The washbasin is blocked by a press valve, what method can be used?

The subject is good, and the maintenance methods of single-hole hot and cold water faucets are as follows: 1Close the water valves of the hot and cold water pipes, loosen the copper nuts on the inlet hose of the hot and cold water faucet, and remove the hot and cold water inlet hoses from the water pipe.

2.Loosen the two nuts holding the hot and cold water faucet in place from under the washbasin so that the tap can be removed from the washbasin. 3.

Use a knife to pick off the plastic plug on the handle, and then use a small flathead screwdriver.

Reach into the small hole in the handle and tighten the set screw.

Release so you can remove the handle. 4.Unscrew the gland by hand, and if it is tight, use needle-nose pliers or rubber pliers, try to be as careful as possible.

The gland is thin and easily damaged. After removing the gland, you can use the large handler to loosen the nut and remove it. 5.

Once the pressure nut is removed, the spool can be removed. Check whether the inlet and outlet holes in the valve core and faucet are blocked. There are usually several situations that can cause blocking:

1. The inlet pipe is twisted or has slag, which can be dredged with blunt iron wire, or it can be tested by water. 2. The valve core is blocked, and the valve core can be disassembled and cleaned. 3. The outlet pipe is blocked, and the outlet nozzle of the hot and cold water faucet can be aimed at the faucet with a large amount of water, and the slag can be discharged from the outlet hole of the hot and cold water faucet (i.e., backfilling).

6.If it is determined that there is a problem with the spool, it is necessary to disassemble the spool. Use a small flathead screwdriver to gently pry the buckle on the valve core to remove the valve core cover.

Hello netizens, you can remove the bolts from under the basin, remove the entire piston for cleaning, if you can't use it, you can replace it as a whole, the cost is about 50 yuan, you don't need to replace the washbasin, just change the button, important reminder: If you buy a brand basin, the merchant has a free maintenance business. Hope it helps, hope.

The washbasin push-type shut-off valve can't be stuck, how to fix it.

Hello, we have collected relevant information for you, please check! Generally, the problem of bouncing and diving is the bouncing problem inside, either the concentricity of the bouncing is not enough and the lid is one-sided, and the thermal expansion and cold contraction of the bouncy are not blind, or the bouncing core is broken, but there are few bouncing cores sold on the market. In the bouncing sewer, the bouncing valve core in the sewer is the most susceptible to break, and every time it is pressed and bounced, there will be a small part of wear, and it will not be pressed when it is ground to a certain degree of emptiness.

If it is said that the base width cannot be bounced up during use, it may be that the buckle is blocked by a foreign object or too long (too long generally does not exist in this case), and there may be a problem with the spring. Maintenance method: This requires the replacement of the spool, in general, it is recommended to replace the drainer, or replace the spool.

Have a great day

Generally, there will be a washbasin installed in our bathroom, but there are many materials for the washbasin, and the installation of different materials will be different, but there are also many brands of washbasins, so we have to have certain purchase skills. So today, I will introduce to you what to do if the washbasin is blocked, as well as the gadgets for dredging the washbasin. If you are interested, please follow the lightning family to take a look.

1. What should I do if the washbasin is blocked?

1.If the washbasin is clogged with hair, we can use a hard wire to enter the drain hole, slowly pull the hair out of the drain, and finally rinse it with water.

2.The wash basin is clogged, soda and white vinegar can be used. We first poured soda water into the drain of the washbasin, then poured in half a cup of white vinegar, and then covered the drain hole with a rag to prevent leakage inside.

The reaction of sparkling water and vinegar can clean pipes well. pieces, and finally pour hot water into the drain. We can also pour some detergent down the drain and then pour hot water into it after a while.

3.Caustic soda can also be used to dredge the sewer, we can put an appropriate amount of caustic soda into the sewer, pour a large amount of boiling water, can dredge the sink sewer.

Second, the small tool for unclogging the washbasin.

1.Pipeline dredging agent.

Plumbing unclogger is a new type of deep cleaning product used in kitchen and bathroom plumbing that is clogged with various substances such as grease and hair in kitchen and toilet plumbing. It also has a deodorizing and sterilizing effect. We can start by pulling the hose out of the sink and then pour 40% of the product into the nozzle and about 500ml of water and press the nozzle.

After a few minutes, it will be cleared.

Pipeline dredger.

The km pipe unclogging device is mainly used in the case of clogged hair in the washbasin drain. The dredger is inserted into the drain and the dredger's hair is hooked by the dredger's bristles. It has a soft texture and is easy to bend.

3.Sewer dredging rods.

The sewer dredging rod is a practical and reasonable gadget with a barb on it and a soft texture. It's easy to get hooked in the sewer.

4.Tube hair decomposer.

Tube hair decomposers are also products for clogged hair. In terms of use, it is safe and does not cause damage to the pipes. The sink is clogged, just pour a pack, clean the drain through the corroded hair, and finally rinse with water.

3. What to pay attention to when buying a washbasin.

1.The pedestal basin consists of a basin and a column. Since the column can play the role of hiding the pipe and supporting the basin, the installation of the base basin is very simple, and the drain pipe can be installed directly without the bracket.

The base basin is compact and easy to clean, but at the same time the disadvantages are obvious. Like the lack of necessary storage space, the bathroom looks a bit messy.

2.Most previous wash basins were round. Wash basins are very personal, they may be square, they may be long, they are hexagonal, fan-shaped, some like bowls, some like hats.

This "personalised" bathroom vanity brings a richer range of colours to the "personal bathroom".

Want to know.

