How can I change the oil in my car to make the climb easier?

Generally, the oil and the filter are changed together, and there is a detailed method of changing the oil in your car manual. You have to have a machine filter wrench. Generally speaking, it is recommended to change the oil in the case of a hot car, take a container (usually a basin) under the oil drain, use a wrench to unscrew the oil port to release the waste engine oil, pay attention not to burn your hands, and it is said that it is best to bring a goggles, but I see that no one in the repair shop wears it.

At the same time, you can unscrew the machine filter, or wait for the oil to be cleaned, you can also unscrew it after the oil is cleaned, wipe the oil near the place where the machine filter is installed with a dry cloth (facial tissue) and apply a layer of new engine oil to the sealing gasket of the new machine filter, and then screw the machine filter on, and then use the machine filter wrench to tighten it by hand, as for how much to use the wrench to screw depends on what you say in the manual, generally 3 or 4 weeks. Tighten the bolt of the oil drain port to pour new engine oil (you can also use some new oil to flush the valve chamber and oil pan before), how much new engine oil is poured on the manual, don't pour too much, take the dipstick to look at the point, as long as it is between the E and F lines, do not exceed the F line, generally speaking, as long as it is close to the F line. Add oil, cover the oil port cap and start, idle for a while to see if there is oil leakage, and if it does not leak, it is completed.

In addition, some cars may have to remove the engine guard before changing the oil, which is more troublesome, and it is estimated that you can get those screws by lying on the ground, but in the repair shop, the car is lifted up.

Semi-synthetic engine oil is poor, and the climbing power is insufficient, and you choose an oil containing liquid molybdenum to greatly improve the power, because liquid molybdenum can effectively reduce friction. , I use German GT engine oil for maintenance, which contains liquid molybdenum, the power output is much better, the climbing is very easy, the flat road is full of power, and the engine sound is very quiet.

Hello! Choose a fully synthetic motor oil.

Personally, I recommend using Mobil oil or Shell, Total Castrol are good engine oils, and you can run 10,000 kilometers once if you choose a fully synthetic one. 0w-40 or 5w-30

<> "For car owners, car maintenance is always a big problem, especially for car novices. You know, car maintenance is a big expense in the cost of car maintenance, of course, you can save it, but you can't suffer from loving the car, after all, the final injury is the wallet! So how often is it reasonable to change the car oil?

Is it 10,000 km or 5,000 km? In fact, you only need to pay attention to 3 points, and you will not suffer a loss when you change the oil at the "point".

Kilometers traveled or oil shelf life.

Starting from the actual situation of infiltration, 10,000 kilometers of replacement or 5,000 kilometers of replacement are not fixed, and you need to know what kind of engine oil your car uses, and the oil change cycle of different engine oil is not the same. Generally, the mineral engine oil is changed once every 5000 kilometers or half a year; Semi-synthetic engine oil is changed every 7,500 kilometers or half a year; Fully synthetic engine oil is about 11,000 kilometers or changed every six months. Some people will wonder, isn't the shelf life of motor oil 5 years?

Usually the car is not opened, why do you have to replace it in half a year. The shelf life of 5 years is for unopened engine oil, and after opening, it cannot be calculated according to this cycle, taking into account the deterioration of the oil itself.

**Oil quantity and color.

Secondly, some car owners do not know what type of engine oil they have, so they do not know what kind of standard they should replace. In addition, due to the difference in driving habits and the usual driving environment, there will be some deviations in the chaotic replacement cycle or the number of kilometers. At this time, we can pull out the oil dipstick to check the oil volume and oil color, if the oil level is lower than the minimum scale or the oil loses its luster and turns black, it is time to change the oil.

**Oil viscosity.

Finally, you can also check the viscosity of the oil, which has a lot to do with the quality of the oil, the higher the viscosity, the more oil can adhere to the parts, and the thicker the oil film, which can minimize the wear between the components. On the contrary, if the viscosity is not enough, or even loses viscosity, it will increase the wear between the parts, and even cause irreparable losses (the higher the viscosity, the better, the general German car requires high viscosity, and the Japanese and domestic viscosity is moderate).

