W950 white screen! Help,What should I do if my W900 has a white screen,

The cable is a soft row with many copper wires, you can simply see it as a lot of thin wires, some receivers, ringing, LCD panels, handwriting boards, the possibility of your mobile phone's LCD not being damaged is zero, and this situation will occur in the cottage mobile phone, it is recommended that you take it to the maintenance point to see, the master removes it to see if the wire is broken, or you can use it for a while to see if sometimes you can show or even the earpiece or handwrite the problem is definitely the cable.

The software is broken.,It shouldn't be a hardware problem.,It's recommended that the landlord brush the machine.,I don't know where you can ask me in the way of a station letter.。

Where did the cable come from, it's not a flip cover or a slide cover.

1: Poor contact between the LCD and the motherboard.

2: The liquid crystal is broken.

3: The motherboard is faulty.

4: Software failure.

Suo Ai's LCD is more fragile, you only have to start with the LCD, go to the maintenance department to see, they will give you the test out, and the detection does not cost money, if they open their mouths, directly flash people, change one outside, about 150. However, the situation of lz looks more like a software failure. But I still want to check it to be sure.

There is no basis for talking. Whether it is LCD or software, it will never exceed 150 yuan. The LCD has not been replaced, but the LCD of Suo Ai is generally not expensive, it should be around 150.

There is a contact point between the upper and lower cover of the mobile phone, which plays the role of connecting, hanging and closing the inner screen and opening the outer screen. The control of the inner and outer screen is a small bulge above the keyboard, when this small bulge is pressed on the corresponding small groove, it means that the phone is closed, the inner screen is extinguished, the outer screen is ignited, and when this small bulge is not pressed on the small groove, it means that the phone box cover is opened, the outer screen is extinguished, and the inner screen is ignited. If the lid is not tight after using it for a period of time, the small bulge cannot be pressed well to the end, and the outer screen is not bright, and when the lid is opened, the groove cannot be completely up, and the inner screen is not lit, and a white screen appears.

Also, the clamshell machine is prone to a white screen, which is mainly caused by the poor contact of the connected cables, and it will be displayed when it is contacted, otherwise it will be a white screen. In this case, you need to open the re-soldering contacts, if it doesn't work, you can only replace the cable, and if you happen to encounter a cable that is not sold separately, you can only replace it in full screen. There are also some reasons why the screen does not display is caused by the motherboard, mainly due to damage to the circuit and power chip, which causes the display to not be able to supply power.

If you can't eliminate the fault after opening and closing it a few times, but after shutting down and turning it on, it can solve the problem, then it can be roughly regarded as a software problem, and you should go to the repair center to test the mobile phone and repair it.