During the run-in period, the new car should pay attention to the gear run-in. When driving a manual transmission car, try to run in every gear, which can increase the coordination of all parts of the car transmission. If you drive an automatic transmission car, you need to control different speeds to run in the transmission and engine.

5.Don't drive heavily :

Driving a new car with heavy loads can cause some damage to the engine. The greater the load on the car, the greater the wear and tear on the engine. The lighter the car during the break-in period, the better. The first 100 km of a new car is the best to drive with no load.

6.Reduce the frequency of emergency braking:

The emergency braking of the new car during the run-in period will have a certain impact on the chassis and engine of the car, so try not to brake suddenly while driving, release the accelerator in advance, and slow down.

7.Don't drive for a long time as soon as you start driving:

Generally, when the new car is sleepy in the run-in period, do not drive for a long time or run long distances. Starting and stopping a new car is a better run-in method, and long-term driving will wear out the car engine to a certain extent.

Millions of car purchase subsidies.

1.Initial run-in.

500 km is the initial run-in. At this time, the speed should not be too fast, generally below 70-80 km, and the speed should not exceed 2200.

2.Medium-term run-in.

50-1000 km is the middle run-in, the maximum speed can be appropriately increased, generally up to 90-100 km, and the speed below 2500 rpm is better. Appropriately increasing the speed not only has an impact on the engine, but also has a promoting effect on the running-in, and then increase the speed to see if there is any abnormality.

3.Post-run-in.

1000-1500 km is the late run-in, and the speed can be increased to less than 120 km. Because running-in is a step-by-step process, it must be gradual. Do not exceed 3000 rpm.

4.Step by step.

During the run-in period of the new car, it is best to turn to 2nd gear after each key insertion, and wait for 10 seconds before ignition, so that the oil pressure and fuel injection volume inside the new car can be fully adjusted to maximize the engine time.

When all cars are driving at low speeds, the actual load is greater than driving at medium speeds. Therefore, the run-in period should not be lower than 60 km h for a long time. The speed must be gradually increased.

At the same time, if you run the run-in period at a speed of 80 km h, the sudden acceleration will make the new car uncomfortable. Therefore, it is necessary to gradually increase the maximum speed during the run-in period. In addition, do not drive at a fixed speed for a long time during the run-in period, but drive at a variable speed.

5.Avoid sudden braking and emergency stops.

Avoid sudden braking and acceleration during the break-in period. Automatic transmission cars, because it is not possible to decide to drive in a specified gear by manual transmission, so it can only be achieved by driving speed.

In short, the run-in should be driven at a constant speed, and the run-in must be stabilized at the level of 30km h, 60km h, 80km h, and 100km h. The completion of the run-in period can be said to be a post-"manufacturing" process for the car. After running-in, the car has strong power, the parts are running normally, and the machine life is longer; Otherwise, the grinding is not good.

The precautions for the run-in period of the new car for automatic transmission are as follows:

500 kilometers is the initial run-in, at this time the speed should not be too fast, generally 70-80 kilometers below, the speed is not more than 2200 revolutions.

1000 kilometers is the mid-term run-in, the maximum speed can be appropriately increased, generally can reach 90-100 kilometers, and the speed is still below 2500 rpm. Increasing the speed appropriately will not only not affect the engine, but can promote the running-in, and you can see if there is any abnormality when the speed is increased again.

1500 kilometers is the later run-in, and the speed can be increased to less than 120 kilometers. Because the run-in is a gradual process, it must be gradually increased. The speed should not exceed 3000 rpm.

4. When all cars are driving at low speed, the actual burden is greater than that of medium speed, so the run-in period should not be run in below 60 kilometers per hour for a long time. The speed must be increased gradually. At the same time, if you have been running at a speed of 80 kilometers per hour after the run-in period, a sharp increase in speed will make the new car unadaptable, so it is necessary to gradually increase the maximum speed during the run-in period.

5. Do not drive at a fixed speed for a long time during the run-in period, and there should be a speed change.

6. Avoid sudden braking and rapid acceleration during the running-in period.

In the run-in period of the new car, the engine speed can not be too high, the speed of 60-90 kilometers per hour is ideal, there should be a process of hot car when cold starting, and then drive on the road after the water temperature changes, do not rush to refuel, brake, try to maintain a constant speed, the maximum speed of the vehicle should not exceed 100 kilometers per hour, but also do not drive at low speed for a long time, do not overload people.

Blue Sky Regarding your question, new cars should avoid high-speed driving, long-distance driving and full-load driving; You need to pay attention to the following points during the run-in period of a new car:1The engine speed should not be too high, preferably not more than 3000 rpm.

2.There should be a hot car during the cold start, and the water temperature changes before driving on the road, generally about 5 minutes. 3.

The load must be reduced according to the load regulations of the model, and it is advisable not to exceed 70% of the specified load capacity. 4.The impact damage of the sudden braking to the engine, braking system and chassis of the new car is very large, and the situation should be dealt with in advance during driving, and the deceleration and gear reduction should be reduced.

5.Avoid sudden refueling and braking, and try to maintain a constant speed. The maximum speed within 2000 kilometers should not exceed 90 kilometers per hour, but it is not possible to drive at low speed for a long time.

6.According to the time and mileage specified by the manufacturer, go to the 4S store for the first insurance.

Nothing special, just don't exceed 3000 rpm.

In Ningbo to get a driver's license, excited to start their own car life, but the new automatic car fuel consumption is very large, consult professionals to know, the new car in the run-in period will be larger than usual fuel consumption, because the new parts friction resistance is relatively large, so fuel consumption will be relatively high.

So how to drive a good car during the run-in period?

Experts say that improper use of the new car during the run-in period will cause damage to the engine, and the fuel cost is a matter of course. Don't let the engine rev too high while driving. It's best not to stay in one gear or drive in low gear for long periods of time.

In the process of adapting to the new car, it is necessary to gradually increase the maximum speed during the run-in period. It should be noted here that the automatic transmission car, because it cannot be manually shifted to determine the run-in specified gear, so it can only be achieved by driving speed.

When driving, the body should not be overloaded. Don't put boxes, clothes, books, piles on them. The lighter the body during the break-in period of the new car, the better. And, it's best to avoid driving the car for long periods of time. Doing so will accelerate the aging of parts and components, which is very harmful to new cars.

Don't drive with a full seat, pay attention to the cold car after starting, idle in situ for about 30 seconds, (do not idle in place for a long time to warm the car) can drive, (the water temperature does not reach more than 2 grids, the speed should not exceed 3000 rpm, which will bring irreparable mechanical wear and tear).

Do not keep the normal driving speed above 3000 rpm for a long time (the best speed is within 100 per hour).

The other is to use the gearbox gear correctly, and don't hang on the forward gear all the time when waiting for the traffic light, you can hang into the n gear, pull up the handbrake and other traffic lights.

Pay attention to the engine speed should not be too high, try to avoid full load, etc.!