About table tennis set rubber, the difference between table tennis ball set rubber and single rubber

Butterfly Sriver-El, very good to make, this is what I use now on my forehand, it is max, the thickest, strong, the rotation is not bad, and it pulls up. Backhand Sriver-FX, relatively soft, well controlled. This is my configuration, refer to it (a bit expensive, forehand can be considered with madness 2, good rotation, low arc.) )

The forehand is the most accustomed to using EL in China, and the sponge is still easier to control within the day. Of course, elasticity is naturally the most violent of the De Setau, F1 is very good, and I think it is completely controllable.

If it is sticky, blue whales are very sought after now, but it is indeed sticky. The sponge is not bad either. There is also Tianji 3 and War Drums, not to mention Tian3, basically eliminated.

The war drums are quite good, the performance of the first generation is outstanding after pouring the glue, the rotation is very strong, the arc is a little longer, but it can be controlled.

Cool. I really haven't used it, it's hard to say.

The latter one is the king of the arc circle.,It's been popular before.,But many masters don't think it's very adaptable.,I don't know how to pull.。

Galaxy M6 is a pure wood board is very hard, with soft points of the glue is good, depending on the economic situation, 100 below 39 degrees 729SST, 38 degrees of Tianji three, 150 has 40 degrees Dornik F1, 350 has a butterfly bus, these are suitable for your needs.

Butterfly Tenergy 05 it.

In response to the inorganic era, butterflies are made of high-speed rubber, but with high rotation.

Both Zhang Yining and Guo Yue use it.

Double Happiness Tianji 2 anti-rubber sleeve glue, 40 degree thickness is good.

Red double joy 3, sponge hardness 40 degrees, thickness.

There are two kinds of rubber, one is the set of glue, that is, the sponge and the rubber layer are glued together and leave the factory, and the glue can be glued to the bottom plate, which is basically what you usually see.

There is also a single rubber sheet, which has only one layer of rubber and no sponge. When pasting, you should buy a sponge to stick together, or not to stick a sponge, only to stick the rubber.

Generally speaking, "rubber" refers to the set of rubber. Mono rubber will be specially indicated.

Popular knowledge of table tennis glue: adhesive glue and astringent glue and glue filling analysis!

The advantages of the astringent sleeve: it is easy to take the initiative to exert force, and after penetrating the rubber sponge through the force, you can feel the feeling of wrapping the ball and generating force. Cons:

It is difficult to make friction, and the control of some small balls near the table and the ball in the table is poor, because many balls in the table now have to rely on very small movements to deal with them, and the corresponding astringent sleeve has very high requirements for the explosive power of the wrist. The astringent sleeve requires more power and speed, and if you don't have a good instantaneous explosiveness, it will be difficult to penetrate the ball into the sponge.

The advantage of the sticky sleeve is that it is easy to create friction, and it can create a certain rotation of the ball with a small force, especially when dealing with the small ball in the table, it is easier to rub through the wrist. Cons:

Since the sticking sleeve is prone to friction, the control of rotation and force is even higher. Thin friction and thick friction are easy to cause ball mistakes.