We often use the washbasin in our daily life, but if we don't pay attention to it, it is easy to cause hair cloggingWhat to do if the face pool is blocked?What are the gadgets in daily life that can easily and quickly unclog the washbasin. Next, I will give you a brief introductionWhat to do if the washbasin is blockedand the lack of simple dredging of the washbasin gadgets.

1. What should I do if the washbasin is blocked?

1. If the washbasin is blocked by hair, we can use a stiff wire, reach into the drainage hole, slowly drag the hair out of the sewer, and finally rinse it with water.

2. The washbasin is blocked, so you can use soda and white vinegar. We first pour soda water into the sewer of the washbasin, then pour in half a cup of white vinegar, and then cover the drainage hole with rags to prevent the contents from leaking out, the reaction between the soda and vinegar can clean up the debris in the pipe, and finally pour the hot water into the drain. We can also pour some detergent down the drain and pour hot water back in after a while.

3. Caustic soda can also dredge the sewer, we can put the appropriate amount of caustic soda into the sewer, and pour a large amount of boiling water to dredge the washbasin sewer.

2. Dredging washbasin gadgets.

1. Pipeline dredging agent.

Pipe dredging agent is a new type of deep cleaning product for dredging the sewer blockage caused by grease, hair and other substances in the kitchen and bathroom pipes, and it also has the effect of deodorization and sterilization. We can first remove the hose of the washbasin from the tube, pour 40 cocos of product and about 500 ml of water into the nozzle, and then compact the nozzle. It was unclogged in a few minutes.

2. KM pipeline dredging device.

The km pipe dredge is mainly aimed at the situation of clogged hair in the washbasin sewer, extend the dredge into the drain, and rotate the way to let the bristles of the dredge hook out the hair in the pipe. It has a softer texture and is easy to bend.

4. Sewer dredging rod.

The sewer dredge stick is a practical and affordable gadget with barbs on it and a soft texture that makes it easy to hook hair out of the sewer.

5. Pipeline hair decomposer.

Pipe hair decomposer is also a product for hair clogging, and it is safe to use and will not cause damage to the pipeline. The washbasin is clogged, so you just need to pour a packet down, unclog the drain by corroding the hair, and finally rinse it with water.

I conclude: aboutWhat to do if the washbasin is blocked

In fact, trees need bark, and people need skin. No matter what kind of profession or level of education, people always pay a lot of attention to their appearance. The face is a very important place, people need to take care of their appearance seriously, some people will spray themselves with perfume to paint themselves a light makeup, but most people will make their faces clean.

Cleanliness is a courtesy to others. I usually wash my face at home. However, if the washbasin is blocked, it will be more troublesome.

What should I do if the washbasin is blocked? The repair method that the washbasin is blocked.

What to do if the washbasin is blocked

1. Put the caustic soda into the mouth of the sewer, and then pour a pot of boiling water into it, not a warm pot, but a large pot for water.

2. If you have used the water to pour the child and ask the worker to pass through the iron branch and it is slightly smooth, but then the water is not removed, it is not suitable to use the iron branch again, and the canal that has been prevented from corrosion will be penetrated. You can use thick rattan instead, the rattan head can be nailed ten eight inches long iron nails, one side stretches into one side and turns and stirs, loosen the debris, and then pour it with a concentrated alkali solution, and then push the rattan out and pull it out, if it continues many times, it can be effective. In addition to thick rattan, you can also buy a spring canal device from a hardware store, which has a better effect.

Salt, white vinegar, straws, etc., used by ordinary people, do not work.

3. Waterway dredging agent: it is the best product on the market. This product is especially effective for clogging blockages caused by hair, greasy, paper, etc.

It is widely used in restaurants, hotels, homes, etc. to dredge vegetable sinks, basins, washbasins, floor drains, and toilets. Do not damage sewer pipes (including PVC pipes) and do not damage the plating layer.

How to use: Remove the stagnant water in the sink or sanitary ware, pour 50-100g of this product into the sewer pipe, if there is no water in the sewer, ** into half a cup of water. At this time, the pipe is boiling. Rinse with plenty of water after about 20 minutes.

4. The practice of unclogging the sewer of the washbasin, (mainly due to the blockage caused by the hair left behind in the bath).Because there is a cover at the drain in the washbasin, decoration, can only be dredged from the floor drain, go to a small store to buy a 8 yuan hand spiral wire, (about 6 mm in diameter) from the floor drain while shaking down until the hand shakes a foreign body feeling, and then gently pull out while shaking, the clogged hair and other dirt will be rotated on the spiral wire, the problem is solved. It's very convenient.

If there is no cover at the drain in the washbasin, it is more convenient (do not use hydrochloric acid, firstly, pollute the environment, secondly, it is easy to cause danger to the human body, and thirdly, the pipe is easy to be eroded by hydrochloric acid and perforated for a long time, and the trouble is even greater).

5. Get some baking soda and vinegar, the reaction between vinegar and baking soda will produce gas, which will have a good dredging effect on the debris in the pipeline.

1. If the basin is clogged with hair, we can use a stiffer wire, extend it into the drain hole, slowly pull the hair out of the sewage pipe, and finally rinse it with water.

2. The sink is blocked, soda and white vinegar can be used. We start by pouring soda into the drain of the sewer, pouring in half a cup of white vinegar, and then covering the drain hole with a rag to prevent the contents from leaking. The reaction of soda and vinegar can be cleaned up in the pipes.

miscellaneous stuff and finally pour hot water into the drain. We can also pour some detergent down the drain and it would be nice to pour hot water after a while.

3. Caustic soda can also clean the sewer, we can put an appropriate amount of caustic soda into the sewer, and when a large amount of boiling water is poured, we can clean the washbasin sewer.