-
Anonymous users2024-02-111. Do you use Kaspersky Antivirus or Kaspersky Firewall, or is it similar to Kaspersky's incognito mode function? If yes,Then you just turn off this incognito mode,Don't be incognito on the network, this situation won't occur after stealth,Invisibility sometimes affects BT** speed,There is also P2P network TV。 A reboot of the machine or cat can sometimes do the trick, but it won't solve the problem at all.
The fundamental reason for this situation is that the broadband network you use (such as telecommunications, Netcom, Tietong, etc.) often has to detect your computer, and this situation will occur when the other party cannot detect your computer network card, and when this situation occurs, your network card does not get the IP address at that time, so this situation will occur.
It's not a big problem, though. Generally, this problem is not easy to occur, unless the broadband network you use needs to be adjusted to the network.
2. Check whether there is strong magnetic field interference in the place where the network cable passes.
Third, the cause of static electricity, friction has static electricity, let alone the computer. The computer's computer source conversion and display will produce static electricity, especially the computer's power conversion is in a high-frequency oscillation state of 500kHz is the most culprit of the chassis electrification, find a piece of wire, connect it to the ground wire on the power socket, and connect the other end to the iron post on the window sill. You can measure the voltage change of the front and rear chassis, which is not small.
The normal chassis voltage should be around 3 volts (I haven't measured it myself, my friend said, there should be no problem).
Fourth, in addition, there are certain requirements for the first line to use ADSL modem to access the Internet, one is that each joint of the line should be connected, and the other is that any equipment can not be connected before the ADSL modem separator, such as: ** extension, anti-theft device, etc. When reconnecting the binding post of the junction box, it is best to wipe the ** wire and the binding post with fine sandpaper, and wrap the ** wire on the binding post a few more times when wiring, and then tighten the screws to ensure good contact.
Remove the first socket at home, use direct wiring, it is best to use welding when connecting wires with wires, and then wrap them with insulating tape, anyway, you can't connect any equipment before the separator, so as to ensure that the line contact between the junction box and the adsl modem separator is good, and the quality of signal transmission is ensured.
And then there's the problem of the operators themselves, but it's unlikely.
-
Anonymous users2024-02-10Is there a problem with your routing power supply?
This is the case with piracy systems. I've encountered it before. >>>More
It should be your cat's problem.
Consider getting a new one. It's better not to have a miscellaneous one. >>>More
In fact, the easiest way is to call **10000 and call someone from telecom to help you get it.
This phenomenon of this problem, it may be the normal computer ** to grab bandwidth, his computer software sent to you, ARP attack router, computer system poisoning hair virus attack network blockage, the first thing to see the problem, there is its own set of IP can ping the router. To solve the problem of internal cyber attacks, you can completely solve the immune wall technology, and the immune wall technology deploys the immune network solution. With the immune network solution, your network doesn't need major changes, you can use the immune wall set policy, don't install drivers, get online, install blocking. >>>More
Dear users, hello:
The wireless router is unstable and the possible reasons for the disconnection are as follows: >>>More