Wuling Hongguang jumped into the fire, and the oil just couldn t beat the fire

The filter is clogged or the oil pump is broken.

If you find that the body shakes significantly when you start the vehicle or stop the vehicle without turning off the engine, it may mean that the vehicle has the following three conditions:1The most common cause of car shake caused by serious carbon deposits in the engine is that the throttle valve is too dirty or the fuel injector is too much carbon.

When the carbon deposition inside the engine is excessive, the gasoline sprayed by the cold start fuel injector will be absorbed by the carbon deposition in large quantities, resulting in the mixture of cold start being too thin, making it difficult to start, in this case, only when the gasoline absorbed by carbon deposition is saturated, it is easy to get on the car, and the gasoline adsorbed on the carbon deposition after the car will be sucked into the cylinder by the vacuum suction of the engine for combustion, and the mixture becomes thick, and the combustible mixture of the engine is dilute and thick, causing idle shaking after cold start. The lower the temperature, the greater the amount of oil required for the cold start, and the more carbon deposits will affect the smooth cold start. Workaround:

Clean the oil circuit and check whether the idle motor has carbon deposits and should be cleaned. 2.Ignition system problems Check the working condition of the spark plug, high-voltage wire and ignition coil, the ignition system is not working well, and the spark plug flashing condition is not good will also lead to this kind of failure.

Solution: Check whether the spark plug has too much carbon deposit, and replace the spark plug. 3.

If the oil pressure is unstable, if you have cleaned the engine carbon deposit, washed the throttle, changed the oil pad and spark plug, etc., and still found that the body shakes when idling, it is recommended that you go to the 4S shop to check whether the fuel supply pressure and intake pressure sensor are normal, if the oil pump supply pressure is abnormal or the intake pressure sensor value is wrong and the work is not good, the body shakes will be caused. Solution: Check the oil pressure and replace the parts if necessary.

4. The aging of engine parts, the shaking of automobiles is also related to the aging of engine feet (also known as claw pads). The engine foot is actually the suspension system of the engine, and the engine foot is responsible for absorbing the subtle shake of the engine when it is running, and if there is a problem with the engine foot, these vibrations will be transmitted to the steering wheel and cab, causing shaking when idling. Workaround:

Replacement parts.

There are many reasons why Wuling Hongguang cannot catch fire, such as no high-voltage electricity, no fuel pressure, no cylinder pressure and so on. In general, it is divided into three categories: circuit faults, oil circuit faults, and mechanical faults.

It is recommended to go to the 4S store for detailed testing.

The car can't catch fire, first of all, we have to rule out whether the steering wheel is locked and the car can't catch fire, because this is an ordinary anti-theft function that many cars have, after pulling out the car key, the steering wheel is not back to the right or has to rotate, it will cause the steering wheel to start the self-locking function, the steering lock pin and the steering column buckle together, and the steering wheel can not move. The solution is very simple, that is, to twist the key while shaking the steering wheel, otherwise it is impossible to twist the key even if it is broken.

If the steering wheel is not locked, then the car does not catch fire, and it is possible that the battery has reached the end of its service life. The way to judge whether the battery is out of power is very simple, you only need to press the horn, and use the horn to determine whether the horn rings or not.

If the horn can sound, then the battery is electrified, which also indicates that the car cannot catch fire is other factors; If the horn does not sound, it means that the battery is out of power or has reached the end of its service life, and it can be judged that it is because of the battery problem that it cannot ignite. If the battery is insufficient, we can take the power start.

Depending on what you've said, there may be two reasons: 1. There is still air in the fuel supply line, so it is difficult to start. 2. Most of the cars now use the EFI system, and the electronic oil pump is installed in the fuel tank, when the fuel pump is working, there must be fuel to cool and lubricate it, when the fuel is used up, the oil pump is still working; At this time, the oil pump is easily damaged without fuel cooling and lubrication (burning the pump), you can use a multimeter to check the resistance of the oil pump outside, and the resistance value is normal within 2 ohms.

