How to adjust the drift of bream fishing and what bait to use

Bream fishing. The bream fishing hook line is the same as that of crucian carp fishing, but the branch line needs to be longer, and the distance between the upper and lower hooks should be larger, I generally let the two hooks be centimeters apart, the upper hook branch line is longer than the centimeter, and the lower hook branch line is longer than the centimeter. When adjusting the drift, it is better to hang the bait with a double hook, and it is better to expose the horizontal mesh at the tip of the drift.

Fishing bait is hooked with commercial bait with good atomization performance and flocculent residue, such as Dongjun crucian carp bait and old ghost.

Nine. One. 8. Golden Dragon Crazy Food, etc. The hook with the traditional bait as well, I generally use cornmeal and green bean flour steamed into a nest, and then mixed with some koji wine and sugar, summer and autumn with the new ripe corn germ effect is also better, at the beginning of fishing, it is best to use crushed bean cake crumbs, bran and wet sand to sprinkle into the nest, and then first fish float, let the bait start fishing in the middle of the water, if there is no fish bite hook and then go up to drift centimeters, let the bait slowly close to the bottom of the water, if you do not bite the hook every minute or so sprinkle a bait made of crushed bean cake crumbs, bran and wet sediment. Generally, when fishing for bream, the bite hook is a strong beating, and then the float will be lifted up a few times, and the rod can hit the fish when it is found to be drifting or rising.

Bream love to move in groups, after finding a certain point and a certain depth of fishing, you should remember this and this depth, try to keep the fishing spot quiet, every second counts to fish, and the fish should be pulled sideways immediately after the hook to lure it out of the nest. The bream bite is a burst, the shortest.

Three or five minutes, elders.

20 to 30 minutes, make full use of this time, strive to improve efficiency, and prepare bait, spare hooks and nets when not fishing.

I generally keep the two hooks 12 cm apart, the upper hook branch 10 cm long, and the lower hook branch 22 cm long. Is it necessary to have such a large distance?

Find the bottom first, use the lead skin or bait to hang the hook position to find the bottom, until the float is adjusted to the flat water, and then move the float down a standard length after finding the bottom, and then add or subtract the lead skin to make the float out of the water to the desired mesh.

This list of key clumps is the weight of the bait.

When floating fishing, we mostly blunt fishing, usually leveling the water to fish two eyes, or just run lead fishing, so that the characteristics of fishing is to let the double hook completely lie on the bottom. The main line is used to start at No. 5, and then the number is increased according to the individual fish, while the sub-line directly uses a strong horse or PE, and the line number is selected at No. 2 or larger.

Mullet. It is a fish species widely distributed in coastal and offshore waters, Fujian, Jiangsu and Zhejiang.

Tangerines are more common in both states. It is a kind of fish that people who like sea fishing prefer to catch, and this kind of fish has osmotic pressure.

The regulation function is particularly developed, so they can survive between seawater and fresh water, they like to live in groups, commonly found in the near-shore slow flow area, drifting with the waves, swimming in groups on the sea surface, swimming brightly and cultivating very fast.

You can choose leeches and silkworms that are soft and easy to hook, or you can choose shrimp and various seafood as bait for mullet fishing. Mullet mostly feed on zooplankton, like to eat soft bait and do not like hard bait, perennial to the bottom of the mud, moss, zooplankton, small fish, small shrimp, aquatic mollusk and some rotting leeches, sand silkworms and so on for food.

Mullet is pelagic and active, jumping, and prefers to inhabit estuaries and harbors, and can enter freshwater. It is mainly distributed in the Indian Ocean and the Pacific Ocean, and China is mostly found in the South China Sea, East China Sea, Yellow Sea and Bohai Sea. It is a target fish that is often caught by offshore fishing enthusiasts.

The time to fish for mullet is generally around the beginning of winter, and it is better to choose a No. 2 rock rod when fishing.

