How to clear the garage roller shutter door, West side C600

West Side C600 garage door motor installation and debugging remote control of the code and clear.

1. Control board layout diagram.

2. Power-on indication.

Turn on the power supply, and the code light, running light, and status light flash three times at the same time, indicating that the program is working normally.

3. Match and clear the code of the remote control.

Press the code key for more than 1 second, and the code light will light up at this timePress any key on the remote control, then release, press this key again, the code light should flash quickly, and after the code light goes out, the remote control learns successfully.

If you need to learn another remote control, you can repeat the operation according to the steps, and this main control board can learn up to 20 remote controls.

Clear the remote control: Press and hold the code key, the code light will be lit, after more than 8 seconds, the code light will be turned off, and all the stored remote controls will be cleared.

Recommendation: If the remote control is lost, you need to clear all the remote control and then relearn it to be safe.

4. Learning of upper and lower limits.

Press the setting button on the control panel, at this time the running light starts to shine, press and hold this button for more than 2 seconds, the running light becomes solid, and then the program enters the learning process of opening and closing the door stroke and overload force.

Press the increase button, at this time the motor begins to run in the direction of opening the door, press and hold, the motor runs continuously, and the running indicator light flashes at the same time, indicating that the motor is running upward. Release the button when the ideal position is reached, and the motor stops runningIf you press the reduce button, the motor wants to run in the direction of closing the door, and the status light is flashing. Use these two buttons to adjust the position of the upper limit.

Note: If the motor runs downward when the increase button is pressed, it means that the motor output line is connected incorrectly. In this case, it is only necessary to simply change the motor output cable.

If the position of the upper limit is adjusted appropriately, press the setting button once, and the running light will flash quickly and then turn off, indicating that the upper limit learning is completedAt the same time, the status indicator lights up, and the program enters the lower limit learning process.

Use the two keys of the increase key and the decrease key to adjust the lower limit position, after reaching the predetermined position, press the setting key until the status light flashes and let go, and the status light goes out to indicate that the limit learning is completed. (Note: You must learn the upper limit first, and then learn the lower limit).

It's very simple, press and hold the code button on the control board and don't let go, release it after about ten seconds after the indicator flashes, and then try it with the remote control, if the control board can't be remotely controlled, it means that the code is cleared successfully.

Once the Seaside Maple Leaf 600 remote control is set, the overnight remote control will not work, and who knows why.

Hello friends, press the code button for more than 1 second like burning, at this time the code light is on; Press any key on the remote control, then release, and then press this key again, the code light should flash quickly, and after the code light is turned off, the remote control learns successfully. The door body of the roller shutter door is made of high-quality stainless steel and other materials, and the parallelogram principle is used for handover, which is flexible and telescopic. The drive is driven by a special motor, the worm gear is decelerated, and a manual clutch is provided, which can be opened and closed by the rubber next to the hand when the power is off.

The roller shutter door is a telescopic shed lattice type, which has the characteristics of stable opening and closing, perspective door body, and small space occupation after opening. Hope it helps!