Depending on what you're talking about, there could be 2 reasons.

1. There is still air in the fuel supply line, so it is difficult to start.

2. Most of the cars now use the EFI system, and the electronic oil pump is installed in the fuel tank, when the fuel pump is working, there must be fuel to cool and lubricate it, when the fuel is used up, the oil pump is still working; At this time, the oil pump is easily damaged without fuel cooling and lubrication (burning the pump), you can use a multimeter to check the resistance of the oil pump outside, and the resistance value is normal within 2 ohms.

An engine that doesn't catch fire is one of the most common faults in cars.

There are two situations when it can't catch fire:

(1) First of all, it may be a circuit or electronic fault. The phenomenon that occurs is very sudden and without warning. The faults of the circuit are:

The fuse is blown out, the high-voltage coil is broken, the low-voltage circuit is broken, the center ignition wire is off, the distributor head is leaking, and the spark plug is damaged. Electronic failure mainly refers to the loss of function of the computer control board.

(2) Then there is the oil circuit failure. Oil pump failure, oil circuit failure, oil filter blockage, carburetor failure, nozzle damage, etc. Sometimes it happens that the fuel tank is empty and the owner doesn't know about it. Add a few liters of gasoline and you'll be able to get rid of all the gross glass.

(3) Finally, it may also be a mechanical failure. Common mechanical failures are: time band (chain) breakage, cylinder leakage without pressure, etc. The second scenario is when even the starter does not work or works barely.

Precautions: 1. When getting on the car to ignit, insert the key and do not ignite immediately, which will have a certain impact on the vehicle battery and starter, so that the car has no time to prepare, and it is not good for the vehicle's starting system.

2. If it is a vehicle with a key to start, do not step on the brake when ignition, after pressing the start button, it is equivalent to the key screwed to the ON position, and then wait a few seconds, and then press the brake to start the vehicle.

3. When starting the vehicle, after the car key is screwed to the start position, do not let go for more than 3 seconds, it is easy to damage the starting device.

5. Do not drive immediately after starting, which will increase the wear and tear of the vehicle.

The above content reference: Phoenix.com - n reasons why the car can't catch fire, how many do you encounter?

Answer: The reasons why the Wuling Hongguang engine cannot catch fire are: 1. The car battery loses power; 2. When the temperature is low, the viscosity speed of automobile oil decreases; 3. There is a problem with the ignition system; 4. The amount of fuel in the car is insufficient; 5. There is a lot of carbon deposition inside the vehicle engine; 6. The fuel pump is damaged, resulting in the fuel in the fuel tank being unable to participate in combustion.

It is recommended that you first check whether there is fuel available, if there is no recommendation to add to the correct liquid level, and pay attention to check the gasoline filter, fuel injector, etc. Secondly, check the battery to see if there is electricity. In addition, it is necessary to check the spark plug, under normal circumstances, after the carbon deposit on the spark plug reaches a certain level, it will make the spark plug electric stage can not form a spark at all, and the engine can not work normally.

If there is too much carbon accumulation on the spark plug in a short period of time, it is necessary to carefully find the cause to rule it out. Thank you for adopting.

Hello, the battery is out of power, ignition coil, spark plug, lack of oil, etc. will cause no ignition, if my answer is helpful to you, please set it to! Thank you!

The main thing is the circuit or oil circuit, the circuit mainly checks the battery power, the motor work, the spark plug and the cylinder line, and the oil circuit mainly depends on the oil pump, the oil deposition situation, and the carbon deposition situation, and clean the fuel injector. All of the above issues can cause problems that you are experiencing. Arrest the stalks, the prostitutes, the illusions, the glass, please check them one by one.

1 No gasoline.

2. Timing error.

3. The battery has no electricity.

4. The starter motor is broken.

5. The crankshaft position sensor is faulty.

6. The high-pressure package is damaged.

7. The fuel injector does not inject oil.

8. The cylinder head gasket was severely broken.

9. The ignition switch is damaged.

Causes: oil circuit failure, circuit failure, mechanical failure.