The winding wheel can be spun wheel 2000 type or above, and the nylon main line No. 3-4 is about 100 meters or more. The length of the carbon line can be adjusted appropriately according to the needs of fishing.

In view of the characteristics of mullet inhalation when eating, the choice of hook is particularly important. Hooks that are too thick are not easily sucked into the fish's mouth, reducing the chance of hooking. Hooks that are too small are not easy to get caught up in, and they are easy to be pulled out of shape or straightened by fast-swimming mullets.

The hook commonly used for mullet fishing is the Senmata hook of size 2-4.

How to adjust the drift and catch the catch of mullet fishing is as follows:

Taiwan mullet fishing is a fishing method for offshore or deep sea fishing, and it is one of the more common Taiwanese fishing methods. When fishing for mullet, it is necessary to pay attention to the selection of drift and hook, as well as the technique of adjusting the drift and catching mouth. Let's take a closer look at how to adjust the drift and grip.

First, the selection and adjustment of drift

1.Selection of drift: Taiwan fishing mullet needs to choose a more sensitive drift, about 20-30 cm long, and the float is made of small, medium-sized foam or soft materials. Hang a plumb sinker above the drift, and the weight of the sinker depends on the depth of the fishing position.

2.Adjust the position of the float: if the fish float is deep or the fish is large, the Tuqing pie needs to lower the float so that the plumb sinker is pressed on the bottom of the sea or close to the bottom of the sea; If the float is shallow or the fish is small, you will need to lower the float up to catch the fish better.

3.Sensitivity of drifting: By adjusting the distance between the drift and the water surface, the sensitivity of the drift and the speed of the float are realized. If the fish is more cautious about swallowing the bait, it needs to be more sensitive to floating, so you can reduce the drift body or use a rubber band to adjust it.

Second, the way of grabbing

1.Mullet tend to move in the current, so it is necessary to choose the right spot according to the direction of the sea surface and fish during the last round of waves.

2.A gear should be placed at the junction of the fishing tackle, and the bus wire should be wound around the gear by grabbing the mouth, so that the length of the fishing line can be adjusted at any time.

3.Choose softer bait, such as mixed reef earthworms, sandworms, etc., and pay attention to controlling the position of the stress point to prevent the bait from drifting underwater.

4.Do not pull the rod on the top rod during the grip process, as the fish only has a few seconds to react to the movement of the line, and the slightest hesitation will miss the opportunity.

5.When grabbing the mouth, it is necessary to pay attention to the strength and frequency of the hammering, and eliminate the influence of wind and strong currents, and when the fish is not sensed, you can moderately increase or change the bait, and change the speed and direction of movement, and find a new area for fish activities.

In short, adjusting the position and sensitivity of the drift and choosing the appropriate grip method are all important factors affecting the fishing efficiency of mullet, and it is necessary to continue to try and practice according to their own experience and actual situation.

BreamThe fishing method and bait used are as follows:

1. Fully equipped: the bream mouth is small and brittle, and it is easy to pull out. Therefore, anglers should choose medium or soft hand rods, can use about five meters of bamboo hook rod, fishing line can use imported wire diameter of strong line, choose Iseni No. 4-6 hook, float can be used small loose drift, can also use small wind drift, to achieve drift can stand on the line.

The most important thing is that the hook, line, pendant and drift equipment should be reasonable.

2. Make bait: Because the bream mouth is greedy, the food is miscellaneous, the smell is fishy, and the meat and vegetables are eaten, so the bait can be meat and vegetarian. Fresh silkworm pupae can be taken.

Rapeseed meal, soybean cake crumbs and dry sawdust crumbs are mixed and mashed in an appropriate amount to make the bait covered with pupal pulp. You can also try using corn kernels as bait. Corn kernels are a favorite food for most fish.

3. Choose a good fishing position: bream like to wander and feed in groups in the water layer with relatively clean water layer, high oxygen content, and sediment and gravel at the bottom, so the fishing position should be selected in the sparse aquatic weeds and deep waters to nest and gather fish.

