Which is better, CAD or PLC, and which CAD brand is easier to use?

1. What major do you tend to? Electrical or mechanical?

2. Electrical major: CAD draws electrical drawings, PLC compiles programs, and the two are combined, and a complete control system comes out. Therefore, if you learn CAD and PLC well, your future will be better.

3. Mechanical major: choose CAD to draw mechanical drawings. Because PLC is an electrical major, it has nothing to do with machinery.

First of all, these two are not comparable.

CAD is computer-aided design, which is used for drawing in architecture, HVAC, industrial and other fields;

PLC is the abbreviation of programmable controller, which is a field controller in the field of industrial automation, which realizes the automation equipment of field equipment, through which it can realize many fields such as industrial automation.

I don't know if the answer is what you need. If you don't understand, you can continue to ask.

Big brother, your question is ambiguous, you should be asking about learning CAD and PLC, which is more promising.

Let's ask which factory is not automation equipment now, it is automation equipment that needs PLC, inverter, and other things, you need to understand this area, you can go.

Place to take a look at the knowledge of PLC, which has collected 10,000 PLC e-books enough for you to learn.

CAD is drawing, PLC is controlled, and both are needed in actual work, and there is no good or bad one.

CAD is a drawing software, PLC is an industrial control system, or power cat (cable network system) is not a concept, okay?

It's like Guan Yu and fast food, which one is better?

Is there a comparison between CAD and PLC for drawing and PLC for controllers?

How can this be compared to CAD office software PLC for industrial control If you talk about the future, PLC is not starving to death, but it is difficult to climb up You think about a company and a few electrical engineers.

Is there anything to do with these two.

It's like, pig or cow, which is more delicious.

CAD versions have their own merits, and it is best to install them according to your own situation. Hole lead burning.

1. AutoCAD2004 is a classic CAD version, which is very smooth to use and many people use it. But 04 and 06 CAD file formats.

It's the same, 06 is very compatible.

The version has a sheet set function, and can be selected when cutting or extending. 04 This aspect is very weak, it is when extending or cutting a set of lines. Version 06 makes up for these shortcomings in version 04.

The version is actually OK.,It's just that it often appears that the display is garbled.。

There are also some characters that always appear garbled. There is no problem with other versions, whether they are in the lower version or the higher version, and the garbled characters have led to the fatal flaw of the 07 version.

4. The current 08 version is better if it is a high version, and there are more people who use it, and the 10 version should be good, but there are few people who use it. The 08,09 version is also very good, but it is more memory intensive, which is a little worse than the 06 version.

Of course, no matter which version you use, it is under the premise of your configuration, in general, it is recommended to use the CAD2008 version. Versions above 10 are basically very memory-hungry, and they consume more memory than some 3D design software. Computer configuration.

Low ones are not recommended to install.

If a novice just starts to learn CAD drawing, it is recommended to use lightweight CAD software, starting from the purest basic functions, such as Haochen CAD computer software, which is a lightweight CAD software, with complete basic functions, if there is a lack of clarity in the upper right corner of the interface, select help, you can click on the customer service to directly have a customer service answer, or you can dress up to view the help document, as shown in the figure below: