-
First: If your computer often has a blue screen, whether you reinstall the system, or later reinstall the system, or the blue screen still appears, it means that the hardware is causing the problem. The one that directly affects the hardware of a computer is the memory module or graphics card.
The cause of the problem is the blue screen phenomenon caused by the oxidation of the gold finger of the memory module or graphics card or the poor contact of the slot. Solution: You can turn off the power first, open the computer case, dial out the memory module, use the eraser to wipe the part of the gold finger (that is, the place where there is a copper sheet) back and forth a few times, and then insert a memory slot back, and you're good to go.
If this is still a blue screen, you have to check the graphics card, explain that it is a problem with the graphics card, and also use the same method as above to do it, and you can do it. Generally, 80% of computers can solve the problem.
The second type: is the hard disk has a bad sector, when the computer reads the bad sector, it is stuck, the background is still running, the CPU occupancy is immediately very high, and then the blue screen, processing method: under normal circumstances, it is repaired with HDD, if it can't be repaired, which can only change the hard disk.
The third way: that is, the video memory chip of the video memory and graphics card appears virtual soldering, and the blue screen will continue to appear, the method is to add solder to the video memory.
Fourth: the computer is poisoned, causing the memory to enter the virus, destroying the operating system, causing the system to be unable to boot, it has been a blue screen, can only reinstall the system, or press f8 to boot up, enter safe mode, open the control panel, delete the latest updated patches and drivers.
Fifth: It's because of illegal shutdown, such as power outage, forced shutdown, or sudden crash, after turning on the machine, it will be self-checked, and it is also a blue screen, in the countdown, in general, let it read it by itself, it's fine. It may waste a little time, but it must read it by itself, because this is the process of checking the disk by the hard disk, and generally the first time it has been read, it will not appear next time.
Don't stop with ESC, or you'll have a blue screen next time, do it all over again. If you want to self-test every day, you have to start --- chkntfs t:
0", the general problem is solved.
Before doing the above, it is best to restore the BIOS of the motherboard to the factory value, or you can discharge the motherboard battery, that is, remove the battery, wait for 20 seconds and then install it back, or connect the jumper to two or three, which is conducive to eliminating strange phenomena caused by the disorder of the motherboard BIOS.
The second of these is the one with the highest probability of causing a blue screen, and if you don't try to use it, 80% of the computer will be fine.
-
From your description, I personally think: this is a mismatch between the drivers of the n card!
It is recommended that you try to reinstall the driver of the n card, it is best to find an official one.
-
How to solve the blue screen when the computer is turned on?
-
You can run it alone with the memory in question to see if it will be a blue screen, if it will still be a blue screen, it is a quality problem of the memory, if the operation is very stable, according to what you described, it should be a problem of incompatibility between the two memory, but the current memory, there will rarely be a compatibility problem.
-
Have you been poisoned lately?
If there is, reinstall it, if not, then it's a hardware problem
Main memory It is recommended to take it out and put it back after brushing off the gold finger
-
The memory module is not compatible, and it will be fine to replace one.
-
Most of the time it is a memory problem, it is recommended that you check the memory
-
Have you been poisoned lately?
If there is, reinstall it, if not, then it's a hardware problem
Main memory It is recommended to take it out and put it back after brushing off the gold finger
Windows 10 locks down untrusted software programs for the security of your computer. If you need to install untrusted software, you can refer to the following methods: >>>More
What should I do if the official version of win10 crashes when running the program? Due to the compatibility problems of the official version of win10, there are freezes and crashes when running some programs. In this regard, we can solve this kind of failure by the following methods. >>>More
In the process of Windows operation, when the program is in an unresponsive state for some reason, you can press the Ctrl+Alt+del key combination to bring up the task manager, end the corresponding process of the program, and then restart the program, the method is as follows. >>>More
Reasons:1It is estimated that there is an accumulation of too many historical documents. >>>More
The booming sound you are talking about must be the sound of the cooling fan in the chassis rotating, and this sound will get louder and louder over time, this is because of the lack of lubrication of the fan bearing, so it is necessary to keep the host clean, the fan also has regular lubrication, and there are many reasons for running the program card, 1, too much system garbage, too much hard disk fragmentation, insufficient space on the C disk, 2, there are viruses, Trojans or malicious plug-ins in the system, 3, software and hardware compatibility, 4There is too much dust in the main machine, which causes the operation to be too slow. >>>More