Where to find the factory reset value of the Sitong 5530SC printer

Main parameters: Printing method: 24-needle dot matrix percussion type.

Number of stitches 24 (stitches).

Print speed 135 words in seconds.

The printing direction is automatically positioned in both directions and the shortest distance.

Printing width 90 (mm).

Paper types: continuous paper, single sheet, pressure-sensitive paper, card, etc.

Paper thickness. Copying capacity 1+5

The print life is 300 million (times).

Ribbon type: 8mm flushed.

The ribbon life is 4 million characters.

Print font GB18030-2000 (large character set), graphic symbols, half-width ASCII code.

Paper supply method: Flat push friction paper feed, drag paper away, automatic paper loading, automatic paper unwinding, and single-sheet paper feeder are options.

Interface Type: Standard Centronics Parallel Interface.

Operating noise 52 (db).

Resolution 600 (dpi).

Power parameters. Voltage (V) 220V 10% Frequency (Hz) 50-60 Power (W) 320

Environmental parameters: Operating temperature ( ) 5-35 Operating humidity 10-80% Storage temperature ( ) 30-60 Storage humidity 0-85%.

Appearance parameters: length (mm) 465, width (mm) 343, height (mm) 200

Machine weight 12 (kg).

The color of the machine is milky white.

I haven't used this printer for many years, can I find it when I check it online? I'll check it out for you, too.

Shut down first, press the online and cut buttons at the same time to turn on the computer, and restore the factory!

The method of correction is:

1) Press and hold the "Page Change, High-Speed Printing" button to turn on the printer.

2) Load the printer paper, the printer will automatically print "Printer function setting start".”

3) Press the "Wrap Print at Normal Speed" button to print "Horizontal Print Position Adjustment (Normal Speed)" and the calibration line

After the setting is complete, press the "Position Paper Output Direction with Paper" key to save the setting result. If you don't want to save, straight.

Turn off the printer.

Factory reset: Press and hold the 1+6 keys at the same time to power on, and then release it after the print is moved, that is, restore the factory settings.

Wipe the 970 feed sensor to try, if it doesn't work, then follow the steps below to check it1Reinstall the driver. Sometimes a driver error can cause garbled printing.

nbsp;2.Restore the printer settings to factory settings, for details on how to restore them, please refer to the relevant printer manual. Different printers have different methods of recovery.

Dot matrix printers are prone to this kind of situation. Your printer is beautiful and can be reached.

to find out the relevant information. nbsp;3.Go to Printer Properties - Advanced to change the data type of the printout, I have also encountered this kind of problem, and it is easy to use after changing the type.

nbsp;4.The print cable is damaged. In the past, I didn't think that the printing cable was not good, which would cause garbled printing, until there was an EPSON1600K printer on the day before the machine had this problem, and I didn't know that the printing computer would also print garbled after changing the cable.

View the original post

It is recommended that the landlord go to this ** to find a maintenance point that is close to your company, and borrow a manual from them to get a copy of the copy shop. Wu Chisen.

The solution is as follows.

Right-click on My Computer, click [Administration], [Services and Applications], and click [Services].

Find the [Print Spooler] item on the right, right-click and select [Stop].

Win+r to open and run, enter [spool] to confirm. Delete all the files in the [Printers] under [Spool].

Go back to Service and start the Print Spooler.

Finally, disconnect the printer from power for a minute and restart the computer, this step must be done.