Why is there only six megabits of fiber for fifty megabytes

There are many scenarios of network slowness, and further testing is necessary to find out the fault point before targeted troubleshooting, and the specific steps are as follows:

1. First of all, the stand-alone device is connected to the operator's optical modem and other equipment to ping the operator's gateway or DNS server address, and a numerical value is obtained;

2. Connect the router again (unplug the other network cables) and then ping;

3. Then connect to other computers and ping when it is in normal use;

Get 3 values, which is larger or has packet loss, it means that it is the problem of **, the first time is that the operator's line is not good, the second time it means that there is a problem with the router, and the third time if it is abnormal, it means that there is a problem with the LAN.

If the three test values are normal according to the above test methods, it means that there is no problem with the local network and the operator's network, and the fault point is on the ** server. Generally, when the number of users is large, the processing capacity of the server is not enough or the egress bandwidth is insufficient, which can easily cause the stuck phenomenon, which cannot be solved, and can only be changed when the network traffic is small.

Hello, your internet speed is normal.

The unit of bandwidth that telecom operators say is MB, and the unit of speed you see online is MB. These two units are different, and the theoretical value of 50mb fiber is. However, in actual use, there may be slight differences in network speed due to various reasons.

Only 5 megabytes of 1000 megabyte broadband wireless may be caused by the signalInternet speedSlow. Broadband is measured in Mbps, while Internet speed is measured in Mb S. B in the former refers to bit, B in the latter refers to byte, and 1byte = 8bit, so the ultimate network speed is 1000Mbps 8bit = 125Mbp.

And there will also be environmental factors, which may lead to only 5 trillion. You can try to recover by restarting the broadband reset network.

Possible causes of slow broadband internet speeds:1. The bandwidth of the ** server accessed is narrow or the service stupid target is busy.

2. The reason for the rubber brain is such as computer configuration.

Relatively low or weak ability to manage the system.

3. It may be a virus or Trojan horse that causes slow Internet speed.

4. Using a router to share the Internet leads to slow network speed.

5. The modem device is unstable.

6. Line reasons (such as long line, noisy line, poor quality of the entrance line, change of the user's line and other factors).

The above content reference: Encyclopedia - broadband network.

In actual use, affected by network equipment such as routers, network cables, switches, etc., the actual ** speed may be slightly lower, but it will not be much worse. If the internet speed can reach 60mb s, it is considered normal.

If there is a device in the router, network cable, and cat at home that only supports 100m, then 500m broadband, its **speed will be automatically limited to 100m, that is, the **speed is only.

Summary: Totally sufficient. Family 500 megabyte broadband should be enough for ordinary families, ordinary families are generally playing games, seeing**, watching dramas, the requirements for network speed are not very high, 500 megabyte broadband is relatively fast enough.

Introduction:

There is no strict definition of broadband. From a general point of view, it is the bandwidth that can meet the needs of various ** transmission on the network that people can feel, so it is also a dynamic and developing concept.

On January 7, 2015, the Federal Communications Commission (FCC) made its annual broadband progress report, in which the current chairman Tom Wheeler redefined "broadband", adjusting the original downlink speed of 4Mbps to 25Mbps, and the original uplink speed of 1Mbps to 3Mbps.

50 megabytes of fiber is enough in the case of Internet access and playing small games.

1. If you just go online, chat, and play games, the network of about 10m is enough.

5. It is mainly calculated according to the number of users of your broadband.

Generally, families are 50m, 100m, 200m broadband, depending on the actual area of each family. The bandwidth of 100M in an ordinary family is completely sufficient, even if you watch ** at the same time, watch live broadcasts, and play games, you won't feel stuck, no matter how large the bandwidth is, it is a waste.

If you are still not sure how much megabit broadband you need at home, you can go to the business hall to consult the relevant salesman, and he will recommend the right one for you according to the size of your house and the specific use scenario.

Distinguish the difference between home bandwidth and leased line.

1. Household bandwidth is generally shared, and leased lines are dedicated bandwidth. So during peak hours, sometimes you feel like the internet is fast.

Relatively slow. 2. The uplink of the household bandwidth is rate-limited, and there is no speed limit for the dedicated line, and the uplink and downlink speed is the same. There is no need to upload a lot of data, and the experience is indistinguishable.

Third, some sensitive ports are disabled for home bandwidth, such as port 80.

If you don't do service equipment, it won't have much impact.

Let's talk about networking again.

1. Fiber-to-the-home.

At present, the networking is basically the same, and only fiber-to-the-home can achieve real 100 megabit bandwidth. The maximum load of the network cable can theoretically be 100 megabits, but the actual loss of too many megabytes has reached the limit.

2. Fiber-to-the-floor.

Fiber-to-the-building, network cable to the home. The maximum speed of the network cable has been mentioned above, which can be referred to.