If the bathroom of the self built house was not waterproofed when it was built, can the floor tiles

I think totally.

During the construction of the building, the construction party has done waterproofing, that is, there is a waterproof layer when you receive the house, if you do not destroy the waterproof layer during the renovation construction, then it should be no problem. For the sake of insurance, you'd better do a closed water test, that is, use a little cement sand ash at the door to make a 5-minute high water retaining strip, and then block the water, and then the bathroom is full of water, after 24 hours to the downstairs residents to see if there is leakage, if not, you don't have to re-do waterproofing, if there is leakage, then you must re-do waterproofing, then you can only knock open the part of the floor tiles and wall tiles below half a meter, re-do the waterproof layer, and then do the closed water test, confirm that there is no problem and then re-inlay the tiles. This must be done, and it must not be too troublesome, otherwise it will be even more troublesome to find the problem after moving in.

The kitchen can be left untouched.

From the construction point of view, you can remove the floor tiles from the new waterproof, if it is square, as long as a layer of ground is made of cement mortar underneath, there will be no big water leakage problem, depending on their own use of the decision.

It must be waterproof, the bathroom shower area must be waterproof of one meter eight, and the waterproof of other places is thirty, and it must be redone. You didn't do that.

No, self-built houses are all low-rise, if the bathroom is on the 1st floor, and the solar energy is on the 2nd or 3rd floor, why do you have to worry about water seeping into other people's homes? The upstairs and downstairs households bought are all other people's homes, so it is necessary to have the first may affect other people's homes, and the second is inconvenient to repair.

This depends on the situation, and it doesn't necessarily have to be redone first. The water leakage is not very serious, and you can also do it without smashing bricks to do waterproofing, and the effect is also good.

It is also necessary to do this, and even to remove the surface leveling, completely expose the surface of the floor slab, at this time it is best to do waterproofing and turn at least one meter of waterproof on the surrounding walls, and repeat it two to three times.

After the construction is completed, it is necessary to do a water storage experiment to see if there is any leakage, and then there is no problem in doing the protective layer and leveling the floor tiles. But during construction, you must keep an eye on the workers, and don't let the careless destroy the waterproofing, then the previous efforts will be wasted.

Yes, yes. But this is a big project. The cost is relatively high.

The floor can be removed and waterproofed.

Summary. Yes, if you are on the first floor of a bungalow, it will not have a big impact if the ground is not waterproofed. However, after a long time, the walls next to the bathroom will have water seepage.

Hello, happy to answer your questions. The ground of the bathroom on the first floor of the rural self-built building can not be waterproof, but if you have the conditions, it is recommended that you still do it I hope my help to you, thank you

Hello, you can not do waterproof, but if there are conditions, it is recommended that you do waterproof (

If there is a bungalow bathroom with tiles on the floor and walls but not waterproofed, will this affect the future?

Hello, is it the ground floor? If yes, it's okay if the ground isn't waterproofed. However, the wall will seep water after a long time.

Bungalow on the first floor. Yes, if you are on the first floor of a bungalow, it will not have a big impact if the ground is not waterproofed. However, after a long time, the walls next to the bathroom will have water seepage.

Yes! I'm afraid of this.

Is there a good way to deal with that.

Hello, it's better to do the waterproofing of the wall. If you really don't want to knock the tiles off the wall, you can stick a film around the wall (which is very aesthetically detrimental) and minimize water splashing on the wall. Hope mine is helpful to you, thanks

The floor of the bathroom has not been changed in the decoration of the new house, and it is necessary to do waterproofing again, reason: because the new house must be moisture-proof in the case of interior decoration, and it must be moisture-proof twice when doing the moisture-proof bathroom, so as to be able to have a non-seepage situation. If the water leaks very easily, it will cause inconvenience to the next-door neighbor downstairs, and the relationship between neighbors is very important to live with each other.

In the case of decorating a new house, because the engineering building is placed in the process of building the house, there will be the problem of shoddy, resulting in the moisture-proof of the bathroom is not particularly good.

When the new house is decorated in the interior, the first step is that most people think of installing water and electricity, so that the installation of water and electricity can be moisture-proof. Moisture prevention is the most important step, if the moisture prevention is not done well, in the case of tap water in the future, it is easy to cause water seepage from the house to seep into the downstairs home. Although it has no effect on itself, it is an unhappy thing to often have the inconvenience of the next-door neighbor coming to find him.