To sum up, whether to change the engine oil, first look at what type of engine oil you use, if you can't be sure or feel that the engine oil can still stick to it, you can check the amount of engine oil and the color and viscosity of the engine oil. Therefore, there is no fixed number of kilometers and cycles for changing the engine oil, but according to the actual use, so as to save money and protect the car!

Before you change the oil, the first thing you need to do is to get your car up. As everyone knows, the self-made slope often said on the Internet is how to do it, and today the author will take us to find out.

How to make your own ramp oil change.

The in-house oil change ramp is carried out according to the specifications of the model with a total width of 40 cm, a height of 26 cm, and a slope angle of 15 degrees (to ensure that the front bumper is not touched). Naturally, it is best to use solid wood planks to make your own oil change slope, after all, this slope must bear a very large net weight, so it is necessary to ensure that the wood is firmly level. If it is accumulated piece by piece, the basic principle of the triangular bracket must be commonly used to expand the bearing capacity of the slope.

Secondly, before application, it is necessary to repeatedly ensure the firmness of the oil change slope, otherwise there will be certain safety risks.

Naturally, if we are too troublesome, we can immediately use the height of the road tooth cover (dirt shoulder or curb) to tilt the vehicle on its side, although it is not convenient to have a car lift and a homemade ramp, but it can at least be said to be a method. However, it is important to note that it is best to use a moderate height of the road, if it is too high, it is very easy to scratch the front side skirt, and even rub against the chassis of the car is very likely, and it is too low to shout the stove may be difficult to carry out the next step of the actual operation.

Millions of car purchase subsidies.

What are some tips to master when changing the oil in your car? Many people find it difficult to change the oil, and they are afraid to try it easily. In fact, as long as you are proficient in professional processes and have specialized tools and equipment, you can change the oil yourself without having to go to a 4S shop.

Next, I'll tell you how to change the oil. How do you change oil in a car? This set of skills is worth learning.

To prepare the raw materials and tools, we must choose the right oil and oil filter element in strict accordance with the oil level specified in the car manual. Then prepare the machine filter tools and wrenches, oil drums, cotton cloths and gloves.

Starting the engine warms up the start of the vehicle's engine, allowing it to warm up for 5-10 minutes, contaminants in the oil are more likely to volatilize from the hot engine and save energy when removing the filter.

Drain the oil to make a shaft, and if possible, it is best to drive the car into the trench or use an elevator to raise the car. This is easy to operate. Then open the hood of your car to find the old oil filter.

After raising the car, put an oil drum under the engine, unscrew the oil drain screws, and drain the engine oil completely. Tighten the screws after finishing. How do you change oil in a car?

This set of skills is worth learning to change the oil filter with a filter wrench, install a new one, tighten it, and then tighten the knob of the oil drain button to put the car down.

The amount that needs to be added is stated in the Add New Oil manual, and the quantity is added according to the quantity in the manual. Once added, close the hood. Start the engine, observe and make sure the oil pressure indicator turns off after starting.

Check for water droplets and leaks underneath your car. If the oil filter or oil plug is not tightened, they may leak slowly. If there is an oil leak, the flame should be turned off in time and inspected.

You should first understand the type of engine oil of the car, now many people are not so aware of the type of engine oil, the owner of the car rent blind in the purchase of engine oil, the sales staff pick those expensive type of engine oil, not necessarily suitable for your car, so we need to buy engine oil, we must be clear that this is suitable for your car.

First of all, I had to replace the product with strong hands-on ability. I bought the Cruze Classic for $178. I bought a Shell 4-liter fully synthetic engine.

The oil grid is 15 yuan. The oil grid was removed and it cost 28 yuan. I don't have an elevator at home.

An oil pump, pumping oil through the dipstick hole, after pumping the oil, you can add 4 liters of oil, the original 4s through the oil drain screw, can only add liters each time, which is not clean at all. The air filter element and the air conditioning filter element should also be replaced by themselves, each for 10 yuan, buy a bottle of throttle cleaner for 5 yuan Nianchen, and even the throttle cleaning for ten minutes, a bottle of cleaner can be used for many times. I didn't really have any difficulties and no pressure.

