Gucci s belt is not suitable for buying, how to adjust his size?

Step 1: Prepare scissors, punches or punch nails, screwdrivers.

belt, and unscrew the buckle with a screwdriver.

Step 2: Then cut it short according to the actual waist circumference, don't cut it blindly, otherwise it won't be able to be used if it's short.

Step 3: Cut short and stack the subtracted part on top of the belt, use the original hole for positioning, <> Step 4: Use a hole punch to punch the hole.

Step 5: Finally, use a screwdriver to fix the buckle head of the belt, try to tighten it a little, otherwise it will be easy to loosen.

Precautions: 1. The cutting of the length must be carried out under certain circumstances, so as to avoid the situation that the cutting is too short to be usable.

2. The value of Gucci belts is high, and you must find a good position when punching, so as not to make mistakes in punching and causing the belt to be unusable.

3. The part of the buckle must be tightened after changing the size, otherwise it will be easy to loosen and fall off after a long time.

Materials Required: Screwdriver, scissors] Hole punch.

1. First of all, prepare the required materials, as shown in the figure below.

2. Then, cut it short according to the actual waist circumference, as shown in the figure below.

3. After cutting, put the belt that has just been cut off on the top of the cut belt, as shown in the figure below.

4. After positioning, use a punching machine to punch the belt hole, as shown in the figure below.

5. Finally, put the belt head on the band, and it's done.

1. First of all, use scissors to pry open the fixing teeth located on the back of the belt buckle, and be careful not to scratch the belt buckle.

2. Pull out the belt, and you can see the indentation of the belt head being pressed out by the fixed teeth.

3. Compare your waist circumference, cut off the excess part according to the length of the need, and pay attention to the part with the belt head rather than the tail of the belt. The actual cut part is a little longer than the length you need for your waistline, leaving room for it.

Leather distinction: first of all, it should be distinguished from the pattern and pores of the leather, and the patterns and pores can be seen on the surface of natural leather, and they are unevenly distributed, and there are animal fibers on the reverse side. Imitation leather artificial pores, there will be inconspicuous pores, some patterns are not obvious, or there are more regular artificial patterns, and the pores are quite consistent.

**The leather of the belt feels delicate and slightly shiny, but the imitation quality does not reach this level.

Odor distinction: **Belt natural leather has a strong smell of fur, even after treatment, the taste is more obvious, while artificial leather products, there is a smell of plastic, no smell of fur.

Feel differentiation: **The belt leather feels comfortable, plump, soft and has a certain sense of warmth. The imitation feels similar to plastic, plump, poor softness, and no warmth.

In addition, the ** section is regular fibrous, and when the nail picks its section, it will swell and thicken. The imitation section is a regular woven fiber, which is relatively rigid.

Hot stamping distinction: **Belt hot stamping is clear, **Belt hot stamping overall glyph spacing is more even, and the glyph pen tip is slightly sharp. The imitation glyph is thin, the overall spacing is slightly longer, and the hot stamping depth is different.

You can go to a Gucci store and re-eye.

You can also come to the temple maintenance center, and the professional maintenance master will give you a new look! ~

If the buckle is not fixed, you can take it off and cut off the starting place. Look at the style specifically, you can send a picture up.

You can drill your own eyes, and the specific operation method is as follows:

1. First take out the belt, belt punch and hammer, as shown in the figure below.

2. Secondly, lay the belt flat, as shown in the figure below.

3. Then measure the position of the punch and mark the punching position with a pen, as shown in the figure below.

4. After marking the position, take out the belt punch and compare the size, as shown in the figure below.

5. Select the appropriate size of the belt and press it to the mark, as shown in the figure below.

6. Then use a hammer to hammer the belt until it penetrates the belt, as shown in the figure below.

7. Remove the belt punch that penetrates the belt, and the hole will be laid, as shown in the figure below.

Summary. Most of the Gucci belts are made of natural leather, the material is relatively special, so the requirements for the punching technology are also relatively high, and after the holes are punched, the new holes need to be treated with edge banding oil, steel pads, etc., so as to ensure their normal service life.

What kind of leather is a Gucci belt?

Most of the Gucci belts are made of natural leather, the material is relatively special, so the requirements for the punching technology are also relatively high, and after the holes are punched, the new holes need to be treated with edge banding oil, steel pads, etc., so as to ensure their normal service life.

You've done a great job! Can you elaborate on that?

Gucci belts are mostly made of animal leather, which contains a lot of protein, which will deform and even mold when wet, so when using Gucci belts, you need to pay attention to waterproof and avoid moisture. Gucci belts will be deformed, wrinkled, and in serious cases, they will lose color after wearing them for a long time and being exposed to high temperatures. Therefore, when using Gucci belts, you should pay attention to prevent sun exposure.

You can buy an extra Gucci belt and wear it again to extend the life of the belt.

The method of slag is as follows:

1. First use scissors to pry open the fixed teeth located on the back grip of the belt buckle, and be careful not to scratch the belt buckle;

2. Pull out the belt, and you can see the indentation of the belt head being pressed out by the fixed teeth;

3. Compare your waist circumference, cut off the excess part according to the length of the need, pay attention to the part with the belt head, not the old part of the belt tail, and the actual cut part is longer than the length required by the actual waist circumference, and the belt size can be changed after reduction.

Tips for choosing the size of your Gucci belt:

1. The size of the Gucci belt is from 100 cm to 105 cm, which is suitable for people with a thinner body;

2. The size of the Gucci belt is from 108 cm to 113 cm, which is suitable for people with moderate stature;

3. The size of the Gucci belt is from 115 cm to 118 cm, which is suitable for people with a slightly larger waistline;

4. The size of the Gucci belt is from one foot to the ruler, that is, the total length of the belt is more than 120 cm, which is suitable for people with a fat body.

Summary. The belts are cut short according to the actual length used.

The Gucci belt I bought back is too long to make holes, can I cut it short? Urgent.

This question is up to me, it takes a little time to type, so please be patient.

The belts are cut short according to the actual length used.

Yes, you can. This kind of one should be disassembled and re-sewn, and it is best to get ** in Wuhan, people.

There is a store in Wuhan Optics Valley.

Or some luxury care shops will do.

Go to the place where you sell ** belts and you can change them short, right!

Yes. This is all after-sales service.

Thank you. You are welcome.