Samsung notebook system is keyboard useless

It should be called a notebook keyboard membrane.

The installation method of Samsung notebook keyboard is as follows:

1. Familiar with keys and installation structure keys, mainly keyboard keys, X-structure support frames, elastic rings, bayonets (slots), etc.

2. Put the keyboard buttons that need to be installed back to their original positions, let the X-frame support bounce up, and buckle the thin metal rod position on the buttons.

3. Install an elastic ring at the position of the metal induction piece. The elastic ring is conical, pay attention to the lower bottom (large circle) to the position of the metal induction piece, and the stability is high.

4. Gently close the button downward, so that the bayonet (slot) on the button and the convex position of the X-structure support frame are buckled (card). Be careful not to move the elastic band position.

5. After closing the button, gently move the button up and down, left and right, ensure the position of the button and the X structure support frame and elastic ring, gently press the button, and after hearing the "card wipe" sound, the button is fastened and the installation is completed.

If there is a problem with the product, in order to understand and solve the problem more targeted, it is recommended to send the machine to the nearest Samsung service center for testing, and the service center will determine the specific problem, accessories and other hidden faults according to the test results.

If you know the key structure, you can put it back on. The details are as follows:

First, the structural principle.

The "scissor foot architecture" of the notebook keyboard design is also called the "X architecture", and the schematic diagram is as follows:

The physical picture is shown below

Second, the disassembly method.

Understand the structure of the X architecture buttons,Disassembly is relatively simple,You can use your hand to pick the top of the button,Towards your own direction (some keys are not in the same order,Need to pull horizontally) with a little force,The key can be removed。 In this case, it may be just the keycap or the bracket of the button. As shown in the figure below.

3. Installation. 1.According to the bayonet shape of the bracket, determine the combination relationship of the bracket and install the bracket.

2.Attach the bracket to the keyboard base.

3.Align the keyboard with the middle bracket and press it down a little harder.

According to the title of the subject, Jane Gao Bureau,Do you want to use a USB flash drive to install the system,Using a USB flash drive to install the system is a need to make a USB flash drive as a boot disk,If you just simply put the system ** and decompress it into the USB flash drive, it is useless。 Only the U disk can be used to start the U disk system, here it is recommended that you ** a small white U disk production tool, use the small white U disk system tool to make the U disk as a starting Sliding Disk, and then decompress the system into the U disk. Insert the boot U disk into the computer, and then you can start the computer, when you start the computer, you need to press the startup hotkey on the keyboard to enter the PE interface, the startup hotkey of different computer brands and hardware brands is different, in addition to F2, there are F8, and other different keys.

After entering the small white PE system, you can carry out the system blocking and installation according to the relevant prompts.