For example, let the car start a will make the oil resistant to preheating and thinning, so that it is cleaner, and then the last few buckles should be screwed according to the vertical force of the acre, and the last quick pull out of the large screw will not be scalded by the hot engine oil.

The reasons why the car is unable to climb the hill and cannot refuel are:

1. There are problems in the oil circuit system, such as the fuel injector is blocked, the oil pipe is leaking, and the oil pump has a tendency to decline after aging power after a long period of use, and the insufficient fuel supply pressure of the oil circuit system will also lead to the inability of the vehicle to refuel.

2. Oil problems, the use of inferior substandard engine oil or gasoline, easy to damage the parts of the vehicle, such as oil pumps, fuel injectors, oil pumps, etc., and inferior gasoline fuel has poor effect and high fuel consumption, while inferior oil has poor lubrication effect and high viscosity and is easy to deteriorate.

3. Carbon deposition problems, the common ones are throttle carbon deposition and spark plug carbon deposition. If there is too much carbon deposit, it is easy to travel deflagration, which is a force to resist engine power, moderate deflagration can improve engine power, but this force is generally uncontrollable, often hinders the work of the engine, so that the engine power decreases.

4. The intake and exhaust system is blocked, such as the air filter is too dirty, and the three-way catalytic device is blocked and fails, which will affect the breathing of the engine, so the poor breathing will eventually lead to the engine climbing and unable to add oil.

Regular maintenance can improve the dynamics of the vehicle.

1. Replace the oil and oil filter element in time, at the end of the maintenance cycle, you should change the oil and oil filter element, gasoline filter element, etc., expired engine oil usually contains a large number of metal debris, and if not replaced in time, it will affect the service life of the engine.

2. Regularly clean the fuel system, generally you can add clean fuel additives (fuel treasure) to the fuel tank, which can clean the carbon deposition effect to a certain extent. You can also go to the 4S store for oil circuit cleaning (often said to be dripping), and the cleaning effect is even better.

3. For slightly serious carbon deposits, it can be cleaned by physical means, and for spark plug carbon deposits and throttle carbon deposits, cleaning agents and weak friction methods can be used to clean them.

Choosing a good engine oil can make your car more durable and powerful. A good engine oil, especially a fully synthetic one, can not only protect the engine and reduce the number of oil changes, but also save on gasoline costs. Therefore, it** is twice as expensive as regular oil, making it the best choice for many car owners.

In general, the selection of engine oil should pay attention to the following four elements: 1. The selection of engine oil should be selected according to the requirements of the engine, and it is not necessary to use too high-grade engine oil on the engine with lower requirements, nor can the lower-grade engine oil be used on the engine with higher requirements. 2. Multi-grade oil should be selected as much as possible, because multi-grade oil has a good protective effect on the engine due to its saving, long life and high efficiency.

Based on the characteristics of multi-grade oil, premature blackening and oil pressure may be smaller than that of ordinary oil during use, which is normal. 3. The quality of some domestic brand-name engine oil is quite good, and it is much lower than that of similar imported products, so it can be used with confidence, and there is no need to blindly pursue "foreign oil". 4. If the engine is in good condition and the temperature is low in season, the oil with low viscosity should be used as much as possible to make the oil circuit smooth.

For example, in the high temperature season or under the condition of severe engine wear, the selection of high viscosity oil is conducive to the formation of oil film and reduces engine wear.

Changing the oil in the car can make the climb easier, and I personally think that this is mainly combined with the requirements of the car maintenance manual, combined with the number of the oil, and the cycle to change.

The engine oil can not completely change the power output of the vehicle, but it should be noted that the oil can not be added too much, and it should be added in strict accordance with the oil scale scale to cool the car, because refueling will affect the power output of the engine and lead to a decrease in power.

You should ask a professional to consult and inspect the vehicle to see if there is a fault that causes the vehicle to be powered insufficiently, and of course you can also improve the power output through some modifications.

Poor power is a problem of the manufacturer's power calibration level, and has nothing to do with the oil.

Changing the oil later can improve the acceleration feel, but it will not increase the power.

The methods that can significantly increase the power basically involve illegal modifications.

If you want to inspect the car normally and not be troubled by the traffic police, you should not have too many ideas.