What are the tips for extending the life of truck tires and reducing tire wear?

The van driving method has a lot to do with tire wear. Good and proficient driving techniques can effectively reduce tire wear, prolong the service life of tires, and improve driving safety.

1.No cracks in the tread.

Regularly check the surface of the tire for cracks, deformation and other defects. The tread groove of the tire gradually becomes shallow due to driving wear, and if it is smoothed, it will lose the effect of drainage and anti-skid, and the performance of the car will be greatly reduced, and the seemingly small cracks are the hidden dangers of tire puncture at high speed. In addition, attention should be paid to removing small stones in the groove in time.

2.Parking on flat ground.

Avoid parking on rough, sharp, or sharp stones. Do not park near or come into contact with petroleum products, acids and other materials that may affect the deterioration of rubber. The driver should not turn the steering wheel after stopping, as this will accelerate the wear of the tires.

3.Don't splash water for heat dissipation.

Tires tend to overheat during long driving or high-speed driving in summer, and the air pressure increases at the same time. At this time, it should be stopped to dissipate heat, and it is strictly forbidden to deflect and depressurize or splash water to cool down to prevent abnormal aging of tread rubber.

4.Avoid braking suddenly.

Truck tires should not start too hard, and frequent use of brakes and emergency braking should be avoided to avoid accelerated tread wear due to the drag between the tire and the ground; When turning corners, overtaking, passing through intersections, narrow roads, railway crossings and other sections, you should master the appropriate speed and pay attention to the dynamics of the road, pedestrians and vehicles, prepare for braking, reduce frequent braking, avoid emergency braking, so as to reduce tire wear; When faced with unavoidable broken glass or other foreign objects, slow down and do not brake suddenly, because the pressure caused by sudden braking increases, and glass shards and foreign objects are more likely to penetrate the tire.

5.Choose a good road surface.

When driving in the highway maintenance and construction section, the method of selecting the road surface should be used at low speed to avoid the tire being overhit or even punctured or scratched; When driving on uneven roads, one must choose the road surface to reduce the impact of tires and road surfaces and avoid damage to parts and tires; Second, slow down and slow down to avoid tire bumps and strong vibrations; Through muddy sections, you should choose a more solid and non-slippery place to avoid serious cuts and scratches on the tire and sidewall caused by tire sagging, idling on the spot, and violent heating.

6.Keep the speed under control.

The vehicle should be turned according to the curved road conditions and turning radius, and generally decelerates appropriately, so as not to accelerate the wear of unilateral tires due to the action of inertia force and centrifugal force; When the vehicle goes downhill, the appropriate speed should be controlled according to the size, length and road conditions of the slope, so that emergency braking can be avoided or reduced and tire wear can be reduced; When the vehicle stops during the drive and stops at the station, it should develop the habit of sliding safely.

Michelin tires have anti-wear features and should have a long lifespan.

Timing differential tire position, four-wheel alignment.

Do not start too hard, avoid frequent use of brakes and emergency braking, so as not to accelerate tread wear due to the drag between the tire and the ground; When turning corners, overtaking, passing through intersections, narrow roads, railway crossings and other sections, you should master the appropriate speed and pay attention to the dynamics of the road, pedestrians and vehicles, prepare for braking, reduce frequent braking, avoid emergency braking, so as to reduce tire wear; When facing unavoidable broken glass or other foreign objects, slow down to pass, do not brake suddenly, because the pressure caused by sudden braking increases, glass fragments and foreign objects are more likely to penetrate the tires, relatively speaking, Michelin tires have better shock absorption and are more wear-resistant, but some choose a harder one that is not easy to be worn.

1. Check the tire pressure regularly: tire pressure is an important factor affecting the life of the tire, not too high or too low, and inflate the tire pressure according to the vehicle marking. It is important to note that the tire pressure changes with the temperature.

Affected by thermal expansion and contraction, the tire pressure will also decrease in winter, if the tire pressure is increased inappropriately, it will not only increase the fuel consumption of the car, but also accelerate the wear of the car tires.

2. Frequently remove the debris in the tread: the tire is used for a long time, and the tread is easy to be mixed with small stones, broken bricks and other debris, if these things are not removed in time, it will make you feel bumpy when driving, and the damage to the tire is great. Especially when driving at high speeds, it is dangerous to have a puncture caused by foreign objects in the tread.

Therefore, if you find small stones, you should use a key to pick them out and try to ensure that the tires are clean.

3. Check the wear and tear of tires: the traction and grip of new tires and old tires are very different, and those tires that are very worn are weak in grip and prone to skidding. Therefore, tires should be replaced in time according to wear and tear.

4. Carry out four rounds of rotation:

When the vehicle deviates or other abnormal steering, it is necessary to change the tire in time to avoid other abnormalities in the tire. The four-wheel rotation can ensure that the four tires of the vehicle are evenly stressed and avoid excessive wear.

5. Repair the tire in time: If the vehicle has nails, even if there is no air leakage, it is necessary to replace the spare tire as soon as possible, and then replace the tire with nails. Sometimes you don't need to change the spare tire before you tie the nails, let the tire repair master look at the nails first, if the nails are not big and not deep, you may not blow up the tires, so you don't need to change the spare tire.

6. Prevent kerbs and potholes: Some people like to park their cars on the shoulders, but in fact, this will squeeze the tires, which can easily cause the cord on the side of the tires to break, causing the tires to bulge. In addition, potholes on the road surface should also be avoided, because when the tire runs over the pothole, the tire will also be crushed.

The larger the potholes and the higher the speed, the more the tires will be squeezed, which can also cause the tires to bulge.

Tires usually pay attention to whether the air pressure is normal and the tire wear condition, abnormal wear can be seen, and the use time limit will be extended if the problem is solved immediately.

