ZTE s cat router is how to set up Tengda

If the broadband you are using is available and the password is dialed to access the Internet, the router is set up as follows:

1. Log in to the router management interface - click Advanced Settings - WAN Settings.

2. Select the Internet access method of PPPoE - fill in the broadband and password - OK.

3. Advanced Settings --Mac Clone --Clone Mac--OK.

4. System Tools - Restart the router.

The cat unplugged the cable that used to connect to the computer and did not connect to the computer, but connected to the WAN port of the router.

Then, connect the computer to the LAN port of the router, enter the web address bar on the computer, or enter the default account password, usually admin, admin

Go to the settings according to the prompts to select the type Generally, under ADSL Virtual Dialing (PPPoE), generally fill in the broadband account number and password Save Set up automatic connection Save OK Finish If you connect to other computers, you can connect the computer directly in the remaining 3 LAN ports.

The cat WAN port is connected to the routing WAN port.

Set up the route according to the manual.

The LAN port is connected to the computer, and the routing port can be connected to as many computers as there are.

Here's how to set up your wireless router:

1. The broadband bus (the network cable from the cat) connects to the WAN port of the router.

2. Connect one end of the network cable to any LAN port of the router, and connect the other end to the computer, and start the computer and router equipment;

3. After starting the device, open the browser and enter the router address in the address bar (the reverse side of the router can be viewed) to enter the wireless router settings.

Interface. 4. An account and password for logging in to the router appear in the settings interface, and enter the default account admin

PS: The router and password are generally printed on the back or periphery of the router, some router passwords are created when you first set up, and if you forget, you can reset the router and set the password again. )

5. Set up step by step according to the setup wizard and select the Internet mode, usually ADSL users choose the first PPPoE, if you use other networks.

If you don't know how to choose, you can directly select the first item to automatically select it, which is convenient for novices to operate, and click next after selection;

6. Enter the password applied for from the network service provider, and go directly to the next step after the input is completed;

7. Set the wifi password, try to make the alphanumeric combination more complicated, and it is not easy to be quietly rubbed into the network.

8. After entering the god and correct, it will prompt whether to restart the router, select Yes to confirm the restart of the router, and you can surf the Internet normally after restarting the router.