Specific analysis: 1. It may be a lack of fuel;

2. Gasoline filter, fuel injector blockage, etc.;

3. Check the battery to see if there is electricity;

4. After the carbon deposit on the spark plug reaches a certain level, it will make the spark plug electric stage unable to form sparks at all, and the engine cannot work normally.

Solution: 1. Provide sufficient liquid.

2. Charge the battery.

3. Clean the fuel injector and spark plug in time. Avoid unnecessary hassles as much as possible.

Five-zero macro light can only hit the fire five times before it can hit the fire, what is the cause.

Summary. According to your description, this is mainly because your engine is not idling, in this case, mainly check whether your throttle is too dirty, you can clean the engine throttle, if it is still not good after cleaning, then it is necessary to consider that the throttle of your engine is faulty, this generally needs to consider replacing the throttle, and at the same time check whether there is any leakage in the intake pipe.

Wuling Hongguang car turns off as soon as the throttle is released, and then the ignition has to be carried out with the throttle.

Hello, don't worry, I can ask for your question, but wait a minute, I need text for about 2 minutes.

According to your description, this is mainly because your engine is not idling, in this case, mainly check whether your throttle is too dirty, you can clean the engine throttle, if it is still not good after cleaning, then it is necessary to consider that the throttle of your engine is faulty, this generally needs to consider replacing the throttle, and at the same time check whether there is any leakage in the intake pipe.

Hello! I would like to ask if the Wuling Hongguang clutch plate is not installed properly will affect the fire problem, that is, if there is no idling, the throttle will be turned off.

What about people. Hold on.

If the clutch is not properly installed, it will not cause this phenomenon.

I have never encountered a clutch plate, this time, the owner came to repair the tire, I drove out, this situation, I asked the owner, the owner said that I did not install the clutch plate when I changed the clutch plate for him, so it is like this! So I asked.

No, this is mainly the problem of idling, and it can't have anything to do with your clutch.

Good! Thank you!

Ask about custom messages].

Summary. Hello, this problem is that the carbon canister is damaged or the carbon canister solenoid valve is not tightly sealed, resulting in the mixture is too thick, after refueling, due to the violent fluctuation of gasoline vapor, the carbon canister can not be absorbed, the gasoline vapor will enter the engine intake pipe through the solenoid valve, at this time, the solenoid valve is poorly sealed, it will lead to the mixture is too thick and cause the start difficulty, to eliminate this fault, you can first pull out the vacuum pipe above the carbon canister solenoid valve and then plug it, and then refuel and try again, the fault will no longer appear to replace the carbon canister solenoid valve.

Hello, don't click to end, I'm textual to give you the full answer, 2-3 minutes.

Hello, this problem is that the carbon canister is damaged or the carbon canister solenoid valve is not tightly sealed, resulting in the mixture is too thick, after refueling, due to the violent fluctuation of gasoline vapor, the carbon canister can not be absorbed, and the blind oil vapor next to the steam will enter the engine intake pipe through the solenoid valve, at this time, the solenoid valve is poorly sealed, it will lead to the mixture is too thick and cause difficulty in starting, to eliminate this fault, you can first pull out the vacuum tube on the pure magnetic valve of the carbon canister electric cover and plug it, and then refuel and try again, The failure no longer appears, and the solenoid valve can be replaced.

Ask about custom messages].

Summary. Why does Wuling Hongguang not add oil when it is on fire, and then it turns off by itself after a few moves, what does this mean?

Dear, this question is up to me, it takes a little time to type, please be patient, thank you!

The car suddenly couldn't catch fire, the electric belt and the plum bottle were electric, and when the key was screwed, it was possible to send ** stupid and late, and then it couldn't be refueled, so it turned off, and the air conditioner and windows were useless.

Fuel injectors, fire plugs, these are checked without problems, and now the blower does not turn? Then check the fuse.

and relays.