Hello 1

Tyre selection and installation. Correct tire installation is directly related to the service life of the tire, especially when replacing it with a new tire.

2.Operating air pressure. If the tire pressure is too low or too high, it will affect the service life of the tire. If the tire pressure is too low, its radial deformation increases, and the deformation on both sides of the sidewall is excessive, resulting in wear on both shoulders of the crown and the tire.

3.Tire load. There is no doubt that the heavier the load on the vehicle, the shorter the life of the tyres. Especially in the case of overload, it is even more prominent. The tires produced by regular tire manufacturers are marked with a load index.

4.Travel speed. The tires produced by regular tire manufacturers are marked with a speed class index. Tires should be used within the maximum driving speed corresponding to the specified speed class index.

1.Check the air pressure of all tires when cooled, including spare tires, at least once a month.

2.Do not exceed the reasonable speed required by driving conditions and legal restrictions (e.g., slow down or avoid obstacles such as rocks and potholes in front of you).

3.Regular wheel alignment and balancing is important to keep your driving safe and get the ideal mileage.

4.In order to achieve uniform wear and thus extend the service life of the tire, tire alignment is a must.

5 Prevent sun, oil, acid, and hydrocarbons from attacking tires.

6.Good driving habits need to be practiced, such as: avoid emergency braking, slamming the steering wheel, etc.

For more information, please visit.

1. Refill gas according to requirements.

2. When changing the oil every 5,000 kilometers, the front and rear cross tires are changed, and the tire working surface is worn 3. If there is a nail situation, it needs to be repaired by fire, and can not be nailed, otherwise the tire will be scrapped 4. The four-wheel alignment should be checked according to the required time, do not mess around, and keep the original car best.

5. If the vehicle is parked for a long time, the tire pressure should be higher, in, otherwise the tire will be deformed for a long time, nothing else, to tell the truth, the brake is not to control whether you want to control or not, but an instinct when people are learning to drive, this can not be changed. In addition, if there is an emergency, you will definitely not do it theoretically, but in the most safe way for yourself, right?

If the tires want to have a long service life, they should maintain the vehicle normally, do a good job in four-wheel alignment, and change positions with forward and backward for 1-20,000 kilometers, so as to avoid rapid acceleration and sudden braking at the start, and do not get on the road.

Generally, tires are replaced in 6 years or 7-80,000 kilometers.

1.In the case of cold tires, maintain the tire pressure according to the tire pressure rating standard.

2.Try to avoid exposing your tires to the sun for long periods of time.

3.Do not have bad driving habits such as high throttle and sudden braking, so as not to cause unnecessary wear and tear on the tires.

4.Try to avoid hitting the steering wheel on the spot when the car is not moving, and the tire is worn out greatly and the wear parts are uneven.

5.Try to avoid knocking on the curb and driving onto the sidewalk.

6.Remove the larger stones caught in the tread in time.

First of all, it is necessary to develop good driving habits, do not brake sharply, do not rush to hit the direction, and reduce static friction with the ground.

Check the air pressure frequently and clean up the debris inside the tires.

<> "Tires for cars are like the shoes we wear, and safety, handling, comfort has a direct relationship with three aspects, good tire maintenance can not only ensure the safety of the drivers, but also prolong the service life of tires. In the past, ordinary car tires could only run about 3 40,000 kilometers. But nowadays, the life of tires produced by manufacturers has been more than tripled, but to ensure safety, even if there is enough tread pattern, it should be checked frequently.

Here are a few tips to keep your tires in tip-top shape.

Keep the tire pressure reasonable: Some car owners will improve the grip of the tire by reducing the tire pressure, but there is no scientific basis for this practice. This not only causes tires to wear out too quickly due to increased friction, but also increases fuel consumption.

The correct way to do this is to ensure that the tire pressure is always at the level recommended by the manufacturer, and the relevant information can be found in the car instruction manual, or on the dashboard and inside the front door, so that the tire pressure can be kept reasonable to make the car easier to handle and smoother to drive. In addition, when the weather is cooler, you need to check the tires of the car, and every 10 drops in temperature will reduce the tire pressure by one scale.

It is recommended to make up some tire pressure in autumn and winter, which can not only ensure that the tire will not be worn prematurely due to insufficient tire pressure, but also achieve the purpose of fuel saving, the best of both worlds.

Wheel alignment: Poor alignment can lead to premature tire replacement, so it's important to make sure your tires are properly aligned. Car Keeper advises all car owners:

The mileage of the vehicle is accumulated to about 20,000 kilometers, and you can do a tire four-wheel alignment at the car maintenance man's cooperative auto service store. In addition, poor positioning not only makes driving unsafe, but also has problems such as poor handling, increased fuel consumption, and uneven tread wear.

Swap the position of the tires: It is recommended that the car owner rotate the tires of the car every six months to plan ahead and avoid forgetting. This results in a consistent burn-retention difference for all tires.

If you want to replace the tire, try to replace the left and right wheels together, otherwise there will be deviation and other situations, which will lead to tire eating. Because different tires wear out differently when used in a car, it is advisable to seek help from a tire expert to find the best tire for your car.

Avoid sliding friction of the vehicle: One of the contraindications when using tires is the occurrence of sliding friction. There are three main reasons for sliding friction in normal driving:

One is that the brake is stepped on more hard, the second is that the accelerator is too heavy when starting, and finally the wheel is taboo for many old car owners, which is a very tire-damaging behavior.

Develop a good habit of checking your tires frequently: always check the sidewall and tread for cuts, cracks or bulges, and replace the tires immediately if you find these problems, because this will make your driving very dangerous. If you walk on the gravel road, check whether there are debris or small stones in the tire pattern, and you must clean it up in time to avoid the deformation of the tread crown of the tire.