At the same time, it is necessary to live in a friendly relationship with neighbors, and only by doing a good job of moisture prevention can you reduce such unnecessary inconvenience. In the case of waterproofing, the toilet must be made two moisture-proof, how to have the actual effect of waterproofing, and in the case of waterproofing, it is also necessary to fill the bathroom with water.

Soak the toilet in water for 2 to 3 days, so that you can test how effective it is to prevent moisture. At the same time, in the case of waterproofing, it is also necessary to come down from time to time to see if there is a leak in the downstairs neighbor's house. If the static water does not leak into the neighbor's house, you can renovate the interior again.

In the case of waterproofing, not only the bathroom should be fully considered to be waterproof, but also the restaurant, kitchen and living balcony must be waterproof.

Since the restaurant kitchen also needs to use water when washing dishes every day, to prevent leakage from the restaurant kitchen will seep into the downstairs, and the balcony in the home is moisture-proof, most of them are fully considered to be raining in the living balcony. If the rain is heavy, it will rain, so you don't have to worry about water leaking into your neighbor's house if you use water to prevent moisture from moisture.

You should do it again for safety reasons, because if you leak in the future, you will have no remedy, and you have to dismantle it and redo it, and the loss will be greater. Moreover, the waterproofing of some real estate is not very good, and it has aged for a long time.

If you decorate a new house, especially in the bathroom, you must do it again, because waterproofing is the top priority, and if you leave hidden dangers, it is very troublesome in the process of use.

In the process of new house decoration, the waterproofing of the bathroom is very important, and one more layer of waterproofing must be done when decorating, so that it can be more convenient in the future use.

In order to ensure the quality of the floor and normal life, it is recommended to do waterproofing. Reason: If it is not waterproofed for a long time, it will cause the sewage in the bathroom to drip downstairs, causing inconvenience to the downstairs neighbors, and at the same time reducing the life of the floor.

Before paving the floor tiles, you have to do waterproofing, and you don't do waterproofing, but it's also a good thing to use temporarily, the water will slowly penetrate down, and it won't take long, or you live on the first floor, so it's not too much of a problem if you don't do it, or you build your own house, even if it leaks, it doesn't matter much.

It needs to be done, and the waterproofing needs to be done so that it doesn't cause trouble for yourself and your downstairs neighbors!

<> needed. The waterproof layer of the bathroom, in order to ensure the waterproof effect, if there is a leak, the waterproof layer needs to be redone. First smash the original floor tiles, clean up the waste, lay the required pipes and lines according to the new plan, and then level the waterproof layer to be laid, which can be used in combination with membrane waterproofing and coating film waterproofing to improve work efficiency and waterproof standards.

And the wall will also be damaged in the process of smashing the floor, and the wall tiles need to be smashed down and redone.

As we all know, the waterproofing project of the bathroom is one of the most important links in the decoration process. If the owners are not attentive to this process, it is easy to lead to water leakage and moisture prevention. So, can the bathroom be waterproof without smashing bricks?

What should I pay attention to when doing waterproofing in the bathroom? Let's find out together!

1. Can the bathroom be waterproof without smashing bricks?

Yes, but it is necessary to use a kitchen and bathroom waterproofing agent that does not smash bricks, because it is a material specially designed for waterproofing projects, but only if the pipes cannot be broken. In addition, since waterproofing is generally done from the ground, if the ground in your home is leaking, you must use glass glue to hook off all the brick joints.

2. What should I pay attention to when doing waterproofing in the bathroom?

1. The ground must be cleaned before waterproofing.

In the process of renovation, it is inevitable that all kinds of garbage will be generated. However, because the waterproofing project is very demanding on the construction site, even a small amount of gravel on the ground may affect the progress of the project. Therefore, before doing waterproofing projects, owners must carefully clean up the garbage on the ground, so as to avoid all kinds of troubles in the future.

2. Don't forget to do waterproofing for threshold stones.

Many construction workers will forget to waterproof the threshold stone when doing waterproofing projects, but in this way, the water inside is likely to penetrate to the outside, thus harming the walls and facades. Even if the water doesn't leak downstairs, it will have a certain impact on your life. Therefore, the owners must explain to the construction personnel that the threshold stone should also remember to do waterproofing.

Summary: The above has introduced to you the relevant content of whether the bathroom can be waterproof without smashing bricks and what should be paid attention to when the bathroom is waterproof, hoping to give you some small help. If you need to explore more content related to waterproofing in the bathroom, you can continue to lock our **, and there will be more exciting content in the future!