4. Lifting the rod strength: pay attention to the strength when lifting the rod, because the mouth of the bream is crisp and thin, so you can't lift the rod vigorously, just lift the rod gently. If you encounter a big bream on the hook, you must not take it hard, but you must walk the fish with a rod, and wait until the fish is tired of walking, and then use a copy net to copy it.

FishingBreamPrecautions

The fishiness of the rod is selected according to the individual of the fish, and the individual is small, and the fish mouth is small.

Slow, choose a slightly softer, such as 46 tones, or 37 tones, the fishing feels good, the fish mouth can not be missing, and the line protection group. If the fish is slightly larger and has many mouths, catch the fish quickly.

The side selects the rod with a hard point, the tonality is 37 to 28 tones, and the rod is hard to control, and the fish is returned.

Fast. What you also need to pay attention to when fishing is the length of time. After casting the rod, it is generally necessary to wait for a while before taking the bait, and the whole fishing process is relatively long. And this is important for the physical fitness of the angler.

The requirements are relatively high, and after a period of fishing, you should pay attention to taking a break halfway.

Mullet mostly feed on zooplankton, like to eat soft bait rather than hard bait, and live on mud, moss, zooplankton, and small fish on the bottom of the water all year round.

Small shrimp, aquatic mollusks and some rotting leeches, sand silkworms, etc., like bighead carp, like like to eat corrosive substances.

Therefore, when fishing for mullet, you can choose leeches and silkworms, which are soft and easy to hook foods, followed by seafood meat, shrimp and other effects are better;

However, it is easy to attract small fish when using these baits in summer, so you can choose commercial bait for mullet fishing in summer, using Fushou plus shrimp powder and Jiuyi.

8. Amino acids fully protect the taste of the bait.

The bait should be fragrant or smelly, and a pack of Fushou should be added with shrimp powder 30. Rub the bait to fish the bottom, and you can fish the float. The drift should be slightly blunt, because the mullet is gnawing, not the kind of crucian carp that sucks, and there are many empty rods instead of Tailing.

The mullet has a lot of strength, and the rod should be a little harder, preferably super hard. Bait: a bag of shrimp powder; 918 (2) 1 2 bags; a bag of Fushou bait; Amino acid 1 3 bags of mullet are very powerful, the rod, line, and accessories must be strong enough, and the hook must be sharp enough.

Generally, 1-2 catties of No. 3 bus can be coped, if you are unfortunate enough to encounter a monster of more than 4 catties, it can only be resigned to fate. By the way, there is another indispensable thing, that is, the lost rope, lengthen the lost rope, because the mullet will definitely rush out after the fish, and you will lose a lot of rig and even fishing rods. Hope to adopt.

<> to find the bottom: the method of drifting bream fishing is very simple, first of all, to find the bottom, install the lead skin, generally heavy lead to find the bottom, and calculate the approximate water depth. Hanging bait:

Hang the corn kernels on the double hook and adjust the number of meshes that the fish float is exposed to the water surface until the tip of the fish float is about 5 mesh above the water surface. Double hook: If you want to fish for bream with a double hook, pay attention to their distance, which is usually kept at around 12 cm.

1. Adjust the five-eye fishing with a double hook: first close the heavy lead to find the bottom, and then pull down the float more than 10 cm longer than the subline, trim the lead skin until the float exposes 5 meshes, and adjust the float to 2 mesh after the double hook hangs the bait.

2. Leveling water fishing 1 3 mesh without hook: first heavy lead to find the bottom, then pull the float down 20 30 cm, trim the lead skin until the float is just exposed to the water, hang the line and bait to find the bottom again, find the bottom and move up the float until the float is exposed 1 3 mesh, this drifting method belongs to the sedan block and is blunt, suitable for summer and autumn and other seasons with high temperatures for bream fishing.