How to make an electronic mousetrap and how to use a mousetrap

1. Place the mousetrap flat somewhere, remove the bolt on the spring and point outward, and pull the bolt needle backwards.

2. Press the metal strip of the mousetrap with one hand, and turn the bolt needle with the other hand to press the metal strip, being careful not to scratch your hand.

3. Insert the bolt into the hole of the metal sheet on the other side.

4. Change the direction so that the metal piece of the mousetrap is facing up, and the metal strip can be opened to clamp the mouse 5. Put a piece of food in the mouse trap and wait for the mouse to trigger the mechanism to be caught.

Placing rat traps, rat traps and sticky rat boards are the most commonly used and safer methods at present.

The rat trap should be placed on the rat path, the mouth of the rat hole and the place where the rat is often infested.

The rat trap is perpendicular to the wall, and the bait is against the wall at one end, and the clip is 2-3 cm apart from the wall, so that the rats from both sides can be hit.

Rat traps placed in sewers and damp places should be coated with anti-rust oil.

In addition, the release of rodenticide bait is also the most commonly used rodent extermination method, advocating the use of chronic anticoagulant rodenticide bait that is safe for humans and animals, the amount of poison bait should be small, the point is more, and it is placed on the rat path that rats often crawl on, such as kitchens, bathrooms and other places where rats like to hide.

Cangzhou Jinglong's mouse trap.

You open the lid first, and you hang something on that hook, and then you put it in a rat-infested area. Hope it works for you...

Preparation materials: iron wire, insulating screws, iron sheets, AC power supply, wires.

1. Use insulating screws to connect the iron sheets together.

2. According to the actual situation, connect to the appropriate length with absolute screws and iron sheets.

4. Cut the wire after connection, and pay attention to tighten the wire.

6. Clamp the black wire on the iron plate and the red wire on the wire.

7. Finally, turn on the power supply.

Sharing a simple way to make a mousetrap, in order to catch mice, it is really painstaking.

Preparation materials: iron wire, insulating screws, iron sheets, AC power supply, wires.

1. Use insulating screws to connect the iron sheets together.

2. According to the actual situation, connect to the appropriate length with absolute screws and iron sheets.

4. Cut the wire after connection, and pay attention to tighten the wire.

6. Clamp the black wire on the iron plate and the red wire on the wire.

7. Finally, turn on the power supply.

How to do a mousetrap:

Homemade mousetrap one:

Prepare a few pieces of paper, nylon cable ties, tape paper, plastic buckles, and a wrench (which can be replaced with other weights).

Thread the end of the nylon cable tie through the clasp and don't thread it too much, or the rat won't be able to get in. Then tie a string to the other end of the untied rope of the nylon cable tie to the wrench.

Take out a piece of wood, nail the plastic buckle to the side of the board, and attach the nylon cable tie as shown in the picture.

Use paper to make a cover, so that the rats feel that it is safe to eat peanuts and other food, put them on the plastic buckle in front of them, and tighten them with ropes.

The other end of the rope is also tied to the wrench, and a mousetrap is DIY. Place it slightly higher and wait for the rats to come and nibble on the food.

As soon as the food is detached from the noose, the wrench will fall off, and the nylon cable tie will be tightened and the rat will be firmly restrained.

Homemade mousetrap two:

Ingredients: 2 handfuls of rice + 2 tablespoons of cement + 2 tablespoons of sesame oil.

Steps:1Fry the rice in a pan first, fry the rice until golden brown, then pour it into the box, add 2 tablespoons of sesame oil and mix well, then add cement and stir well.

2.Divide it into small portions and place it in a place frequented by rats.

Cement is odorless and rats are not easy to spot. When the rat smells the fragrant fried rice, it comes and eats the food, and when it is done, it is thirsty and finds water to drink. Once there is water, the cement coagulates into a hard lump, clogging the intestines of the mice, causing bloating and death.

If there are rats in the place, hurry up and try it, rats on the street, everyone shouts and fights, as long as the rats dare to eat, let the rats come and go!