-
The computer connection shows that the server timeout analysis is as follows:
It could be caused by an unstable or slow internet connection, or it could be caused by a busy server.
There are a few reasons for a slow internet connection:
1. Problems of the network itself (insufficient server bandwidth or excessive load).
Second, the network cable problem leads to the network speed slowing down (the twisted pair cable is not up to standard, which is manifested as: one situation is that the network speed is very slow when you first use it; The other scenario is that the speed is normal at first, but after a while, the speed slows down).
3. There is a loop in the network, which slows down the network speed.
4. The network speed is slowed down due to the broadcast storm caused by the hardware failure of the network equipment.
5. A bottleneck is formed on a port in the network, resulting in slow network speed.
6. The influence of worms causes the network speed to slow down.
7. Excessive use of firewalls.
8. Insufficient system resources.
Slow network speed is mainly caused by the above reasons, I personally recommend that you first clean up the junk process of the computer, optimize the system, and the Trojan horse is also a pest!
2. Check whether the twisted pair is qualified.
3. Use the method of gradual elimination by partition and segmentation to eliminate circuit faults.
Fourth, use the "ping" command to test the computers involved one by one under DOS, network cards, hubs and switches are the most likely to fail and cause network speed to slow down.
5. Change the server NIC to 100M or 1000M, install multiple NICs, divide multiple VLANs, change the router configuration to increase bandwidth, etc.
6. The anti-virus software used must be upgraded in a timely manner; Computers should also be upgraded and installed in a timely manner, while uninstalling unnecessary services and closing unnecessary ports to improve the security and reliability of the system.
If you can solve these problems, your internet speed will be faster.
-
If the network cable is not in good contact, change the cable.
-
Hello: 1. When the computer is connected to the network, it will pass through n relay stations on the way, if a relay is not powerful, the message will be returned, and then the relay station will be selected again (randomly) until it is connected.
2. There are generally two reasons for the timeout of connecting to the server: The network (the broadband network of the computer) is not powerful; There is a temporary problem with the network card.
-
Opportunity to green secretary general Chrysalis.
-
That means your monitor and console aren't connected.
Personally, I think it may be a port problem with the firewall, you can try it according to my method or ideas, and give you some suggestions I hope it can help you: >>>More
Check whether the network is normal, and the exclusion method is to log in to the web page to view, and if you can log in to the web page normally, you will be eliminated from the network reason. >>>More
It's just that you don't have an Internet connection, check the network.
You can try entering the IP address manually.
Based on your description, first of all, it is preliminarily determined that this is a home network, then it is connected through the PPPoe protocol. Are there two routers you're talking about? One is wired by, and the other is wireless routing? >>>More